Genie WHD8BVAF Manuel utilisateur

User Manual

Please read these instructions carefully before operating the unit

and keep for further reference.

8MP 4-in-1 IR Bullet Camera

with 2.8–12mm Auto Focus

Lens

WHD8BVAF

Intro Section

Please read this instruction carefully before operating the product and keep it for

further reference. All examples and pictures used here are for reference only.

The contents of this manual are subject to change without notice.

CAUTION:

• If the product does not work properly, please contact your dealer or the

nearest service centre. Never attempt to disassemble the camera yourself. We

shall not be responsible for any problems caused by unauthorised repair or

maintenance.

• Do not allow water or liquid into the camera while in use.

• When using the product, you must be in strict compliance with the electrical

safety regulations of the nation and region.

• When the product is mounted on wall or ceiling, the device needs to be ﬁrmly

ﬁxed.

• Make sure the power supply voltage is correct before using the camera.

• Do not drop the camera or subject it to any physical shock.

• If cleaning, please use a clean soft cloth with a little neutral detergent to wipe it

gently.

• Do not aim the camera at the sun or in any area where there is bright lighting.

• The device may be burned out by a laser beam, so when any laser equipment is

in use, make sure that the surface of the device will not be exposed to the laser

beam.

• Do not place the camera in extremely hot, cold , dusty or damp locations, and

do not expose it to high electromagnetic radiation.

• To avoid heat accumulation, good ventilation is required for operating

environment.

Contents

iii

1.0 Introduction..........................................................................................................4

1.1 Product Features...........................................................................................4

1.2 Product Dimensions.....................................................................................4

1.3 Speciﬁcation.................................................................................................5

1.4 Functions ......................................................................................................6

2.0 Cables ..................................................................................................................7

3.0 Product Installation..............................................................................................8

4.0 Call Up Main Menu ...............................................................................................9

The Genie WHD8BVAF is a professional, modern bullet design CCTV camera that

boasts 4-in-1 technology (AHD, TVI, CVI, CVBS) and offers a 2.8–12mm motorised

auto focus lens. The camera offers IP67 protection and up to 50m viewing when

the IR illumination is switched on.

1.1 Product Features

• 8MP @ 15fps / 5MP @ 20fps / 4MP @ 30fps high resolution, true colour

• Switchable AHD, TVI, CVI, CVBS (960H) output

• CMOS progressive scan, improves moving object capture

• Supports OSD menu

• High speed, long distance and real time transmission

• Auto colour to B&W at low illumination

• Supports ICR switch, true day / night

• Supports noise reduction function

• 30 ~ 50m IR night view distance

• IP67 ingress protection

• Supports COC

• NDAA compliant

1.2 Product Dimensions

217.7mm 80.5mm

80.5mm

1.0 Introduction

User Manual 8MP 4-in-1 IR Bullet Camera with 2.8–12mm Auto Focus Lens

1.3 Speciﬁcation

Camera

Image Sensor 1 / 2.5” CMOS

Image Size 3840 × 2160

Image System PAL / NTSC

Resolution 8MP

Electronic Shutter Auto

Minimum Illumination Colour : 0.01 Lux @ F1.2, AGC ON

B&W : 0 Lux with IR

Lens 2.8–12 mm motorised lens

S / N Ratio ≥52dB (AGC Off)

Frame Rate 8MP @ 15fps

Video Output AHD / TVI / CVI / CVBS

Functions

IR Distance 30 ~ 50 m

Function Control OSD (COC Control)

Day & Night ICR

Digital WDR No

3D NR Yes

AGC No

Auto White Balance Yes

BLC Yes

LSC No

Defog No

Saturation Yes

Sharpness Yes

Contrast Yes

Smart IR Yes

Image Setting Yes

Defect Correction Auto

Language 11 languages

Angle Adjustment Pan: 0°~360°, Tilt: 0°~90°, Rotation: 0°~360°

Others

Ingress Protection IP67

Power Supply DC12V (± 10%)

Power Consumption IR Off : < 2W, IR On : < 5.5W

Working Environment - 30°C ~ 50°C,

10 % ~ 90 % (Relative Humidity)

Dimensions 217.7 × 80.5 × 80.5 mm

Weight Approximately 0.57Kg (Net)

User Manual 8MP 4-in-1 IR Bullet Camera with 2.8–12mm Auto Focus Lens

1.4 Functions

High Resolution

Adopt high performance sensor, providing high deﬁnition and clear image.

High Transmission Performance

Real-time transmission with high speed and long distance.

DNR

Reduce noise from brightness and colour signal.

OSD

It’s easy for the user to call the setup menu and conﬁgure the menu. The camera

settings can be clearly displayed through the main menu.

White Balance

Adjust the colour temperature according to the environment automatically.

ICR Auto Switch

The ﬁlter will ﬁlter infrared light during the daytime and change to normal at night

to ensure a high sensitivity and clear image.

AGC

Adjust the gain of ampliﬁer, enabling the camera to output the standard video

signal in different lighting condition.

Wide Dynamic Range (WDR)

When there are both very bright and very dark areas simultaneously in the ﬁeld of

view, this function will balance the brightness level and provide clear images.

Backlight Compensation (BLC)

When the back of the captured object is too much bright, you can set BLC for the

captured object to make it clearer.

The cables are only for reference. The default video output will be different for

different cameras.

For the camera with video switch cable, there are two kinds of video switches,

button switch and dial switch.

Button Switch: The video outputs will recycle by holding and pressing the button

in the video switch cable for 5 seconds.

Dial Switch: Please set the video output according to the directions described on

the tag of the video switch cable.

Note:

Before switching video outputs, remove the cover of the video switch cable ﬁrst.

* Some models do not have the video switch cable, please go to OSD to change

video outputs.

Video Output

Power Cable

Video Output

Video Switch Cable

2.0 Cables

Before you start, please make sure that the wall or ceiling is strong enough

to withstand 3x the weight of the camera. Please install the camera in the dry

environment.

1. Attach the drill template to the place where you want to ﬁx the camera and

then drill screw holes according to the drill template.

2. Route and connect the cables.

3. Secure the mounting base with the camera to the wall with screws as shown

below.

4. Bracket adjustment. Before adjustment, preview the image of the camera on a

monitor and then loosen the ﬁxed ring or screws to adjust the view angle of the

camera.

5. Focus and zoom adjustment (If the model you get is ﬁxed lens or motorised

lens, please skip this step). Remove the cover and then adjust the focus and

zoom levers to get a clear image. Finally, install the cover back.

Fixed Ring

Fixed

Screws

Pan 360°

Tilt 90°

Lens Cover

Focus

Zoom

Cover

Focus

Zoom

Tilt 90°

Rotation 360°

3.0 Product Installation

Access Main Menu

1. Press Enter key of the rear panel or cable of the camera to go to the main

menu.

2. Select the preview window and right click the mouse to show the following

menu list on the DVR.

3. Click on the toolbar at the bottom of the live preview window (or right click

the mouse to select “PTZ Control”).

4. Select the “OSD” tab and then click / to call up the main menu.

Menu Operation

You can select the menu by clicking (U) or (D) key on the direction area.

Click (L) or (R) key to select the menu on the left. The menu with arrow icon

which means it has sub-menu. Click / to go to the sub-menu or conﬁrm the

settings.

If there are direction keys and enter key on the cables of the camera, you can also

use these direction keys to select menu and the enter key to go to the sub-menu

or conﬁrm the settings.

Note:

This series of the camera must be connected to the DVR which supports calling

up main menu of camera. Different DVRs manufactured by different DVR

manufacturers may have different modes of menu operation. Please refer to the

relevant User Manual of DVR.

* Some models may not support calling up main menu, please take the ﬁnal

product as the standard.

Camera Camera1

OSD PresetCruise

4.0 Call Up Main Menu

Sales +44(0)1707 330541

Enquiries [email protected]o.uk

Website www.genieproducts.co.uk

Table des matières

Autres manuels Genie Appareil photo numérique

Genie

Genie GIPPIR Manuel utilisateur

Genie

Genie GAHDB650IR Manuel utilisateur

Genie

Genie GEBV Manuel utilisateur

Genie

Genie WIPX8EBVAF5 Manuel utilisateur

Genie

Genie PWIPN8EBVAF Manuel utilisateur

Genie

Genie WIP2FRTMTP Manuel utilisateur

Genie

Genie WHD8EBVAF Manuel utilisateur

Genie

Genie MSC Series Manuel utilisateur

Genie

Genie GHDPIR Manuel utilisateur

Genie

Genie WAHD8162 Manuel utilisateur

Genie

Genie WAHD2BVAF Manuel utilisateur

Genie

Genie PWIP4EB Manuel utilisateur

Genie

Genie HDMC221V2 Manuel utilisateur

Genie

Genie WHD5EB Manuel utilisateur

Genie

Genie WHD5EBVAF Manuel utilisateur

Genie

Genie WIPX4EB Manuel utilisateur

Genie

Genie GIP2CMIR Manuel utilisateur

Genie

Genie GHD190DV Manuel utilisateur

Genie

Genie GAHDCMIR Manuel utilisateur

Genie

Genie GEBVAF Series Manuel utilisateur

Genie

Genie SSAHD2B Manuel utilisateur

Genie

Genie GEB Manuel utilisateur

Genie

Genie WHD8EB Manuel utilisateur

Genie

Genie WAHD2EBVAF Manuel utilisateur

Manuels Appareil photo numérique populaires d'autres marques

Mercury

Mercury 350K Manuel utilisateur

Pentax

Pentax Optio LS 465 Manuel utilisateur

Sanyo

Sanyo VPC-S1085 Manuel utilisateur

GE SMART A1255 Manuel utilisateur

Point Grey

Point Grey Gazelle Manuel utilisateur

Nikon

Nikon COOLPIX A Manuel utilisateur

Pentax

Pentax P-5 Manuel utilisateur

BlazeVideo

BlazeVideo A280 Manuel utilisateur

Sony

Sony MCA-20 Manuel utilisateur

Sony

Sony Alpha DSLR-A290 Manuel utilisateur

ATIK Cameras

ATIK Cameras One Manuel utilisateur

CohuHD Costar

CohuHD Costar 3930 Series Manuel utilisateur

Leica

Leica M10-R Manuel utilisateur

FujiFilm

FujiFilm FinePix A700 Manuel utilisateur

Lorex

Lorex LNZ81P25 Series Manuel utilisateur

GE J1470S Manuel utilisateur

Sony

Sony A6700 Guide de l'utilisateur

Canon

Canon EOS ELAN7 Manuel utilisateur