7
4.1. Tara
Place the load to be weighed on the scale platform, when the stability indicator lights up,
press the key to tare. The display shows zero and the net weight indicator light
illuminates. Remove the load and press the key again to cancel the tare, the net
weight indicator light will go out.
4.2. Zero
Zeroing of the scale. The stability indicator must be lit. While the scale is zeroed, the
zero indicator lights up. In addition to the zeroing button the scale shall perform an
automatic zeroing each time it is switched on. The automatic zeroing device at start-up
operates in a range of +-10% of the maximum capacity.
4.3. Weighing function of animals
In the parameterisation, set the value In the parameterisation, set the value [P 9][P 9] to to [2][2] to start the animal weighing function. to start the animal weighing function.
Set the value Set the value [P 9][P 9] to to [1][1] to deactivate the animal weighing function. to deactivate the animal weighing function.
4.4. Function of accumulation
In weighing mode, press the indicator will accumulate all the current weight, and at
the same time the ACCUM indicatorwill light up.press the key again, it will go to
normal weighing mode and the ACCUM light will turn off; press the key with the
counter at zero, to display the current accumulated value; under the accumulation status,
press to reset to zero, press can return to normal weighing mode and at the
same time the ACCUM lights will turn off.
Note: the balance must be zeroed before the next accumulation operation. otherwise,
you will not be able to perform the accumulation operation a second time.
4.5. Piece-counting function Piece-counting function
In weighing mode press and hold In weighing mode press and hold to enter the count function. The count light will to enter the count function. The count light will
come on and display come on and display [Count][Count]. When stable, press the . When stable, press the key to enter the sample key to enter the sample
number setting and number setting and [C00000][C00000] will be displayed. After placing a few samples, press the will be displayed. After placing a few samples, press the
key to change. Press the key to change. Press the key to set the value of sample numbers. After setting key to set the value of sample numbers. After setting
the value of the current sample number, press the value of the current sample number, press to sample and to sample and [------][------] will be will be
displayed. When number appears you can start counting. This sampling date will be displayed. When number appears you can start counting. This sampling date will be
saved. Press the key saved. Press the key to exit the counting mode. to exit the counting mode.
Note: If the sample weight is less than the minimum sampling weight, the sampling willNote: If the sample weight is less than the minimum sampling weight, the sampling will
fail and the data from the previous sampling will be taken. If the weight of the samplingfail and the data from the previous sampling will be taken. If the weight of the sampling
unit is less than the minimum weight of the sampling unit, the sampling will also failunit is less than the minimum weight of the sampling unit, the sampling will also fail
and the data from the previous sampling will be taken.and the data from the previous sampling will be taken.
4. Instructions for use and description
