1. Cut out a piece of 30 to 50 cm
length from the water conduit
after
the water meter
.
2. Connection of the seals and if
necessary the reductions at the
water conduit.
3. Connection of the flexible armoured
hoses at the entrance and exit of
the activator as well as at both
ends of the cut water conduit. The
nuts and bolts do not need to be
tightened. Pay attention to the
correct connection of Entrance
(“Eingang”) and Exit
(“Ausgang”)! The connections
must always (at least diagonally)
face
downwards
.
4. Now fix the holders at the wall
(they are supposed to take on the
activator).
5. Fix the activator into the holders
without exerting pressure on the
covers above and below the
activator.
6. After the activator has been fixed,
tighten the nuts and bolts of the
armoured hoses carefully (to avoid
the risk of damage), holding on to
the lock nut with a spanner.
Important Note:
The following rules are to be respected,
since neglecting them can crucially
impair the function of the appliance:
Minimum distance of at least
50 cm to wires carrying the
current.
Minimum distance of at least
150 cm to the current
junction box.
A metal cover or a metal
sheath over the activator is to
be avoided!
