Gira 2600 Series Manuel utilisateur
Installation and
Operating Instructions
VideoTerminal
2600 ..
3
Contents
Device description ..............................................................................................5
Installation ........................................................................................................ 6
Removing glass cover ........................................................................................7
Operation ............................................................................................................7
Normal conversation mode ................................................................................8
Accepting a call ............................................................................ 8
Enforcement function.................................................................... 9
Ending a call ................................................................................. 9
Deactivating/activating ringing tone .............................................10
Switching on camera image .........................................................10
Changing display of colour camera ..............................................11
Switching functions .....................................................................11
Opening door ...............................................................................11
Switching light (in conjunction with a switching actuator)............11
Structure of menu interface..............................................................................12
Camera selection .........................................................................13
Internal call ..................................................................................13
Switching.....................................................................................14
Automatic door opener ................................................................14
Status display...............................................................................15
Adjusting speech volume .............................................................15
Setting ringing tone volume .........................................................16
Selecting ringing tone melody......................................................16
Brightness - Contrast - Colour ......................................................17
Switch-on time.............................................................................17
Commissioning menu.......................................................................................18
Priority .........................................................................................18
Frequency ....................................................................................19
Resistor........................................................................................19
Lighting .......................................................................................20
Display .........................................................................................21
Language .....................................................................................21
Assign..........................................................................................22
Factory setting .............................................................................23
Version.........................................................................................24
Assigning door station to VideoTerminal..........................................................25
Assigning VideoTerminal via floor-call button ..................................................25
Assigning home station to VideoTerminal........................................................26
Assigning VideoTerminal to a home station.....................................................27
Assigning switching actuator to a VideoTerminal ............................................28
Technical data.................................................................................................. 29
Warranty .......................................................................................................... 30
4
5
Device description
The VideoTerminal is a home station from the Gira door communication system with
a large TFT colour display and a convenient hands-free speech function.
The VideoTerminal is operated with the backlit operating button for turning and
pressing and the four function buttons.
The Gira VideoTerminal can be installed in three different ways:
• in the modular function profile (surface-mounted)
• in the surface-mounted mounting frame
• in the flush-mounted mounting frame
VideoTerminal
Menu
1
2
3
1Devicebox
2 VideoTerminal
3 Glass cover
6
Installation
1. Specify the optimum installation location: As the installation height, it is recom-
mended that the centre of the display be positioned between 1.60 m and
1.70 m.
2. Install the modular function profile, or the mounting frame (see mounting
instructions for function profile or mounting frame).
3. Remove the VideoTerminal from the device box.
4. Open the required wire inlets on the device box and guide in the supply wires.
5. Insert the device box in the function profile or the mounting frame and screw
on.
6. Connect the VideoTerminal:
the 2-wire bus on the BUS terminals,
the power supply (24 V DC, 700 mA) on the AS (ZV) terminals and,
if necessary, the floor-call button on the ET terminals.
7. Insert the VideoTerminal in the function profile or the mounting frame and fas-
ten with 4 screws.
8. Lay on the glass cover and press it on until the retaining springs engage.
iWire lengths to power supply
The maximum wire length between the power supply and the VideoTerminal is
dependent on the wire diameter used. It is
50 m for 0.6 mm diameter and 80 m for 0.8 mm diameter
If these maximum wire lengths are exceeded, malfunctioning of the VideoTerminal
may occur.
iStart-up procedure of VideoTerminal
After the operating voltage is connected, the software of the VideoTerminals is
started. This start-up procedure takes approx. 30 seconds. During this time the
operating button lights up yellow.
BUS ET ZV
BUS ZV
BUS ET ZV
Spannungsversorgung
230 V AC
24 V DC
7
Removing glass cover
To remove, the glass cover is pulled off toward the front using the removal suction
cups provided.
Operation
The VideoTerminal is operated with the 4
function buttons and the backlit operating
button.
