Goodman OTDFPKG-01 Manuel utilisateur

Part Descripton Qty.

Webbed Grommet 1

Cutting Screws 2

Housing Assembly (contains parts below) 1

Door 1

Box 1

Top 1

Bottom Screen 1

Thermostat 1

ThermostatHarness 1

Screws 6

IO-771A Installation Instructions 1

Kit Components

Table 1

2. Remove the blower door in order to access the thermostat

plug on the inside of the unit. The harness is labeled “OUT-

DOORTHERMOSTAT”.

3. Remove the knockout from the duct panel located next to the

blower door (see Figure 1).

MOUNTING

DIMPLES

REMOVE KNOCKOUT

AND CUT “X” IN

INSULATION

AS SHOWN

Figure 1

ATTENTION INSTALLING PERSONNEL

As a professional installer, you have an obligation to know the

product better than the customer. This includes all safety precau-

tions and related items.

Prior to actual installation, thoroughly familiarize yourself with this

Instruction Manual. Pay special attention to all safety warnings.

Often during installation or repair, it is possible to place yourself in

a position which is more hazardous than when the unit is in op-

eration.

Remember, it is your responsibility to install the product safely

and to know it well enough to be able to instruct a customer in its

safe use.

Safety is a matter of common sense...a matter of thinking before

acting. Most dealers have a list of specific good safety

practices...follow them.

The precautions listed in this Installation Manual are intended as

supplemental to existing practices. However, if there is a direct

conflict between existing practices and the content of this manual,

the precautions listed here take precedence.

WARNING

HIGH VOLTAGE!

DISCONNECT ALL POWER BEFORE SERVICING OR INSTALLING

THIS UNIT. MULTIPLE POWER SOURCES MAY BE PRESENT. FAILURE

TO DO SO MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR

DEATH.

CAUTION

TO AVOID POSSIBLE PERSONAL INJURY, USE EXTREME CAUTION IF USING

POWER TOOLS TO REMOVE THE SMALL BREAKER MOUNTING BRACKETS. THE

BRACKETS MAY QUICKLY ROTATE AND CAUSE INJURY.

INSTRUCTIONS

1. Remove all parts from the OTDFPKG-01 kit. Compare parts

to Table 1 to insure all needed parts are present before pro-

ceeding.

OTDFPKG-01 OUTDOOR THERMOSTAT

FOR DUAL FUEL PACKAGE

INSTALLATION INSTRUCTIONS

IO-771A

9/2013

4. There will be insulation behind the knockout on the inside of

the unit. Cut an “X” into the insulation as shown in Figure 1.

5. Snap in the webbed grommet into the resulting hole in the duct

panel.

6. Remove the door from the housing assembly. Place the plug

of the thermostat through the grommet and through the hole

cut into the insulation into the inside of the unit.

7. With the cutting screws shipped with the kit, mount the hous-

ing to the duct panel using the locating dimples on the panels.

When mounted, the large hole in the top right hand corner of

the housing should surround the webbed grommet and the

housing should be flush against the duct panel.

8. Locate the outdoor thermostat harness inside the blower com-

partment. Remove the jumper plug and connect the plug from

the thermostat to the plug inside the blower compartment.

Place the jumper plug with the literature of the unit and keep in

case servicing is needed later.

9. Set the outdoor thermostat to the desired level using a flat

head screw driver (see Figure 2). The setting will determine

the temperature at which the unit will switch from mechanical

heat with the heat pump to gas heat using the gas furnace. In

most cases, it is recommended that the setting be in the range

of 35°F – 40°F depending on the cost of local utilities.

Set the thermostat

by lining the small tick mark

on the dial with the desired temperature.

Figure 2

IMPORTANT NOTE: If the housing is in a location where it will be in

direct sunlight, the temperature inside the housing could be 5°F -

10°F higher than the ambient outside of the box. Take this into

consideration when setting the thermostat in these applications.

10. Once the thermostat is set, replace the door to the housing

and to the blower compartment.

NOTE: SPECIFICATIONS AND PERFORMANCE DATALISTED HEREIN ARE SUBJECT TO CHANGE WITHOUT NOTICE

Quality Makes the Difference!

All of our systems are designed and manufactured with the same high quality standards regardless of size or efficiency. We have designed

these units to significantly reduce the most frequent causes of product failure. They are simple to service and forgiving to operate. We use

quality materials and components. Finally, every unit is run tested before it leaves the factory. That’s why we know. . .There’s No Better

Quality.

Visit our website at www.daikincomfort.com, www.goodmanmfg.com or www.amana-hac.com for information on:

• Products

• Warranties • Customer Services

• Parts • Contractor Program and Training

• Financing Options

Autres manuels Goodman Thermostat

Goodman

Goodman G4273 Manuel utilisateur

Goodman

Goodman TSTATG2100-2 Manuel utilisateur

Goodman

Goodman TSTATG2152-2 Manuel utilisateur

Goodman

Goodman GT4272 Guide de dépannage

Goodman

Goodman TSTATG2111 Manuel utilisateur

Goodman

Goodman TSTATG4272GT Mode d'emploi

Goodman

Goodman TSTAT G2200C Manuel utilisateur

Goodman

Goodman GT4273 Manuel utilisateur

Goodman

Goodman TSTATG4272 Manuel utilisateur

Goodman

Goodman G2270 Instructions originales

Goodman

Goodman TSTATG2152-2 Manuel utilisateur

Goodman

Goodman TSTATG1152-2 Manuel utilisateur

Goodman

Goodman TSTAT GTS1175 Manuel utilisateur

Goodman

Goodman TSTATG2100-2 Manuel utilisateur

Goodman

Goodman TSTATG4271GT Manuel utilisateur

Goodman

Goodman TSTATG2111-2 Mode d'emploi

Goodman

Goodman TSTATG2111 Manuel utilisateur

Goodman

Goodman TSTATG1152-2 Manuel utilisateur

Goodman

Goodman TSTATG1100-2 Manuel utilisateur

Goodman

Goodman G4273 Manuel technique

Goodman

Goodman TSTATG1100-2 Manuel utilisateur

Goodman

Goodman TSTATG2152-2 Manuel utilisateur

Manuels Thermostat populaires d'autres marques

EWELLY

EWELLY EW-181 Manuel utilisateur

Prolon

Prolon T1100 Instructions d'installation

Computherm

Computherm Q20 Manuel utilisateur

Heatmiser

Heatmiser neoStat Manuel utilisateur

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur

Saswell

Saswell SAS920XWHB-7-S-RF Mode d’emploi

Aircalo

Aircalo TFP1-ET85P2 Manuel utilisateur

Honeywell

Honeywell CM721 Manuel utilisateur

Carrier

Carrier DEBONAIR 33CS Manuel utilisateur

Lennox

Lennox iHarmony Zone Thermostat Instructions de montage

Gemtech

Gemtech GT7000 Mode d’emploi

Rollei

Rollei Smartes 45000 Manuel utilisateur

Sinope

Sinope TH1300RF Manuel utilisateur

Honeywell

Honeywell RLV4305 Manuel utilisateur

Honeywell

Honeywell Prestige 2.0 THX9421 Manuel utilisateur

NuTone

NuTone NTBZ48 Instructions d'utilisation d'origine

Stelpro

Stelpro MAESTRO ASMT402AD Manuel utilisateur