Harbor Freight Tools 56814 Instructions de montage
Visit our website at: http://www.harborfreight.com
Email our technical support at: [email protected]
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the
back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference. 20a
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
Copyright© 2019 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein.
To ol s r eq ui r ed f o r as s em bl y a nd se rvice m ay not be in cluded.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Page 2 For technical questions, please call 1-888-866-5797. Item 56814
Important Safety Information
1. Do not allow children younger
than age 14 to use this Drone.
Children should not operate
without adult supervision.
2. Only fly outdoors during daylight
hours in an area with no
obstructions, power lines, vehicles,
animals or people nearby.
3. Do not fly in wet or windy conditions.
4. Keep spectators and pets away.
Spectators should only watch
from a safe distance.
5. Position remote control batteries in
proper polarity. Do not mix old and
new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries. Position
batteries in proper polarity. Do not
use swollen or leaking batteries.
6. Do not open the Drone’s housing or
modify its design. Doing so may cause
damage and/or make it dangerous.
7. Do not use if parts are loose or
damaged. If the toy has been
damaged, immediately stop using it.
8. Contains Lithium-Polymer battery.
Battery must be recycled or disposed
of properly. Do not open, crush,
heat above 140° F or incinerate.
9. Check federal, state and local
surveillance laws before using
the camera on this product.
10. Operating a drone that has a dangerous
weapon attached to it is a violation of
Federal law. The term “Dangerous
Weapon” is defined as any item that
is used for, or is readily capable of,
causing death or serious bodily injury.
11. People with pacemakers should
consult their physician(s) before
use. Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference
or pacemaker failure.
12. The warnings, precautions, and
instructions discussed in this instruction
manual cannot cover all possible
conditions and situations that may
occur. It must be understood by the
operator that common sense and
caution are factors which cannot
be built into this product, but must
be supplied by the operator.
13. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Page 3For technical questions, please call 1-888-866-5797.Item 56814
Lithium Battery Charging Safety
1. Do not leave Drone unattended
while charging.
2. Battery charging should be
done by adults only.
3. Use the supplied USB
charging cable only.
4. Charge on non-flammable surface and
keep away from flammable items.
5. If battery-powered device has been
damaged, immediately stop use,
unplug, and safely move away
from flammable materials.
6. Follow instructions for charging
battery. DO NOT charge
longer than recommended.
7. Allow a clearance of at least 4" on
all sides during charging.
Personal Safety
1. Operator and spectators must
wear ANSI-approved safety
goggles during use.
2. Do not wear loose clothing or
jewelry. Keep hair and clothing
away from moving parts. Loose
clothes, jewelry, or long hair can
be caught in moving parts.
3. Do not use the Drone while tired or
under the influence of drugs, alcohol, or
medications. A moment of interruption
can result in serious personal injury.
Page 4 For technical questions, please call 1-888-866-5797. Item 56814
Specifications
Remote Control Battery Type 4-AAA (sold separately)
Drone Battery Type 3.7 V / 520 mAh rechargeable Lithium-Polymer
Battery Charging Time 1.5 hours max
Flying Time Approximately 7.5 minutes
Range Up to 160 feet
Operating Frequency 2.4 GHz
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Warning! Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult Customer Service or an experienced radio/TV technician for help.
Drone FCC ID: 2AKPPHELICUTE
Remote Control FCC ID: 2AKPPHLTH816
The responsible party in the United States for compliance of the equipment is:
Harbor Freight Tools, 26541 Agoura Road, Calabasas, CA 91302
1-888-866-5797 • http://www.harborfreight.com
Page 5For technical questions, please call 1-888-866-5797.Item 56814
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Switch the Drone and Remote Control OFF before
performing any procedure in this section.
Charging Battery
CAUTION! Do not leave Drone
unattended while charging. Battery
charging should be done by adults only.
1. Make sure Drone and Remote
Control are turned OFF.
2. Plug the USB plug on the Charging
Cable into the USB port of a computer
or any other USB power source.
3. Insert Charge Plug on the Charging
Cable into the Charging Port on the
Drone.
4. While Battery is charging, LED
light on Battery is on. When fully
charged, LED light goes off. Charging
takes approximately 90 minutes.
5. When charging is complete,
disconnect Charging Cable from
Drone and power source.
USB
Charging
Cable
Charge
Charge
Plug
Plug
USB
Plug
Page 6 For technical questions, please call 1-888-866-5797. Item 56814
Remote Control
1. Remove the screw securing
the Battery Cover on the back
of the Remote Control.
