Heitronic 27794 Manuel utilisateur

1 of 3 | Dated 26.02.2016

GB Installation and Operating Instructions

LED panel

Art. No. 27794,27795,27796

These operating instructions refer exclusively to the above products.

They contain important information for the start-up and handling of the light.

Therefore, follow these operating instructions, even if you pass this product onto a third party.

It is important, therefore, that these instructions are archived carefully for referring to information at a

later stage.

1. Introduction

Dear customer, thank you for deciding to purchase our product.

You have acquired a product from Vollmer, which has been built according to the current state of technology.

The light fulfils the requirements of effective European and national guidelines

To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the

instructions of this operation manual!

2. Safety Instructions

The guarantee becomes invalid if damage occurs due to the failure of following these operating

instructions!

We do not accept liability for any consequential damage!

Commissioning is strictly prohibited if there are any damages to the light.

Do not allow children to play unsupervised near the light.

Do not allow the light to come into contact with extreme heat or naked flames.

The product in its entirety must not be altered or modified. Alterations to the light invalidate the

guarantee.

The type plate must not be removed.

3. Proper Use

The light is designed for use in outdoor/indoor areas.

This product is only intended for lighting purposes and may:

only be operated with a voltage of 230V ~50Hz

only be connected according to protection class II (two)

only be operated when mounted to a sturdy, level and non-tilting surface

only be operated on normal or non-flammable surfaces

not be subjected to strong mechanical loads or heavy soiling.

4. Before Installation/Commissioning

The light may only be operated once removed from the packaging.

Remove the light from the packaging carefully.

Make sure that the light has not been damaged during transport before taking it into operation. The light

may not be operated if there are any damages to electrical parts. Repairs may only be carried out by a

qualified electrician.

Keep packaging materials away from children and pets. Asphyxiation hazard!

2 of 3 | 26.02.2016

5. Installation/Commissioning

This product can only be installed by a qualified electrician.

The connection lines in the building must be disconnected before installation and secured against being

switched back on. For this, trip the corresponding fuse switch in the building installation.

Make sure that the surface is suitable for permanently and reliably taking the weight of the light.

Using a saw, cut out the installation dimensions at the desired position. Use the retainer clips to mount

the LED panel. Make sure that no lines are damaged.

Now connect the building installation's connection lines to the screw terminals on the transformer The

brown (or black) cable is generally the phase conductor - connect this to the terminal marked with "L".

The blue conductor must be connected to the terminal marked with "N".

Do not bend the cables; make sure that the cables are not subject to tension or torsional forces. Protect

all cables and insulation against possible damages.

Check proper connection once again.

Switch the building installation's fuse switch back on.

6. Faulty Function

Light does not switch on

Light switched on at the wall switch?

Transformer mounted and connected properly?

Check the connected lines

7. Technical Data

Article Connection Installation

dimensions LED panel

Protec-

tion

Type

Protec-

tion

Class

27794

AC 230V ,

DC max. , 24-38V,max

40V, 350mA

180 x 180mm 14W, 730lm, 3000-6000K,

dimmable IP20 II

27795

AC 230V ,

DC max. , 24-38V,max

40V, 350mA

Ø187mm 14W, 900lm, 3000-6000K,

dimmable IP20 II

27796

AC 230V ,

DC max. , 24-40V,

max.45V, 450mA

273 x 273mm 17W, 1400lm, 3000-6000K,

dimmable IP20 II

8. Setting the light

You can set 3 different lighting situations (warm white, cold white and daylight white) by switching your

light switch on and off (the light must remain switched off for at least two seconds).

The lamp has a memory function so that the lighting situation that you last set will automatically occur

when you next activate the lamp. (However, the light must remain switched off for at least 10 seconds)

9. Care

Disconnect the entire product from the mains first before cleaning or maintaining the product.

3 of 3 | 26.02.2016

10. Waste Disposal

Old electronic devices must be taken to public waste disposal sites and must not be put into general

household waste.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Heitronic Équipement d'éclairage

Heitronic

Heitronic 30390 Manuel utilisateur

Heitronic

Heitronic 38037 Manuel utilisateur

Heitronic

Heitronic 35378 Manuel utilisateur

Heitronic

Heitronic 38205 Manuel utilisateur

Heitronic

Heitronic Enterprise 501233 Manuel utilisateur

Heitronic

Heitronic Wheel Manuel utilisateur

Heitronic

Heitronic 38277 Manuel utilisateur

Heitronic

Heitronic FLAVIO 28278 Manuel utilisateur

Heitronic

Heitronic 30317 Manuel utilisateur

Heitronic

Heitronic 39689 Manuel utilisateur

Heitronic

Heitronic Disqa 501227 Manuel utilisateur

Heitronic

Heitronic 27542 Manuel utilisateur

Heitronic

Heitronic 35866 Manuel utilisateur

Heitronic

Heitronic 37234 Manuel utilisateur

Heitronic

Heitronic 27004 Manuel utilisateur

Heitronic

Heitronic 28162 Manuel utilisateur

Heitronic

Heitronic 39888 Manuel utilisateur

Heitronic

Heitronic 38179 Manuel utilisateur

Heitronic

Heitronic 28589 Manuel utilisateur

Heitronic

Heitronic 38185 Manuel utilisateur

Heitronic

Heitronic 501193 Manuel utilisateur

Heitronic

Heitronic 500708 Manuel utilisateur

Heitronic

Heitronic 37072 Manuel utilisateur

Heitronic

Heitronic Bedlight Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur