BYPASSING ZONES
If you wish to bypass one or more zones, this must be done while the system is in the
disarmed state. The following steps are used for bypassing zones:
Step 1 Press the [BYPASS] key.
Step 2 Enter user code, if required (optional). The bypass light flashes.
Step 3 Enter 1 or 2 digits indicating the zone you wish to bypass,
i.e. press the [1] key for zone 1, press [1]-[2] for zone 12.
Step 4 Press the [BYPASS] key again.
Step 5 The corresponding zone icon will illuminate indicating the zone has been bypassed.
Repeat steps 3 and 4 for any other zone(s) that need to be bypassed.
Step 6 Press the [BYPASS] key again -or- press the [#] key to exit the Bypass Mode.
The bypass light will stop flashing upon exiting the Bypass Mode.
GROUP BYPASS
By pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] key again, all
zones that are designated as group bypass zones will be bypassed. Press the [BYPASS] key
again -or- press the [#] key to exit group bypassing.
UNBYPASSING
To manually unbypass zones, perform the bypassing procedure on a zone that is already
bypassed. The corresponding icon for that zone will go off when unbypassed. NOTE: All
zones will automatically be unbypassed each time the system is disarmed.
ADDING AND CHANGING USER CODES
Your system must be Disarmed to change user codes.
Step 1 Press [r]-[5]
Step 2 The Enter Code icon will display. Enter a [“Master Arm/Disarm” Code].
Note: for partitioned systems, someone changing the code of another person must
have access to all or more partitions than the user being changed.
Step 3 The Ready icon will flash.
Step 4 Enter the 2-digit “user number”.
(Always enter 2 digits such as [0]-[3] for user 3.)
Step 5 The instant icon will flash and zone icons will illuminate specifying the first digit of
the “user code”.
• When all icons are all illuminated = code is blank; when all icons are off = “0”.
• Use the [•] and [–] keys to view the next digit or enter new 4- or 6-digit “user
code”.
• While using the [•] and [–] keys, you can change any digit by entering a new
digit. This will advance you to the next digit.
To delete a user code, enter [r]-[r]-[r]-[r] for a 4-digit code, or [r]-[r]-[r]-[r]-
[r]-[r] for a 6-digit code.
Step 6 The ready icon will flash indicating you are back at Step 2 above.
If the code is rejected, the sounder will beep 3 times.
Step 7 If another “user code” needs to be programmed, return to Step 4.
Step 8 Press the [#] key while the ready icon is flashing to exit the User Code
Programming Mode.
Icon Keypad Page 10
