HC-ANA devices installation manual
4. DEVICE OPTIONS
4.1 Antenna
Devices can be delivered with a fixed external antenna
in the box, or with a flat antenna with a cable as long
as needed. In cases where it is necessary that the
equipment does not have any antenna outside the
box, do not hesitate to ask, since we can also send the
equipment with an internal antenna.
The flat antennas are special to install the devices
inside a metal box in which there is no coverage of the
technology of the equipment and you want to install
the antenna outside the box for example, or for
similar cases. We can also deliver the devices with
larger cables, special antennas etc. for use in places
without coverage, etc.
4.2 Power
HC-ANA devices have two different feeding systems.
Those references with -B refer to devices powered by
batteries. The standard batteries we use are AA
batteries, however, the device has been designed in
such a way that larger batteries can be used for
special cases in which greater power capacity is
required.
The -TR references refers to devices with an internal
AC / DC transformer. So that the devices can be
powered with 110 / 230V AC. Specially designed for
applications with close power (high power consumer
sensors, etc.).
The internal AC power system has been designed so
that you can not have contact with the AC signals at
any time. In addition, a 5x20 mm 240V 100mA fuse
protected by a plastic cover is used. In the event of a
short circuit or any other problem, to replace the fuse,
remove the plastic cover, insert the new fuse in the
cover and reconnect the plastic cover to the fuse
holder.
5. SENSOR INSTALLATION IN HC-ANA BOX
HC Technologies can install the sensors into the HC-
ANA box if needed. We can install the sensors in
different places and also change the antenna installing
mode, etc. Following, two different installation are
shown, one with three different sensors
(temperature, moisture and light sensors), and the
