Harbor Freight Tools 90034 Guide de référence rapide

ASSEMBLY & OPERATING INSTRUCTIONS

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web Site at www.harborfreight.com

90034

30” HARLEY (RED)

TOY ROCKER

THANKYOU for choosing a HARBOR FREIGHTTOOLS product. For future reference, please complete the

owner’s record below:

Model______________ Serial No._____________ Purchase Date_______________

SAVE THE RECEIPT, WARRANTY ANDTHESE INSTRUCTIONS. It is important that you read the entire

manual to become familiar with the unit BEFORE you begin assembly.

Technical Specifications

Construction: Pine Wood

For ages: 3-8

Maximum Weight: 100 LBS.

Overall Dimensions: 35-1/5” L x 11”W x 20-1/2” H

Safety Warnings and Precautions

WARNING:When using product, basic safety precautions should always be followed to

reduce the risk of personal injury and damage to equipment.

Read all instructions before using this product!

1. Keep work area clean. Cluttered areas invite injuries.

2. Observe work area conditions. Do not use this product in damp or wet locations. Don’t

expose to rain. Keep work area well lighted.

3. Store idle equipment. When not in use, products must be stored in a dry location to inhibit

rust.

4. Check for damaged parts. Before using any product, any part that appears damaged should

be carefully checked to determine that it will operate properly and perform its intended function.

Check for any broken or damaged parts and any other conditions that may affect its operation.

Replace or repair damaged or worn parts immediately.

5. Replacement parts and accessories. When servicing, use only identical replacement parts.

Use of any other parts will void the warranty.

6. Use eye protection. Always wear ANSI approved impact safety goggles when assembling this

product.

7.Always check hardware and assembled parts after assembling. Use in an area that is

flat and level. All connections should be tight and hardware tightened.

8. All assembly should be done by an adult.

9. TheToy Rocker should be played with in the presence of an adult. The Toy Rocker is for

indoor use. Use on a padded surface, like a carpet.

10.This product contains small parts and therefore represents a choking hazard.

Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot

cover all possible conditions and situations that may occur. It must be understood by

the operator that common sense and caution are factors which cannot be built into

this product, but must be supplied by the operator.

#90034 Page 2

Assembly

Your Toy Rocker will require complete assembly prior to use. It is important that you read the entire

manual to become familiar with the product BEFORE you use the Toy Rocker. Before assembling

the Toy Rocker be sure that you have all parts described in the Parts List and Assemby Diagram

located on the last page of this manual.

Step 1) Attach the two (2) Rocker Slats (#1) together with Cross Piece (#2). Place Rocker

Slats (#1) parallel to each other and set Cross Pieces (#2) down in-between them at

each end. Insert 2 Hex Bolts (A) into the holes at each end of the Rocker Slats and

into holes in Cross Piece (#2). Insert Nut (B) down into Cross Piece (#2). Turn the

Nut (B) clockwise which will pull in Hex Bolt (A) and tighten the Rockers Slats (#1) to

the Cross Pieces (#2)-refer to Figure 1.

#90034 Page 3

Step 2) Next, attach the Rocker Slats (#1) and Cross Pieces (#2) to the Body (#4). Insert the

Connecting Plate (#3) so that the dowel on the Connecting Plate (#3) goes into the

middle hole on the Cross Piece and up into the Body (#4)-see Figure 2.

Rocker Slat (#1) Cross Piece (#2)

Two Hex Bolts (A)

Nut (B)

Figure 1-Rocker Slats with Cross Pieces

Connecting Plate (#3)

Rocker Slat (#1)

Cross Piece (#2)

Figure 2-Attaching Connecting Plate to Body

Step 3) Secure the Connecting Plate (#3) to the assembly by inserting the two-sided Bolt (E)

through Body (#4), Connecting Plate (#3) and out other side of Body (#4). On each

end of Two-Sided Bolt (E), slide on Big Washer (J), Spring Washer (K) and tighten on

Nut (I).

Step 4) Fully secure the Connecting Plate (#3) to each Cross Piece (#2) by inserting the

two (2) Hex Bolts (D) down into the Cross Piece. Slide on Medium Spring

Washer (L), Washer (G) and tighten on Nylon Nut (H).

Step 5) Insert two (2) Hex Bolts (C) down through the Seat Bottom (#5).

Step 6) Insert the Handlebar (#6) through the top holes in the forks. Slide one Washer (M)

onto each Screw (F) and thread into the hole in front of fork and into the Handlebar

(#6) to secure in place-see Figure 3.

Handlebar (#6)

Screws (F) with

Washers (M)

Figure 3-Handlebar to Body

#90034 Page 4

Step 6) If decals are not attached, apply decals as shown on manual cover. Peel off decal

from paper and attach to Toy Rocker.