1Display
2"Menu"button
Briefly pressing the button activates/deacti-
vates the menu (see Page 12).
Pressing and holding the button activates/
deactivates the display and the colour cam-
era (see Page 10).
3Button
Directly switches a switching actuator (see
Page 11).
4Button
Used for ringing tone deactivation (see
Page 10).
5Button
Directly operates the door opener (see Page 11).
6Microphone
7 Operating button
The operating button accepts a call, ends it and operates the enforcement function
(see Page 8).
Turning and pressing selects and confirms the functions in the respective menus.
If several colour cameras are connected, the operating button is used to switch to
the next camera (see Page 11).
8Loudspeaker
VideoTerminal
Menu
1
5
6 8
7
8
Normal conversation mode
Accepting a call
If the call comes from a video door station,
the display is automatically switched on
and shows the camera image.
The number of cameras shown is dis-
played.
If the call comes from an audio door sta-
tion, the display "Door call" and "Accept
call" appears.
If the call comes from a home station, the
display "Internal call" and "Accept call"
appears.
A colour camera in the system can be
switched on with the "Camera" function
button. If several colour cameras are
installed, the last active camera is
switched on.
✓When a call is received, the operating but-
ton flashes green for two minutes.
1. Briefly press the operating button to
begin intercom conversation with the per-
son at the calling station.
✓The operating button lights up continu-
ously during intercom communication.
iMaximum conversation time
The maximum conversation time is 2 minutes. When this time expires, the conver-
sation is automatically ended.
Camera1
Door call
Accept call
Camera
9
Enforcement function
If the background noises at the door station are so loud that automatic switching of
the speech direction is not guaranteed, the enforcement function can be activated:
Ending a call
During a conversation with an audio door
station or an internal conversation with
another home station, "End call" appears
during the conversation.
1. This is achieved by pressing the operating button while
speaking.
While the button is being pressed, is it only possible to
speak from the VideoTerminal to the door station.
2. To release the voice control to the door station again,
release the operating button again.
✓The operating button lights up continu-
ously during intercom communication.
1. Briefly press the operating button to end
the voice connection.
✓The illumination of the operating button
goes out.
Door call
End call
Camera
10
Deactivating/activating ringing tone
Switching on camera image
The display of the VideoTerminal and the related colour camera can be specifically
activated/deactivated with the Menu button:
Only deactivate the ringing tone if necessary
Only deactivate the ringing tone in special cases. Otherwise, your run the risk of
not hearing the ringing in an emergency, for example.
1. Press the button to deactivate the ringing tone.
✓The operating button lights up continuously in red if the
ringing tone is deactivated.
2. Press the button again to reactivate the ringing tone.
✓The illumination of the operating button goes out.
iSwitching off ringing tone in "Automatic door opener" menu
As an alternative, the ringing tone of the VideoTerminal can also be switched off
in the "Automatic door opener" menu (see Page 14).
1. For activation, the Menu button is pressed and held for
approx. 3 seconds.
✓If several colour cameras are installed, the last active cam-
era is switched on.
✓The bottom line of the display continuously shows the des-
ignation of the camera currently active.
2. For deactivation, the Menu button is pressed and held
again for approx. 3 seconds.
Menu
3 s
Menu
3 s
Table des matières
Autres manuels Gira Système d'interphone
Gira
Gira 1264 00 Manuel utilisateur
Gira
Gira 1281 Series Manuel de service
Gira
Gira Surface-mounted video home station 7 Manuel utilisateur
Gira
Gira 2551 20 Manuel utilisateur
Gira
Gira 5919 Series Manuel utilisateur
Gira
Gira Surface-mounted video home station 7 Mode d'emploi
Gira
Gira 1250 Series Manuel de service
Gira
Gira 1269 65 Manuel utilisateur
Gira
Gira 1288 00 Manuel utilisateur
Gira
Gira 1279 series Manuel utilisateur
