Clean rinse Filtering Dirty water (optional)
1) Fill an additional bucket (not supplied) with clean water. 1) Remove the cleaning platform from inside of the tank.
2) Insert the clean rinse pick up tube located on the left side 2) Add flocculant (not supplied) to the dirty water.
of the Gun Washer in the bucket. Note: Contact local distributor to purchase flocculant.
3) Set the rinse / agitator switch on the right side of the Gun Amount of flocculant required and time required will vary
Washer to rinse. depending on the brand flocculant being used.
4) Position the spray gun so the clean rinse nozzle is 3) Start the agitator by setting the rinse / agitator switch to
inserted into the paint channel of the spray gun. agitator. Allow the dirty water / flocculant mix to agitate
for 30 to 120 seconds (dependent upon quality of
5) Squeeze the trigger of the spray gun and step on the flocclant). Stir the water for 30 seconds during agitation.
clean rinse foot pedal to send a pressurized flow of Let the water sit for 30 seconds. Return the rinse /
clean water through the paint channel. agitator switch to the neutral position.
6) Return the rinse / agitator switch to the neutral position Note: Repeat process if adequate seperation does not
when finished. occur (dependent upon quality of flocculant).
7) Use the air gun to dry off any wet components. 4) Open the ball valve to allow the dirty water to drain
through the filter bags. The filter bags capture the
Disposal paint debris, and the bucket captures the filtered water
that can be reused for cleaning.
1) Once all the water has been pumped out of the bucket
you have two options. Note: Reuse the water until it becomes tacky to the
touch then dispose of the dirty water according to
a. Remove the filters from the bucket, open the ball local, state and national regulations.
valve to allow the dirty water to return to the
Operation
Page 7 of 12
bucket without filtering. Reuse the water until it 5) Clean the inside of the tub using the cleaning brush.
becomes tacky to the touch then dispose of the Once the tub is clean, use the pressure clean nozzle
dirty water according to local, state and national to clean off the brush.
regulations. 6) Clean the filter bag by removing the paint debris.
b. Filter the water using a flocculant (not supplied)
and the filter bag supplied with the Gun Washer. Note: Allow the flocculated paint to dry before removing
from filter.
7) Dispose of all paint waste according to local, state
and national regulations.
8) Close the ball valve and return the cleaning platform
to the inside of the tub. Replace filter bags (1003348
& 1003351) as needed.
Page 7 of 12
