Graco 240054 Manuel d'utilisation

308830E

First choice when

quality counts.t

INSTRUCTIONS-PARTS LIST

Important Safety Instructions

DRead all warnings and instructions in this

manual. Save these instructions.

Frame, Roller

5000 psi (345 bar, 34.5 MPa) Maximum Working Pressure

Model 240054, Series A

3 in. (7.6 cm) length

Model 240055, Series A

12 in. (30.5 cm) length

Model 240005, Series A

9 in. (22.9 cm) length

Pressure Relief Procedure

WARNING

IN INJECTION HAZARD

The system pressure must be manually

relieved to prevent the system from

starting or spraying accidentally. Fluid

under high pressure can be injected through the

skin and cause serious injury. To reduce the risk of

an injury from injection, splashing fluid, or moving

parts, follow the Pressure Relief Procedure

whenever you:

Dareinstructedtorelievethepressure,

Dstop spraying,

Dcheck or service any of the system equipment,

Dinstall or clean the frame.

1. Lock the gun safety latch.

2. Shut off the power supply to the pump and open

any air bleed valves in the system.

3. Unlock the gun safety latch.

4. Hold a metal part of the gun firmly to the side of a

grounded metal waste container, and trigger the

gun to relieve pressure.

5. Lock the gun safety latch.

6. Open the pump drain valve to help relieve fluid

pressure in the pump, hose and gun. Triggering

the gun to relieve pressure may not be sufficient.

Have a container ready to catch the drainage.

7. Leave the drain valve open until you are ready to

spray again.

If you suspect that the frame or hose is completely

clogged or that pressure has not been fully relieved

after following the steps above, VERY SLOWLY

loosen the tip retaining nut or hose end coupling and

relieve pressure gradually, then loosen completely.

Now clear the frame or hose obstruction.

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440--1441

http://www.graco.com

Graco Inc. is registered to I.S. EN ISO 9001

7927A

2 308830

Installation

WARNING

Refer to your sprayer and spray gun manuals for

appropriate warnings and instructions for safe op-

eration of this roller frame.

Gasket (7) must be in place before installing frame

(1). If gasket is not in place there is a potential in-

jection hazard which could result in serious injury.

1. Follow Pressure Relief Procedure on page 1.

2. Prime pump.

3. Install roller frame.

Parts

Ref

No. Part No. Description Qty

1 FRAME, roller

220235 Model 240054, 3 in. (7.6 cm) 1

218582 Model 240005, 9 in. (22.9 cm) 1

224378 Model 240055, 12 in. (30.5 cm) 1

2 183420 NUT, retainer, diffuser 1

3 108808 PACKING, u-cup 1

4 DIFFUSER, roller

220233 Model 240054, 3 in. (7.6 cm) 1

218934 Model 240005, 9 in. (22.9 cm) 1

224377 Model 240055, 12 in. (30.5 cm) 1

5 101983 SCREW, set 1

6 192638 FITTING, swivel 1

7 15H622 GASKET, non-metallic 1

9 192637 NUT, retaining, 7/8--14 (f) 1

Wetted Parts: fluoroelastomer, nylon, plated........

steel polyethylene, acetal

Lips of u-cup face

roller diffuser (4)

7926b

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

This manual contains English. MM 308830

Graco Headquarters: Minneapolis

International Offices: Belgium, Korea, China, Japan

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440--1441

http://www.graco.com

12/97, Revised 08/2009

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Graco Pistolet à peinture

Graco

Graco MONARK 222-617 Manuel d'utilisation

Graco

Graco 313483A Manuel d'utilisation et d'entretien

Graco

Graco Optimiser 2K Manuel d'utilisation

Graco

Graco ProMix 2KE Mode d’emploi

Graco

Graco 231-351 Manuel d'utilisation

Graco

Graco T-Max Applicator 256383 Manuel d'utilisation et d'entretien

Graco

Graco Magnum X5 Manuel utilisateur

Graco

Graco FinishPro 290 Manuel utilisateur

Graco

Graco Dura-Flo 600 Manuel utilisateur

Graco

Graco 288359 Manuel utilisateur

Graco

Graco 190ES 261825 Mode d'emploi

Graco

Graco Ultra MAX II 490 PC Pro Mode d’emploi

Graco

Graco Magnum X5 Manuel d'utilisation et d'entretien

Graco

Graco ULTRA 500 Manuel d'utilisation

Graco

Graco IronMan 256790 Mode d’emploi

Graco

Graco STX 17Y910 Mode d’emploi

Graco

Graco Ultimate MX II FT500 Manuel utilisateur

Graco

Graco 311001G Fiche technique

Graco

Graco 223–390 Manuel d'utilisation

Graco

Graco Magnum Pro Plus Series Mode d’emploi

Graco

Graco Reactor A-25 Mode d’emploi

Graco

Graco 232630 Mode d'emploi

Graco

Graco ULTRA MAX II 1095 Manuel utilisateur

Graco

Graco ST Max 395 Hopper Manuel

Manuels Pistolet à peinture populaires d'autres marques

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Manuel utilisateur

Binks

Binks SV100 Manuel utilisateur

Fimco

Fimco LG-4-3-1 Manuel utilisateur

AG SPRAY

AG SPRAY FS-ATV-25BL Manuel utilisateur

Nordson

Nordson MicroMax 2 Manuel utilisateur

Bonide

Bonide 051 Manuel d'utilisation

zogics

zogics Z-DAS Manuel utilisateur

KISANKRAFT

KISANKRAFT KK-KBS-165 Manuel utilisateur

Matrix

Matrix SG 650 Manuel utilisateur

Anest Iwata

Anest Iwata SGA-3 Guide de démarrage rapide

paasche

paasche VV Fiche technique

Carlisle

Carlisle DeVilbiss JGA-510 Manuel utilisateur

Gardena

Gardena 11120 Manuel utilisateur

Conrad

Conrad Hobby Airbrush K3 Manuel utilisateur

wiwa

wiwa 14025 R/F Manuel utilisateur

DeVilbiss

DeVilbiss LUNA2i Manuel utilisateur

WAGNER

WAGNER W 125 Manuel utilisateur

My Clean Buddy

My Clean Buddy PW018 Manuel utilisateur