Hamwells Loopz Manuel utilisateur

v1.0

Quick Start Guide

Enjoy your Loopz!

* UV-C LED is only included with the Loopz Plus

Please read the quickstart guide before using the Loopz. We would

like to point out the safety instructions which are included in the

box. Allmanuals are available at www.hamwells.com.

Save water, have a better shower

How to start?

1. POSITION THE MODULE

Position the Loopz in such a way that there is a slope

towards the drain to allow the water to ow towards it.

2. THE CONTROL UNIT

Place the control unit and guide the power

supply cable out the module through its cable

duct.

3. PLACE THE FILTER

Please note, the raised edge of the lter should point

upwards and make contact with the front end (the side

with the drain) of the module.

1 °

5. PLACE THE DECK

Make sure the deck falls into the recess. Please note,

theLoopz’s maximum load is 100 kg / 220 lbs.

6. CONNECT THE ADAPTER

Connect the Loopz’s 12V power supply cable to the

power adapter cable. Connect the power adapter to a

power source. Please note, the power adapter should

be placed in a dry environment.

4. CONNECT THE SHOWER HEAD

Screw the hose coupler onto the thread on to the

control panel.

LED signal

The LED on the control panel has three distinct patterns

giving feedback on the usage of the Loopz. These are: blinking,

continuously on and fading in and out.

7. PLACE THE PLUG

Place the plug in the reservoir.

Remove theplug after use to drain

the reservoir.

8. CHECK THE WATER LEVEL

Fill the reservoir at least to the indicated level. Please

check the LED on the control panel, it should be

continuously on.

ready for use in useﬁll the reservoir

Filling the reservoir

Please note, do not leave

harmful substances in the

environment.

Hamwells Nederland B.V.

Pelgrimsstraat 3, 3029 BH Rotterdam,

The Netherlands

hamwells.com/loopz

Questions? Mail us at loopz@hamwells.com

9. USING THE LOOPZ

Once the LED is continuously on, the Loopz is

ready for use.

Press the push button to start the shower,

push it again to stop.

10. MAINTENANCE

Please note to rinse the microlter after each shower using an external

water source.

We advise to frequently clean the shower by adding a mild detergent to

the water reservoir. Let the shower run for a few minutes and empty the

reservoir afterwards. Furthermore, remove the lid of the shower head once

in a while to get rid of any obstructions in the nozzles.

Please note, the recycled water is not

drinking water.

Please, limit the amount of soap used.

Showering

Table des matières

Autres manuels Hamwells Appareil de salle de bains

Hamwells

Hamwells e-Shower HOMESPA Manuel utilisateur

Hamwells

Hamwells e-Shower Manuel utilisateur