
This is a safety alert symbol. It alerts
an operator to information concerning
personal safety. Always observe and
heed these instructions, otherwise death or
serious injury can result!
Operator safety is a principle concern in
equipment design and distribution. However,
many accidents occur because a few seconds
of thought, and a more careful approach to
handling, were ignored.
Accidents can be avoided by knowing and
following the precautions cited in this manual.
GENERAL SAFETY
1. Read this manual thoroughly. Make sure
the operator understands it and knows
how to operate this equipment safely.
This equipment can injure an untrained or
careless operator and bystanders. If you
sell this equipment, ensure the new owner
acknowledges receipt of this manual.
2. Make sure all safety guards are securely
mounted in place before operating this
spreader.
3. Do not attempt to handle or service this
equipment, or direct others to do the same,
unless you know how to do it safely and
have the proper tools for the job.
4. Keep hands, feet, hair, and clothing away
from moving/rotating parts. Flying material
can cause bodily injury. Wear eye protection.
5. Do not alter the equipment to the extent of
compromising safety or performance.
6. Material to be spread can be dangerous.
Improper selection, application, use or
handling may be a hazard to persons,
vehicle or other property. Follow instructions
and precautions given by the material
manufacturer.
SAFETY
7. Do not over-load your vehicle beyond
payload limits. If there are any questions,
contact the vehicle manufacturer.
8. Make sure spreader is securely fastened to
vehicle in accordance with this manual.
9. Do not operate a spreader in need of
maintenance or repair.
BEFORE OPERATION
1. Discipline yourself to visually check for
worn, damaged or cracked parts before
starting use. Replace these with genuine
Hiniker parts.
2. Check all controls and operating functions
of machine in a safe area before starting to
work.
3. Do not adjust or clean machine while it
is running. After making adjustments,
check machine thoroughly for loose parts,
hardware and tools.
4. Always disconnect wiring harness before
removing or replacing any electrical
components.
5. Verify hardware attaching safety cable to
cover and hopper is tight.
6. Make sure cover rubber latches are securely
fastened before driving motor vehicle.
Safety 3