2. Remove the Battery Cover and insert
four AAA batteries (sold separately)
in the indicated polarity.
3. Replace Battery Cover and
tighten screw securely.
CAUTION! Do not install old and
new batteries together. Do not install
alkaline, carbon-zinc or rechargeable
batteries together. Position batteries
in proper polarity. Do not use
swollen or leaking batteries.
Battery
Cover
Battery
Compartment
Page 7For technical questions, please call 1-888-866-5797.Item 56814
Controls
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use.
Power
Switch
Power Indicator
Light
Throttle
Joystick
Directional
Joystick
Forward / Backward
Trim Button
Headless
Mode Button
One Key
Return Button
Left / Right
Trim Button
Left or Right Right
Turn Trim ButtonButton
Camera
Light
Start / Stop
Button
Picture / Video
Button
BASIC FUNCTIONS
UP Throttle Joystick Up MOVE LEFT Directional Joystick Left
DOWN Throttle Joystick Down MOVE RIGHT Directional Joystick Right
FORWARD Directional Joystick Up START DRONE Start / Stop Button
BACKWARD Directional Joystick Down HEADLESS MODE Headless Mode Button
TURN LEFT Throttle Joystick Left ONE KEY RETURN One Key Return Button
TURN RIGHT Throttle Joystick Right TRIM ADJUSTMENT Refer to page 10
Page 8 For technical questions, please call 1-888-866-5797. Item 56814
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY: Operator and spectators must wear ANSI-approved
safety goggles during use. Keep Drone within 160 feet of Remote Control. If Drone
goes out of range, it will stop working and fall.
WARNING! To prevent serious
injury, avoid sudden movements
of controls while flying.
CAUTION! Only fly outdoors during
daylight hours in an area with no
obstructions, power lines, vehicles,
animals or people nearby.
Pairing
1. Turn the Drone ON – the red and
green LED lights will flash. Place
the Drone on a flat surface.
2. Turn Remote Control ON. Unit
will beep once, the blue Power
Indicator Light will come on, and
the red Camera Light will flash.
3. Push Throttle all the way up, the unit
will beep once. Then push Throttle all
the way down until unit beeps again.
4. The red Camera Light on the Remote
will go out and the blue Power Indicator
Light will stay on, indicating the
Drone and Remote are connected.
Auto Trim Function
1. When pairing is complete, place
Drone on a flat surface.
Simultaneously pull the Throttle
stick and the Directional stick
down at a 45 degree angle as
shown until the Drone’s LED
lights flash.
2. Release the Throttle and
Directional sticks. The LED
lights stop flashing and remain
on when auto trim is complete.
Speed Control
Drone speed is set to slow by default. To change to medium speed, press the Throttle
Joystick down once — the Remote will beep twice indicating speed is set. For high speed
press the Throttle Joystick down again — the Remote will beep three times indicating speed
is set. To return to slow speed press the Throttle Joystick once — the Remote will beep once
indicating speed is reset to slow.
Page 9For technical questions, please call 1-888-866-5797.Item 56814
Basic Operation
1. Place Drone on a flat, level
surface. Connect Drone and
Remote Control as described
in Pairing on page 8. Press
Start / Stop button to start
operation; press again to stop.
2. To maneuver the Drone up or
down, move the Throttle
Joystick up or down.
3. To move the Drone forward
or backward, push the
Directional Joystick up to go
forward or pull it down to go
back.
4. To turn the Drone left or right,
move the Throttle Joystick to
the left or right.
5. To move the Drone left or
right from side to side, push
the Directional Joystick to
the left or right.
Up
Down
Backward
Forward
Turn Right
Turn Left
Left Side Right Side
Start/Stop
Button
Directional
Joystick
Throttle
Joystick
Page 10 For technical questions, please call 1-888-866-5797. Item 56814
Checking / Fine Tuning Trim
Using a light touch, slowly push Throttle up until Drone is barely hovering. Drone should
stay in one place without excessive forward, backward, or side to side movement or
rotation. If any of these conditions occur make adjustments using the following procedures.
BACKWARD
TRIM
RIGHT
TURN TRIM
FORWARD
TRIM
LEFT SIDE
TRIM
RIGHT SIDE
TRIM
LEFT TURN
TRIM
Forward
Forward
Trim
Backward
Backward
Trim
Left
Side Trim
Right
Side Trim
Left
Turn Trim
Right
Turn Trim
Table des matières
Autres manuels Harbor Freight Tools Drone
