Greenheck SBCE Manuel utilisateur

Concrete Block Fan 1

Document 462051

Model CBF-205

Concrete Block Fan

Installation, Operation and Maintenance Manual

Please read and save these instructions for future reference. Read carefully before attempting to assemble, install,

operate or maintain the product described. Protect yourself and others by observing all safety information. Failure

to comply with these instructions will result in voiding of the product warranty and may result in personal injury

and/or property damage.

WARNING

Parts List

1. Grille (1)

2. Grille Screw (2)

3. Block Fan Housing (1)

4. Blower Panel (1)

5. Blowers (2)

6. Blower Panel Screw (4)

7. Receptacle Plug, 115 volt only (1)

8. Blower Screw (4)

9. Junction Box (1)

10. Electrical Cord (not shown)

Tools Required

• Phillips Head Screwdriver

• Hex Head Sockets and Wrench

To reduce the risk of fire, electric shock, or injury to

persons observe the following:

• Use this unit only in the manner intended by the

manufacturer. If you have any questions, contact

the manufacturer.

• For General Ventilation use only. Do not use to

exhaust hazardous or explosive materials and

vapors.

• Before servicing or cleaning unit, switch power off

at service panel and lock service panel to prevent

power from being switched on accidentally. When

the service disconnecting means cannot be locked,

securely fasten a prominent warning device, such

as a tag, to the service panel.

• Installation work and electrical wiring must be

done by qualified person(s) in accordance with

all applicable codes and standards, including

fire‑rated construction.

• The combustion airflow needed for safe operation

of fuel‑burning equipment may be affected by this

unit’s operation. Follow the heating equipment

manufacturer’s guideline and safety standards

such as those published by the National Fire

Protection Association (NFPA), and the American

Society for Heating, Refrigeration and Air

Conditioning Engineers (ASHRAE), and the local

code authorities.

As a result of our commitment to continuous improvement, Greenheck reserves the right to change speciﬁcations

without notice.

Speciﬁc Greenheck product warranties are located on greenheck.com within the product area tabs and in the

Library under Warranties.

Greenheck’s Transfer Fan catalog provides additional

information describing the equipment, fan performance,

available accessories, and speciﬁcation data.

Phone: 715.359.6171 • Fax: 715.355.2399 • Parts: 800.355.5354 • E-mail: [email protected] • Website: www.greenheck.com

Our Commitment

AMCA Publication 410-96, Safety Practices for Users and

Installers of Industrial and Commercial Fans, provides

additional safety information. This publication can be obtained

from AMCA International, Inc. at www.amca.org.

Blower Panel

Screws (4)

Service and Maintenance:

1. Turn off all power to Concrete Block Fan.

2. Remove (2) grille screws with Phillips head

screwdriver. Figure 1.

3. Unfasten (4) blower panel screws from support

angles. Figure 2.

4. Pull blower assembly out approximately 12 inches.

5. Reach inside housing and unplug receptacle from

junction box.

6. Brush off any accumulated dust or dirt from the fan

motor and wheel(s).

Figure 1

Figure 2

NOTE

For General Ventilation use only. Do not use to

exhaust hazardous or explosive materials and vapors.

General Maintenance Suggestions

The Concrete Block Exhaust Fan requires very little

maintenance. However, since small problems left

unchecked over time could lead to loss of performance

or early motor failure, we do recommend that the unit be

inspected periodically (once or twice a year).

The fan motor and wheel(s) should be checked for dust

and dirt accumulations. Dirt buildup can lead to loss of

performance and motor overheating. Cleaning can be

accomplished by brushing off any dust or dirt that may

have accumulated.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Greenheck Ventilateur

Greenheck

Greenheck 100 Series Manuel utilisateur

Greenheck

Greenheck G Series Manuel utilisateur

Greenheck

Greenheck RV-35 Manuel utilisateur

Greenheck

Greenheck LFC Manuel utilisateur

Greenheck

Greenheck MSCF-FC Manuel utilisateur

Greenheck

Greenheck SP110 Instructions générales

Greenheck

Greenheck 473642 Manuel utilisateur

Greenheck

Greenheck SP-AP0511WL Manuel utilisateur

Greenheck

Greenheck RSF Series Guide d'installation

Greenheck

Greenheck DFD-M150 Manuel utilisateur

Greenheck

Greenheck BIDW Manuel utilisateur

Greenheck

Greenheck MiniCore Series Manuel utilisateur

Greenheck

Greenheck SQ-M 70 Manuel utilisateur

Greenheck

Greenheck ERV Series Manuel utilisateur

Greenheck

Greenheck SQ Series Manuel utilisateur

Greenheck

Greenheck SQ Manuel utilisateur

Greenheck

Greenheck GreenJet GJI Manuel utilisateur

Greenheck

Greenheck SP-A Manuel utilisateur

Greenheck

Greenheck AE Guide d'installation

Greenheck

Greenheck XG-5700 Manuel utilisateur

Greenheck

Greenheck SDPHE Manuel utilisateur

Greenheck

Greenheck MiniVent Series Manuel utilisateur

Greenheck

Greenheck 474051 Manuel utilisateur

Greenheck

Greenheck FDR-510 Manuel utilisateur

Manuels Ventilateur populaires d'autres marques

ELTA FANS

ELTA FANS H03VV-F Manuel utilisateur

Hunter

Hunter 20714 Manuel d'instructions

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manuel utilisateur

Hunter

Hunter Caraway Manuel d'instructions

Panasonic

Panasonic FV-15NLFS1 Manuel utilisateur

Kompernass

Kompernass KH 1150 Manuel utilisateur

VES

VES FALA100/12V/TR Manuel utilisateur

Vertiv

Vertiv Liebert DCD Manuel utilisateur

Westinghouse

Westinghouse GFP Series Manuel utilisateur

Venmar

Venmar KUBIX HRV PLUS Series Manuel utilisateur

Maico

Maico ECR 31 Manuel utilisateur

Sonnenkonig

Sonnenkonig Dinky Manuel utilisateur

S&P

S&P ECOWATT HXBR Manuel utilisateur

Wider

Wider IMP03369BH Manuel utilisateur

Panasonic

Panasonic F-60DHN Manuel utilisateur

Hinkley

Hinkley HIGHLAND Manuel utilisateur

Broan

Broan 766BN Manuel utilisateur

Premium

Premium PFS16022 Instructions de montage