2
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Router/Access Point Information
The HLWLAN cannot be configured without the following information. Before going any further with
the installation, fill in the information below.
Router or Access Point’s SSID (wireless network name - case sensitive)____________________
To find the SSID:
1) Ask the homeowner. Each wireless router or access point has a default SSID which may be in
use, or has been changed by the network administrator (homeowner).
2) If the homeowner doesn’t know, have them login to the router/access point and read the
information from the device. The SSID should be shown along with other router settings. The
router’s documentation or manual should show how to access administrative settings and find
the SSID.
3) If a wireless device is already connected to the home network (phone, tablet, laptop, etc.), the
device’s connection properties may show the SSID.
Router or Access Point’s Security Type_______________________________
To find the Security Type:
1) Ask the homeowner. The network administrator (homeowner) would have set up the security
type based on the desired security level and the type of devices that will be connecting to the
wireless network.
2) If the homeowner doesn’t know, have them login to the router/access point and read the se-
curity type from the device. This information should be shown along with other router settings.
The router’s documentation or manual will show how to access administrative settings and find
the security type.
3) If a wireless device is already connected to the home network (phone, tablet, laptop, etc.), the
device’s connection properties may show the security type that is in use.
Wireless Network Password (case sensitive) _______________________________
The wireless network password is not broadcast or typically saved in the router/access point’s
administrative settings. The network administrator (homeowner) would have set up a password
when initially setting up the wireless security type. If no security was selected, the network is Open
and there is no password.
Installation
DANGER of Death, Injury or Property Damage if procedure not followed. This accessory
connects to the OmniLogic beneath the dead front panel. Dead front removal is required for this
installation. Power to the OmniLogic panel MUST be shut off before the dead front is removed. This
means a complete shutdown of power to the entire OmniLogic unit.
