Harman Kardon ONYX Manuel utilisateur

Onyx Studio

Wireless Speaker System with Rechargeable Battery

Owner’s Manual

Table of Contents

Onyx Studio

INTRODUCTION 3

DESCRIPTION AND FEATURES 3

DESIGN AND PERFORMANCE 3

WIRELESS CONNECTION 3

INCLUDED ITEMS 3

CONTROLS AND CONNECTIONS 3

TOP PANEL CONTROLS 3

REAR PANEL CONNECTIONS AND CONTROLS 4

LED INDICATIONS 4

OPERATION 4

SWITCHING ON AND OFF 4

ADJUSTING VOLUME 4

PLAYING MUSIC THROUGH BLUETOOTH 4

TROUBLESHOOTING 5

SPECIFICATIONS 5

Onyx Studio

Introduction

Thank you for purchasing the Harman Kardon Onyx Studio. HK Onyx Studio is a premium

wireless speaker with an iconic design and comes with a rechargeable built-in battery

that allows you to stream music from any smart phone, tablet or other wireless devices

through Bluetooth®.

HK Onyx Studio is a 4-speaker, advanced acoustic platform and its dual passive radiators

deliver a truly fantastic sound experience with a balanced soundstage and powerful

bass response.

Description and Features

Design and Performance

• Dual passive radiators provide deep bass.

• The built-in rechargeable battery offers up to 5 continuous hours of

playtime.

Wireless Connection

Wireless connectivity allows you to place the speaker in any part of the room without

having to worry over friends and family tripping over cables. The HK Onyx Studio

supports almost every popular wireless device via Bluetooth .

Included Items

HK Onyx Studio speaker system complete accessories consist of:

• HK Onyx Studio speaker

• One AC power adaptor

• Regional power cable

• Quick Start Guide

• Safety sheet

• Warranty Card (for some specific countries)

IMPORTANT: If any included accessory is missing, or if any part of your

HK Onyx studio system fails to operate properly, contact your dealer

immediately.

Controls and Connections

This section will help you identify the controls that are provided on the Onyx Studio top

and rear panels.

Top Panel Controls

The following control buttons are available on the top panel:

• Power button

• Volume Controls

• Bluetooth

Power Button

This button when pressed turns the HK Onyx Studio ON or OFF and has an LED to indicate

the power mode. The two power modes are:

• Operational mode

• OFF mode

When the system is in OFF mode (Power LED is not lit), press the power button for more

than 3 seconds to switch on the system. The power LED turns white when the system

is turned on.

To turn the speaker off, press the Power button for more than 3 seconds.

When powered by the battery, the speaker will go into off mode automatically after 30

minutes if no music stream is detected. The power LED will be turned off. To turn the

speaker on, press the power button for more than 3 seconds.

NOTE: When the system gets into Operational mode from the OFF mode, the

last used volume setting will be restored.

Volume Controls

• Press the (-) button to decrease the volume

• Press the (+) button to increase the volume

Bluetooth

This button helps you pair your system with other devices. The system enters into

Bluetooth pairing mode automatically when it is turned on.

NOTE: The speaker’s Bluetooth device name is HK Onyx Studio and password

is 0000.

Introduction

Onyx Studio

Rear Panel Connections

The connections on the rear panel are:

1. USB Port (For service use)

2. Power DC input

USB Port

The USB port is used to upgrade software as service purpose.

Power DC Input

Connect the AC power adapter to this port to charge the built-in battery.

LED Indications

The LEDs present on the top panel indicates the status of the speaker unit.

Refer to the table below to get a fair idea on the speaker LED indications.

Operation

Switching ON and OFF

The power button on the top panel of the speaker allows you to set your speaker to any

of the following power modes:

• Operational mode – White constant LED illumination

• Off mode – No illumination

To change the power mode:

• Long press: Off mode – to enter operational mode

• Long press: Operational mode – to enter off mode

Adjusting Volume

The volume buttons on the top panel allow you to increase or decrease volume. Adjust

volume using the Volume Up (“+”) and Volume Down (“–”) buttons located on top of

the unit.

• Short press - Increase/decrease volume by 1 step

• Press and hold - Increase/ decrease volume continuously (1 step per 0.2

second)

Connecting Bluetooth & Playing Music through Bluetooth

1. Press the Power button. The LED will illuminate white.

The speaker enters pairing mode when it is switched on.

2. If the speaker has been paired with any source before, press

and hold the Bluetooth button for at least 2.5 seconds.

3. Perform a new device search on your Bluetooth-capable device.

4. Select HK Onyx Studio on the device’s pair-

ing list and enter pasword as 0000.

