1 Introduction
1.4 Equipment care
This section summarizes safety guidelines when installing the LD8 unit.
1.4.1 Unpacking and inspection
Carefully unpack and inspect the unit. If the equipment appears damaged, then return it using the original
packaging. Responsibility for damage will not be accepted if the approved packaging is not used. Ensure
all the major items and the ancillary equipment are supplied. If any items are found to be missing, contact
the system supplier or VERIPOS as soon as possible.
1.4.2 Safety warnings
Always observe the following safety precautions:
lDisconnect electrical power from the DC power supply.
lEnsure adequate air circulation to ventilate the unit, especially to the sides, to avoid heat build-up.
lConnect only to a power supply with a voltage corresponding to that marked on the unit.
lAlways disconnect the LD8 and associated equipment from the power supply when connecting
equipment.
lNever use the equipment in damp or wet conditions.
lAvoid excessive heat, humidity, dust or vibration.
lDo not use the equipment where it may be subjected to dripping or splashing liquids.
lAlways use the power connections supplied with the unit.
lBefore replacing a fuse, disconnect the equipment from the power supply.
1.4.3 Installation
During installation ensure the following:
lDC power supply is disconnected. The power connection is easily accessed on the unit rear.
lThe unit is secured using the holes in the base plate. Position the unit to ensure there is ample
spacing for access to the interface panel and adequate ventilation during normal operation.
lAll cables are routed safely to avoid sharp edges, bends and pinches.
lOnly the cables specified within this manual are used for interconnection of the equipment.
1.4.4 Maintenance
Clean the unit using a clean dry cloth only. Do not wet the unit or allow the penetration of water. Do not
use solvents to clean the unit.
1.4.5 Servicing
This unit contains no user-serviceable parts. Please refer all repairs to a qualified service agent or
VERIPOS.
1.4.6 Fault diagnosis
Follow the guidance in this document to correctly install the LD8. Where the LD8 does not perform as
indicated firstly check all connections before contacting your supplier or VERIPOS for assistance.
6
LD8 Installation Manual
