HHP Adaptus Image Kiosk TT8870 Mode d'emploi

™

Image Kiosk™

TT8870

Programming Guide

Statement of Agency Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

FCC Class A Compliance Statement

This equipment has been tested and found to comply with the limits for a Class

A digital device pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

•Consult the dealer or an experienced radio or television technician for

help.

Caution: Any changes or modifications made to this device that are not

expressly approved by Hand Held Products, Inc. may void the user’s authority to

operate the equipment.

Note: To maintain compliance with FCC Rules and Regulations, cables

connected to this device must be shielded cables, in which the cable shield

wire(s) have been grounded (tied) to the connector shell.

Canadian Notice

This equipment does not exceed the Class A limits for radio noise emissions as

described in the Radio Interference Regulations of the Canadian Department of

Communications.

Le present appareil numerique n’emet pas de bruits radioelectriques depassant

les limites applicables aux appareils numeriques de la classe B prescrites dans

le Reglement sur le brouillage radioelectrique edicte par le ministere des

Communications du Canada.

The CE mark on the product indicates that the system has been

tested to and conforms with the provisions noted within the 89/336/

EEC Electromagnetic Compatibility Directive and the 73/23/EEC

Low Voltage Directive.

Complies with:

EN55022:1998 (for ITE emissions)

EN55024:1998 (for ITE immunity), including CISPR 22B:1997

EN61000-4-2:1995

EN61000-4-3:1995

For further information please contact:

Hand Held Products, Inc.

Nijverheidsweg 9

5627 BT Eindhoven

The Netherlands

HHP shall not be liable for use of our product with equipment (i.e., power

supplies, personal computers, etc.) that is not CE marked and does not comply

with the Low Voltage Directive.

UL and cUL Statement

UL listed UL1950 and CSA 22.2 No.950. cUL listed UL1950 and CSA 22.2 No

950.

LED Safety Statement

This device has been tested in accordance with EN60825-1 LED safety, and has

been certified to be under the limits of a Class 1 LED device.

TÜV Statement

TÜV or GS marked to EN60950 and EN60825-1.

C-Tick Statement

Conforms to AS/NZS 3548. C-Tick number: N10410.

Mexico

Certified

Patents

Please refer to the TT8870 packaging for a list of patents.

Disclaimer

Hand Held Products, Inc., d/b/a HHP (“HHP”) reserves the right to make changes

in specifications and other information contained in this document without prior

notice, and the reader should in all cases consult HHP to determine whether any

such changes have been made. The information in this publication does not

represent a commitment on the part of HHP.

HHP shall not be liable for technical or editorial errors or omissions contained

herein; nor for incidental or consequential damages resulting from the furnishing,

performance, or use of this material.

This document contains proprietary information which is protected by copyright.

All rights are reserved. No part of this document may be photocopied,

reproduced, or translated into another language without the prior written consent

of HHP.

Web Address: www.hhp.com

Microsoft®Windows®is either a registered trademark or trademarks of Microsoft

Corporation in the United States and/or other countries.

Macintosh®is a trademark of Apple Computer, Inc., registered in the U.S. and

other countries.

Other product names mentioned in this document may be trademarks or

registered trademarks of other companies and are the property of their

respective owners.

Chapter 1 - Getting Started

About This Manual ............................................................... 1-1

Chapter 2 - Output

Good Read Indicators ........................................................... 2-1

Beeper – Good Read ...................................................... 2-1

Beeper Volume – Good Read ........................................ 2-1

Beeper Pitch – Good Read ............................................. 2-2

Beeper Duration – Good Read ....................................... 2-2

LED – Good Read.......................................................... 2-2

Number of Beeps – Good Read ..................................... 2-3

Reread Delay ........................................................................ 2-3

User-Specified Reread Delay ............................................... 2-3

Good Read Delay.................................................................. 2-4

User-Specified Good Read Delay......................................... 2-4

Aimer Mode.......................................................................... 2-5

Centering Window................................................................ 2-6

Decode Search Mode............................................................ 2-8

Output Sequence Overview .................................................. 2-9

Output Sequence Editor ............................................... 2-11

Require Output Sequence............................................. 2-11

Multiple Symbols................................................................ 2-12

No Read .............................................................................. 2-12

Print Weight........................................................................ 2-13

Video Reverse..................................................................... 2-13

Working Orientation........................................................... 2-14

Table of Contents

Chapter 3 - Data Editing

Prefix/Suffix Overview ......................................................... 3-1

To Add a Prefix or Suffix:.............................................. 3-2

To Clear One or All Prefixes or Suffixes: ...................... 3-3

To Add a Carriage Return Suffix to all Symbologies .... 3-3

Prefix Selections ............................................................. 3-4

Suffix Selections............................................................. 3-4

Function Code Transmit ................................................. 3-4

Intercharacter, Interfunction, and Intermessage Delays........ 3-5

Intercharacter Delay ....................................................... 3-5

User Specified Intercharacter Delay...............................3-5

Interfunction Delay......................................................... 3-6

Intermessage Delay......................................................... 3-6

Chapter 4 - Data Formatting

Data Format Editor Introduction........................................... 4-1

To Add a Data Format .................................................... 4-1

Other Programming Selections....................................... 4-2

Data Format Editor Commands...................................... 4-2

Data Format Editor ......................................................... 4-5

Data Formatter................................................................ 4-5

Alternate Data Formats................................................... 4-6

Chapter 5 - Symbologies

All Symbologies ................................................................... 5-2

Message Length Description................................................. 5-2

Codabar ................................................................................ 5-3

Codabar Start/Stop Characters.......................................5-3

Codabar Check Character............................................... 5-4

Codabar Concatenation................................................... 5-5

Codabar Message Length ............................................... 5-5

iii

Code 39 .................................................................................5-6

Code 39 Start/Stop Characters .......................................5-6

Code 39 Check Character ...............................................5-7

Code 39 Message Length................................................5-7

Code 39 Append .............................................................5-8

Code 32 Pharmaceutical (PARAF).................................5-8

Full ASCII.......................................................................5-9

Code 39 Code Page.......................................................5-10

Interleaved 2 of 5 ................................................................5-10

Check Digit ...................................................................5-11

Interleaved 2 of 5 Message Length...............................5-11

Code 93 ...............................................................................5-12

Code 93 Message Length..............................................5-12

Code 93 Code Page.......................................................5-13

Code 2 of 5 .........................................................................5-13

Code 2 of 5 Message Length ........................................5-13

IATA Code 2 of 5 ...............................................................5-14

IATA Code 2 of 5 Message Length..............................5-14

Matrix 2 of 5 .......................................................................5-15

Matrix 2 of 5 Message Length......................................5-15

Code 11 ...............................................................................5-16

Check Digits Required..................................................5-16

Code 11 Message Length..............................................5-16

Code 128 .............................................................................5-17

ISBT 128 Concatenation...............................................5-17

Code 128 Message Length............................................5-18

Code 128 Code Page.....................................................5-18

Telepen ...............................................................................5-18

Telepen Output .............................................................5-19

Telepen Message Length ..............................................5-19

UPC-A ................................................................................5-19

UPC-A Check Digit ......................................................5-20

UPC-A Number System................................................5-20

UPC-A Addenda ...........................................................5-20

UPC-A Addenda Required ...........................................5-21

UPC-A Addenda Separator...........................................5-21

UPC-A/EAN-13

with Extended Coupon Code ...........................................5-21

UPC-E0 .............................................................................. 5-22

UPC-E0......................................................................... 5-22

UPC-E0 Expand ........................................................... 5-22

UPC-E0 Addenda Required.......................................... 5-23

UPC-E0 Addenda Separator......................................... 5-23

UPC-E0 Check Digit .................................................... 5-23

UPC-E0 Number System..............................................5-24

UPC-E0 Addenda ......................................................... 5-24

UPC-E1 .............................................................................. 5-24

EAN/JAN-13 ...................................................................... 5-25

EAN/JAN-13 Check Digit............................................ 5-25

EAN/JAN-13 Addenda................................................. 5-26

EAN/JAN-13 Addenda Required ................................. 5-26

EAN/JAN-13 Addenda Separator ................................5-26

ISBN Translate ............................................................. 5-27

EAN/JAN-8 ........................................................................ 5-27

EAN/JAN-8 Check Digit.............................................. 5-27

EAN/JAN-8 Addenda................................................... 5-28

EAN/JAN-8 Addenda Required ................................... 5-28

EAN/JAN-8 Addenda Separator .................................. 5-28

MSI ..................................................................................... 5-29

MSI Check Character ................................................... 5-29

MSI Message Length.................................................... 5-30

Plessey Code ...................................................................... 5-30

Plessey Message Length............................................... 5-30

RSS-14 ............................................................................... 5-31

RSS Limited ....................................................................... 5-31

RSS Expanded .................................................................... 5-32

RSS Expanded Message Length................................... 5-32

PosiCode ............................................................................ 5-33

PosiCode Message Length............................................ 5-33

Trioptic Code ..................................................................... 5-34

Codablock F ....................................................................... 5-34

Codablock F Message Length ...................................... 5-35

Code 16K ........................................................................... 5-35

Code 16K Message Length........................................... 5-35

Code 49 .............................................................................. 5-36

Code 49 Message Length .............................................5-36

Table des matières

Manuels Scanner populaires d'autres marques

Plustek

Plustek Scanner Manuel utilisateur

Z/I Imaging

Z/I Imaging PhotoScan 2001 Manuel utilisateur

Renkforce

Renkforce DS100-5M Manuel utilisateur

Image Access

Image Access WideTEK A2 Manuel utilisateur

Canon

Canon imageFORMULA CR-120N Manuel utilisateur

Fujitsu

Fujitsu FI-4860C2 Manuel utilisateur

GeoSlam

GeoSlam ZEB Horizon Instructions d'installation

Kodak

Kodak i5800 Scanner Manuel utilisateur

Kodak

Kodak i7300 Manuel utilisateur

Revopoint

Revopoint POP Manuel utilisateur

Fujitsu

Fujitsu fi-4860C Manuel utilisateur

Eddyfi Technologies

Eddyfi Technologies Floormap X Manuel utilisateur

Faselase

Faselase F6 Manuel utilisateur

Fujitsu

Fujitsu CardMinder Manuel utilisateur

Uniden

Uniden BC340CRS Manuel utilisateur

Infinite Peripherals

Infinite Peripherals INFINEA TAB M Manuel utilisateur

Mustek

Mustek PageExpress 4800 Pro Manuel utilisateur

Optex

Optex 750830 Manuel utilisateur