The device will be paired to HK Onyx Studio automatically. If pairing is

successful, the Bluetooth LED will change to white.

5. Control playback from your Bluetooth-capable device.

LED State Indication

Power LED White, Constant Operational mode

White, Slow Flash Battery Charging

White, Quick Flash Low battery

White, Flash Twice Factory settings restored

OFF OFF mode

Bluetooth LED White, Constant Bluetooth connected

White, Slow Flash No Bluetooth device connected

Operation

110/220 volt power source

Onyx Studio Troubleshooting

Troubleshooting

If your Harman Kardon Onyx Studio is not performing the way you think it should, check if the problem is covered in this section before calling your dealer or contacting a Harman

Kardon representative.

Problems Solutions

There is no sound coming from the speaker • No power to unit. Make sure that the wall outlet or

power strip has power.

• Make sure that all switches for outlet/power strip are

ON and that all switches for the unit are ON.

• If you have not plugged it to the AC source, make sure

that the battery is charged.

Distortion (static, crackling or hissing sounds) • Audio source or source material may be the problem.

Test the HK Onyx Studio with another source.

Loud hum or buzzing noise • It might happen due to ground loop (an unsuitable

connection). Turn the HK Onyx Studio OFF and connect

it to another wall outlet.

Battery not charging • No power to unit. Make sure that your wall outlet or

power strip has power.

• Make sure that all switches for outlet/power strip are

ON and that all switches for the unit are ON.

Specifications

No of channels 4

Transducers 2 X 3" woofers, 2 X ¾" tweeters, 2 x passive radiators

Bi-amplification 4 X 15W

Maximum SPL 95dB @ 1m

Power requirement 100 – 240 V AC, 50/60 Hz

Power adaptor 19V, 2.0A

Built-in battery 3.7V, 2600mAh, Cylindrical Lithium Ion Rechargeable Battery

Power consumption 38W Maximum <1W stand by

Speaker impedance 4 ohm per speaker

Frequency Response 60Hz – 20kHz

Frequency range 2402MHz ~ 2480MHz

Transmitter power <4dBm

Modulation GFSK/ /4-DQPSK/8-DPSK

Wireless Bluetooth 3.0 A2DP v1.3 AVRCP v1.5

Dimensions (Dia x W x H) 280mm X 161mm X 260mm

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries,

Incorporated is under license. Other trademarks and trade names are those of their respective owners.

Harman Kardon is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. The“beautiful/sound”

logo is a trademark of HARMAN International Industries, Incorporated.

Autres manuels pour ONYX

Table des matières

Autres manuels Harman Kardon Intervenants

Harman Kardon

Harman Kardon ONYX Manuel utilisateur

Harman Kardon

Harman Kardon Allure Manuel utilisateur

Harman Kardon

Harman Kardon SB 30 Manuel utilisateur

Harman Kardon

Harman Kardon Aura Studio 3 Manuel utilisateur

Harman Kardon

Harman Kardon CITATION BAR Manuel utilisateur

Harman Kardon

Harman Kardon SB20 Manuel utilisateur

Harman Kardon

Harman Kardon AVR 7500 Manuel utilisateur

Harman Kardon

Harman Kardon CITATION 300 Manuel utilisateur

Harman Kardon

Harman Kardon CITATION 500 Manuel utilisateur

Harman Kardon

Harman Kardon NEO Manuel utilisateur

Harman Kardon

Harman Kardon ESQUIRE Manuel d'installation et d'exploitation

Harman Kardon

Harman Kardon HKS 4 Manuel utilisateur

Harman Kardon

Harman Kardon ONYX STUDIO 6 Manuel utilisateur

Harman Kardon

Harman Kardon CITATION RECEIVER Manuel utilisateur

Harman Kardon

Harman Kardon Aura Manuel d'installation et d'exploitation

Harman Kardon

Harman Kardon ONYX Manuel utilisateur

Harman Kardon

Harman Kardon CITATION TOWER Manuel utilisateur

Harman Kardon

Harman Kardon Nova Manuel utilisateur

Harman Kardon

Harman Kardon Go Plus Play Mini Manuel utilisateur

Harman Kardon

Harman Kardon Sabre SB35 Manuel utilisateur

Harman Kardon

Harman Kardon SB26 soundbar Manuel utilisateur

Harman Kardon

Harman Kardon HKB 4 Manuel utilisateur

Harman Kardon

Harman Kardon ONYX STUDIO 4 Manuel utilisateur

Harman Kardon

Harman Kardon Aura Manuel utilisateur

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur