6
Figure 5
4. Using both hands, one on the tractor the other on the paper, slide
tractor right or left so that the tractor pins line up with the holes in check
carrier strips.
a. Align top of check form with top of tractor - insert left check carrier strip
into feeder pins and close tractor cover. (See Figure 7).
b. GENTLY pull tractor to the left to eliminate any sagging of the forms - -
- forms must be taut between the tractors. Lock the left tractor in place
by pushing down on the locking lever. (See Figure 8).
NOTE:
Continuous forms of some manufacturers may vary in width from
box to box or even within the same box. Whenever loading continuous
forms, always check to make sure that the feeder strips line up with the
tractor pins AND that the paper is taut between the tractors.
E. Close cover on machine. LOCK and REMOVE key.
F. Reset Run Meter by pressing in firmly on CENTER of RESET bar. Make
sure all zeros (00000) appear and line up across the face of the meter.
G. Press START button. Allow approximately 12 checks to run through the
machine. Press STOP button. Model EDP1000 checks will run until they are
all signed - there is no STOP button. The Model EDP1000 can be stopped
for stacking by the power switch.
1. Make sure that the checks are stacking properly at the rear of the
machine. The first check should be pointing toward the rear of the
machine. If not, manually refold the checks along the natural fold lines.
Place the stack of refolded checks about 6" from the rear of the
machine.