Unpacking

UNPACK AND CHECK CONTENTS

When unpacking your Harley 30”Toy Rocker, check to make sure the following parts are included. If any parts

are missing or broken, please call HARBOR FREIGHTTOOLS at 1-800-444-3353.

Part # Description Quantity

1 Rocker Slats 2

2 Cross Piece 2

3 Connecting Plate 2

4 Body 1

5 Seat Bottom 1

6 Handlebar 1

Part # Description Quantity Part # Description Quantity

A Hex Bolt 2 H Nylon Nut 4

B Nut 8 I Nut 4

C Hex Bolt 2 J Big Washer 4

D Hex Bolt 4 K Spring Washer 4

E Bolt 2 L Medium Spring Washer 4

Hardware

F Screw 2 M Washer 2

G Washer 4 N Wrench 2

#90034 Page 5

Note: Some parts are listed and shown for illustration purposes only and are not available

individually as replacement parts.

PLEASE READTHE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDEDTHE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE

TOOL ONLY. NEITHERTHE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY

KINDTO THE BUYERTHAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRSTOTHE PRODUCT ORTHAT HE OR SHE IS

QUALIFIEDTO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY

STATESTHAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED

TECHNICIANS AND NOT BY THE BUYER.THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER

REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTSTHERETO, OR ARISING OUT OF HIS OR HER

INSTALLATION OF REPLACEMENT PARTSTHERETO.

O Allen Wrench 1

Table des matières

Autres manuels Harbor Freight Tools Jouet

Harbor Freight Tools

Harbor Freight Tools 3514 Manuel utilisateur

Harbor Freight Tools

Harbor Freight Tools 94840 Manuel d'installation

Harbor Freight Tools

Harbor Freight Tools 94737 Manuel utilisateur

Harbor Freight Tools

Harbor Freight Tools River Boat Manuel utilisateur

Harbor Freight Tools

Harbor Freight Tools Lightning Airplane with Charger 42619 Manuel d'installation

Harbor Freight Tools

Harbor Freight Tools 68752 Manuel utilisateur

Harbor Freight Tools

Harbor Freight Tools 95125 Manuel de la liste des pièces

Harbor Freight Tools

Harbor Freight Tools 90033 Guide de référence rapide

Harbor Freight Tools

Harbor Freight Tools 57990 Instructions de montage

Harbor Freight Tools

Harbor Freight Tools 92304 Guide de référence rapide

Harbor Freight Tools

Harbor Freight Tools 95149 Manuel utilisateur

Harbor Freight Tools

Harbor Freight Tools 91192 Manuel utilisateur

Harbor Freight Tools

Harbor Freight Tools 56513 Instructions de montage

Harbor Freight Tools

Harbor Freight Tools U.S. GENERAL Junior 56515 Instructions de montage

Harbor Freight Tools

Harbor Freight Tools 91311 Guide de référence rapide

Harbor Freight Tools

Harbor Freight Tools AIR PIXIE HELICOPTER Manuel d'installation

Harbor Freight Tools

Harbor Freight Tools 57293 Instructions de montage

Harbor Freight Tools

Harbor Freight Tools 95641 Manuel de la liste des pièces

Harbor Freight Tools

Harbor Freight Tools 95641 Manuel de la liste des pièces

Harbor Freight Tools

Harbor Freight Tools 62578 Instructions de montage

Harbor Freight Tools

Harbor Freight Tools 94774 Manuel d'installation

Harbor Freight Tools

Harbor Freight Tools 94840 Guide de référence rapide

Harbor Freight Tools

Harbor Freight Tools BUCK HORN WAGON WOODEN MODEL 9141 Manuel utilisateur

Harbor Freight Tools

Harbor Freight Tools 91131 Manuel utilisateur

Manuels Jouet populaires d'autres marques

marklin

marklin 37321 Manuel utilisateur

Canon

Canon PAPER CRAFT Manuel utilisateur

GREAT PLANES

GREAT PLANES Pitts M-12S Manuel utilisateur

NOCH

NOCH 14261 Manuel utilisateur

Hausler

Hausler 450 SE V2 Manuel utilisateur

Dynaflite

Dynaflite Daydream Manuel utilisateur

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manuel

Kenner

Kenner Batman 63651 Manuel utilisateur

LEGO

LEGO 8527 Manuel utilisateur

iKarus

iKarus ECO 8 Manuel utilisateur

Multiplex

Multiplex EasyStar II Mode d’emploi

Walkera

Walkera 38 Mode d’emploi

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manuel utilisateur

MD MXION SWD Manuel utilisateur

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manuel utilisateur

marklin

marklin 39671 Manuel utilisateur

Meccano

Meccano 15103 Manuel utilisateur

LEGO

LEGO TECHNIC 8735 Manuel utilisateur