GFA 10003738 10011 Manuel utilisateur

Installation Instructions

ELEKTROMAT

SI 55.40 FU-40,00

Model: 10003738 10011

-en-

Status: 30.05.2018

GfA ELEKTROMATEN GmbH & Co. KG

Wiesenstraße 81

D-40549 Düsseldorf

www.gfa-elektromaten.de

[email protected]

Table of contents

1General safety information .............................................................................................. 4

2Technical Data ................................................................................................................ 5

3Mechanical installation .................................................................................................... 6

4Electrical installation ..................................................................................................... 10

5Limit switch adjustment ................................................................................................. 11

6Motor connection .......................................................................................................... 12

7Limit switch connection ................................................................................................. 12

8Emergency manual operation (emergency hand crank) ................................................ 13

9Completion of commissioning / testing .......................................................................... 15

10Declaration of incorporation / conformance ................................................................... 18



Symbols

Warning - Potential injury or danger to life!

Warning - Danger to life from electric current!

Note - Important information!

▶ Requirement - Required action!

Schematic representations are based on product examples. Deviations from delivered

products are possible.

1 General safety information

Specified normal use

The drive unit is intended for doors, which have to be secured against falling down; a safety

brake is included in the gearbox. The drive unit is directly mounted on the door shaft.

The safe operation is only guaranteed with normal specified use. The drive unit is to be

protected from rain, moisture and aggressive ambient conditions. No liability for damage

caused by other applications or non-observance of the information in the manual.

Modifications are only permitted with the agreement of the manufacturer. Otherwise the

Manufacturer’s Declaration shall be rendered null and void.

Safety information

Installation and initial operation tasks are to be performed by trained, skilled fitters only.

Only trained electrical craftsmen are permitted to work on electrical equipment. They must

assess the tasks assigned to them, recognise potential danger zones and be able to take

appropriate safety measures.

The installation is only to be carried out with the supply off.

Observe the applicable regulations and standards.

Coverings and safety devices

Do not operate unless corresponding coverings and safety devices are fitted/installed.

Ensure that gaskets are correctly positioned and cable glands are correctly tightened.

Spare parts

Use only original spare parts.

2 Technical Data

Type SG 85F

Output torque 550 (440) 1) Nm

Output speed OPEN 8-40 rpm

Output speed CLOSE 8-30 rpm

Output speed CLOSE > 2,5m 8-30 rpm

Output shaft / hollow shaft 40,00 mm

Locking torque moment 1100 Nm

Safety brake (testhouse/approval number) 14-003612-PR03

Supply voltage 3~ 400 V

Maximum holding torque 550 Nm

Operating current 12,40 A

Operating frequency 50 Hz

Power factor cos φ 0,76

Maximum movement per hour 20 h-1

Hand forces 320 N

Class of protection IP 65

Limit switch range

(maximum revolutions of output shaft / hollow shaft) 20

Braking torque 9 Nm

Braking voltage 178 V DC

Rectifier type FU

Temperature range +5 / +40 (+60) 2) °C

Operating sound pressure level < 70 dB(A)

Abtriebsdrehmoment, das konstant über den gesamten Endschalterbereich und die maximalen Schaltungen pro Stunde genutzt werden kann.

2) When using a temperature range of +40°...+60°C use half of maximum movements per hour.

3 Mechanical installation

Prerequisites

The permissible loads on walls, fastenings, mountings and transmission elements must not

be exceeded, even for maximum holding torques or locking torques (▶ refer to technical

data).

Connection elements

▶ Self-locking connection

elements with a minimum

strength of 800 N/mm2

(8.8) must be used.

▶ Utilize the hole diameter

to the full.

▶ Use adequately

dimensioned washers for

elongated holes.

BAGAB00002_Z002 BA GAB00003_Z002

3 : 1

Permissible mounting positions

BAGAC0 30 0 1 _Z0 0 2

Mounting

Two elongated holes are provided for mounting.

BAGAD03 0 0 1 _Z0 0 3

Installation

The descriptions below apply to general door specifications. The specifications of the door

manufacturer must also be observed during installation.

Warning - Potential injury or danger to life!

 During installation, be sure to use a lifting device that has a sufficient load-carrying

capacity.

▶ Thoroughly grease the door shaft. BAGAE01001_Z003

▶ Mount the keys.

BAGAE03002_Z001

▶ Attach the drive unit. BAGAE03005_Z002

▶ Tighten all connection elements (M12) to

75 Nm. Install all other connection

elements according to the specifications of

the door manufacturer.

BAGAE03010_Z002

75 Nm

8.8

4 Electrical installation

Warning - Danger to life from electric current!

 Switch the mains OFF and check that the cables are de-energised

 Observe the applicable regulations and standards

 Make a proper electrical connection

 Use suitable tools

Performing electrical installation

Remove the cover. Insert the motor plug. Insert the limit switch plug.

BAHEA02_Z001 BAHEB01_Z001 BAHEC01_Z001

Completing the electrical installation

Mount the cable entries and/or cable glands.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels GFA Entraînement CC

GFA

GFA SI 25.15-30,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SE 14.15-25,40 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 5.250 FU-25,40 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 65.15-40,00 Manuel utilisateur

GFA

GFA 10002624 10011 Manuel utilisateur

GFA

GFA ELEKTROMAT ST 80.15-50,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 45.60 FU-40,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 25.15-30,00 Ex Manuel utilisateur

GFA

GFA ELEKTROMAT SI 25.15-30,00 GA25HC/15GD Manuel utilisateur

GFA

GFA ELEKTROMAT SI 10.15-30,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 25.15 WS-30,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 55.15-40,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 25.35-30,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 75.45 FU-55,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 35.100 FU-40,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 14.15-25,00 Manuel utilisateur

GFA

GFA 10003166 10011 Manuel utilisateur

GFA

GFA ELEKTROMAT FS 15.20-25,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 55.40 FU-40,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 360.12 FU-80,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 140.20 FU-55,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 75.20 FU-55,00 Manuel utilisateur

GFA

GFA ELEKTROMAT SI 180.12 FU-60,00 Manuel utilisateur

GFA

GFA ELEKTROMAT ST 9.24-25.00 Manuel utilisateur

Manuels Entraînement CC populaires d'autres marques

Vincent Associates

Vincent Associates UNIBLITZ ED12DSS Manuel utilisateur

EKSMA OPTICS

EKSMA OPTICS DQ-100-4 Manuel de la liste des pièces

Chamberlain Garog

Chamberlain Garog D Series Manuel utilisateur

Parker

Parker PDS Series Manuel utilisateur

Festo

Festo DGC G Series Guide de configuration

Binks

Binks QS-5012-1-CE Manuel utilisateur

Danfoss

Danfoss VLT 2800 Series Fiche technique

ABB

ABB ACQ580-01 Series Manuel d'installation

YASKAWA

YASKAWA CANopen SI-S3 Manuel utilisateur

GE D20A6 Manuel utilisateur

Unex

Unex MC-D-250-1000-050W-TW Manuel utilisateur

Geckodrive

Geckodrive G213V Manuel utilisateur

ABB

ABB RSYC-01 Manuel utilisateur

Rockwell Automation

Rockwell Automation PowerFlex 700S Manuel du propriétaire

WEG

WEG DeviceNet CFW500 Manuel utilisateur

Siemens

Siemens SINAMICS G Fiche technique

Siemens

Siemens SINAMICS SM150 6SL3815-7NP41-0AA1 Mode d'emploi

SOMFY

SOMFY JR RU 30 Manuel utilisateur