HID Miniprox Manuel utilisateur

REV DESCRIPTION DATE APPROVED

1 INITIAL RELEASE PER EO #E5365-44

-01 Part: Sheets 1 through 4

-02 Part: Sheets 1 through 5

NOTE: Cover sheet is for Revision Control only, and is not to be sent with document.

REV

SHEET 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 59 50 51

REV

SHEET 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33

REVSTATUS 111111

OFSHEETS 0123456789101112131415

TOLERANCES APPROVALS DATE HID CORPORATION

.XX = +/- .03” DWN Andresky 060500 IRVINE, CALIFORNIA

.XXX = +/- .010” CHK Installation Manual,

ANGLES = +/- 1°APVD Miniprox Reader

MATERIAL N/A APVD

FINISH N/A P/N 5365-910 REV 1

SCALE N/A

THIS DOCUMENT CONTAINS PROPRIETARY

INFORMATION.ITMAYNOTBE DISCLOSED TO

OTHERS OR USED FOR MANUFACTURING

PURPOSES WITHOUTTHE PERMISSIONOF HID

CORPORATION. SIZE A SHEET 0 OF 5

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.hidcorp.com - Miniprox Installation Manual 5365-910 Rev 1

Install Manual – 5365-910 Rev 1

MiniproxTM Installation Manual

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.hidcorp.com - Miniprox Installation Manual 5365-910 Rev 1

PARTS LIST (Included)

Quantity

- MiniproxTM Reader with snap-on cover and 18” cable

(For terminal block versions no cable is supplied)

- #6-32 x 1” self-tapping panhead screw

- Installation manual 1

- Junction box (Hazardous installation version only)

PARTS LIST (Not-Included)

Quantity

- Wire splice 9

- DC Power supply 5.0 VDC or 12 VDC

Mounting Instructions

•Determine an appropriate mounting location. The

reader may be mounted to any surface, including

metal.

•Drill two (2) 3/32-inch (2.5mm) holes approximately

1 inch deep for mounting the reader.

•Drill a 5/8-inch (16mm) hole for the cable.

•Remove the snap-on cover from the reader and

secure the reader to the mounting surface.

•Route the cable from the reader and/or power

supply to the host. A linear type power supply is

recommended. Check all electrical codes for proper

cable installation.

•For best operation, the drain wire should be

disconnected at the power supply end of the cables.

•For the cable connection to the Panel - Use Alpha

#1299C or equivalent.

•Test the operation of the reader. After completion of

the test, replace the snap-on cover.

•See sheet 3 of this manual for the appropriate

dimensioned drawings.

Connecting the Reader to the Host

Connect the reader to the host according to the wiring

table below and the host installation guide.

Wiegand

Clock & Data

Wire Color

Terminal Number

+DC

Red

TB1-1

Ground

Black

TB1-2

Data0

Data

Green

TB1-3

Data1

Clock

White

TB1-4

Shield Ground

Drain

TB1-5

Green LED

Orange

TB1-6

Red LED

Brown

TB1-7

Beeper

Yellow

TB1-8

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.hidcorp.com - Miniprox Installation Manual 5365-910 Rev 1

Hold

Blue

TB1-9

---

Card Present

Violet

TB1-10

Testing and Operation

•When power is applied to the reader the LED will

flash green three (3) times while the beeper beeps

simultaneously. The LED will then turn red. This

indicates that the microcontroller is operating

properly.

•Present an ID card to the reader. The LED will

momentarily turn green while the beeper beeps once,

indicating that the card was read successfully.

Important Product Specifications

Power requirements (linear supply)

Operating Voltage Range 5.0 – 16.0 VDC

Absolute Maximum Voltage 18 VDC

Peak Current 80 Ma

Average Current 5V or 12V 20 Ma

Maximum cable distance 500 ft (153 m)

To host

FCC Compliance Statement: This device complies with

part 15 of the FCC rules. Operation is subject to the

following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept

any interference received, including interference that

may cause undesired operation.

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.hidcorp.com - Miniprox Installation Manual 5365-910 Rev 1

Pigtail Installation

Figure 1

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.hidcorp.com - Miniprox Installation Manual 5365-910 Rev 1

Terminal Block Installation

Figure 2

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page, E-mail - www.hidcorp.com - Miniprox Installation Manual 5365-910 Rev 1

Hazardous Location Installation (Pigtail or Terminal Block)

Figure 3

Table des matières

Autres manuels HID Lecteur de cartes

HID

HID SmartID SK10 Manuel utilisateur

HID

HID OMNIKEY 5121 Manuel utilisateur

HID

HID OMNIKEY eBase 1021 Manuel utilisateur

HID

HID ProxPro II Reader Manuel utilisateur

HID

HID iCLASS R10 Manuel utilisateur

HID

HID pivCLASS R10-H Manuel utilisateur

HID

HID Technology Solutions 1060 Manuel utilisateur

HID

HID MiniProx 5365 Manuel utilisateur

HID

HID iCLASS RK40 Manuel utilisateur

HID

HID iCLASS SE Biometric Reader Manuel utilisateur

HID

HID MaxiProx 5375A Instructions d'utilisation et d'entretien

HID

HID iCLASS SE U90 Series Manuel utilisateur

HID

HID iCLASS R10 Manuel utilisateur

HID

HID EdgeReader Manuel utilisateur

HID

HID ProxPro II 5455 Manuel utilisateur

HID

HID Technology Solutions 1139 Manuel utilisateur

HID

HID iCLASS SE Express R10 Manuel utilisateur

HID

HID iCLASS SE Manuel utilisateur

HID

HID iCLASS SE R10F Manuel utilisateur

HID

HID Signo 20 Manuel utilisateur

HID

HID Signo Series Manuel utilisateur

HID

HID MaxiProx DFM Reader - 5375 Manuel utilisateur

HID

HID iCLASS R10 Manuel utilisateur

HID

HID iCLASS SE U90 Series Manuel utilisateur

Manuels Lecteur de cartes populaires d'autres marques

Lindy

Lindy 43185 Manuel utilisateur

Lindy

Lindy 43185 Manuel utilisateur

ViziT

ViziT RD-4F Manuel utilisateur

Jinmuyu Electronics

Jinmuyu Electronics MR811 Series Manuel utilisateur

AVID ID

AVID ID AVID1043 Manuel utilisateur

Conrad

Conrad PCMCIA Manuel utilisateur

Rosslare

Rosslare DR-6255 Manuel utilisateur

Lindy

Lindy 51541 Manuel utilisateur

Diapro T?bbi Ürünler

Diapro T?bbi Ürünler Across System Manuel utilisateur

Johnson Controls

Johnson Controls Kantech tyco ioSmart Manuel utilisateur

ACS

ACS ACR122L Manuel utilisateur

Secukey

Secukey S2-MF Manuel utilisateur

Elecom

Elecom MR-SMC07 series Manuel utilisateur

Alien

Alien ALR-9800 Manuel utilisateur

ACS

ACS ACR310 Manuel utilisateur

Datamars

Datamars R-IN1300 MID Manuel utilisateur

Alarm Lock

Alarm Lock AL-PRE2 Manuel utilisateur

xpr

xpr B100PROX-AH Guide de l'utilisateur