D-G 16 S2 - 18.04.13 / Vers.: 1
1
Dear customer,
Thank you for the confidence you have placed in us by purchasing this
automatic blast-
ing unit
.
Please take time to read these operating instructions carefully, especially before using
the unit for the first time, as this will ensure that the unit will give you good service for
many years to come.
Contents
1
Safety..................................................................................................................... 2
1.1
Correct use ..................................................................................................... 2
1.2
Possible dangers ............................................................................................ 2
1.3
Approved operators ........................................................................................ 2
1.4
Safety measures at site of operation.............................................................. 2
1.5
Marking of safety references contained in these instructions ........................ 3
2
Starting up ............................................................................................................ 3
2.1
Technical data ................................................................................................ 3
2.2
Unpacking the automatic blasting unit............................................................ 3
2.3
Short description of unit and identification of components............................. 4
2.4
Process for putting into operation................................................................... 7
3
Operation .............................................................................................................. 7
3.1
Connect sandblasting device to the compressed air supply .......................... 7
3.2
Filling with blasting agent ............................................................................... 7
3.3
Fill abrasives................................................................................................... 8
3.4
Automatic operational mode........................................................................... 8
3.5
Description of how to set and save the blasting time ..................................... 9
3.6
Manual blasting .............................................................................................. 9
3.7
Automatic cut-out and filter change warning light......................................... 10
4
Cleaning/maintenance ....................................................................................... 10
4.1
Replacing the filter bag................................................................................. 10
4.2
Cleaning (replacing) the super-fine filter ...................................................... 10
4.3
Cleaning the shove-in sieve (embedded material residue) .......................... 11
4.4
Draining of the abrasive............................................................................... 11
4.5
Checking of the injector if blasting performance is reduced......................... 12
4.6
Checking of other components..................................................................... 14
5
Sandblasting area illumination ......................................................................... 14
6
Electrical fuse protection .................................................................................. 14
7
Access to electrical/pneumatic control system.............................................. 14
8
Warranty conditions........................................................................................... 15
9
EC declaration of conformity ............................................................................ 16
