5 Keypad Options
On rst use of the Access Control Keypad (or after a reset procedure), set the keypad options. Program commands directly into the
keypad. Make continuous entries until complete. If an entry was incorrect, cancel it by pressing the # key, or wait 10 seconds and retry.
5.1 Setting Keypad Functions
Notes
• Some, all, or none of the following procedures may be used when setting keypad functions.
• The keypad can be unlocked by entering the master code.
• The keypad recognizes four digits as one code entry.
Setting Keypad Functions
Step Operation Buttons
1Enter the master code < 4 – 8 digit master code > *
Set Door Lock Release Timer (optional)
2Initiate the door lock release timer programming function 40
3Initial factory setting = 10 seconds
Specify the timer duration, in seconds < 1 – 999 > #
Set the Door Lock Release Sound (optional)
41-second beep occurs with door lock release
Turn the door lock release beep on
812 #
52 short beeps occur with door lock release
Turn the door lock release beep on
811 #
6Turn the door lock release beep o 810 #
Set the Keypad Activity Sound (optional)
7Turn keypad activity sounds on 831 #
8Turn keypad activity sounds o 830 #
Set the Invalid Code Response(s) (optional)
9After 10 consecutive invalid code entries, the keypad locks
for 30 seconds (initial factory setting)
Turn 30-second keypad lockout on 701 #
10 After (5 - 10) consecutive invalid code entries, the keypad
locks for 15 minutes
Turn 15-minute keypad lockout on 70
11 Enter the number of consecutive invalid code entries before the
keypad locks out < 5 – 10 > #
12 Remove all invalid code responses
Initiate the invalid code response removal function 7000 #
Select Fail-Safe or Fail-Secure Lock Operation(optional)
13 Turn Fail-Safe lock operation on 661 #
14 Default after Reset System to Factory Settings
Turn Fail-Secure lock operation on 660 #
Exit Programming Mode
15 Save changes and return to normal operation *
Helmer Scientic Horizon Access Control Keypad User Guide
360392/A 7
