GE Paywise Manuel utilisateur
Guide to your
new
Pay As You Go
meter
T1 T2 T3 T4 T5 T6
000010.73
1.8.0
Supply
disconnected
Display
number*
Current
tariff
Energy
reading
u
Credit status
indicators
e
Display cycle
button
r
Meter display
t
Meter number
o
Re-connection
and
Emergency
credit
activation switch
i
Display legend
Meter overview
Guernsey Electricity are installing new Pay As You Go
Meters that will make it easier for you to operate and to
keep track of how much electricity you use. The Meters also
feature ‘Friendly’ periods which mean that you will not be
left without electricity during periods when top-ups aren’t
possible, for example in the middle of the night.
The
display
legends
*Number refers to the current display and always starts with 1.8. For details
see display legend on the front of the meter. E.g. 1.8.8 = Usage Cost p/hr.
T1 T2 T3 T4 T5 T6
5.41
BAL
T1 T2 T3 T4 T5 T6
0.41
- BAL
in Credit or in Debt (-)
Pressing the green button ecycles through the
display. For information on your last payment
press repeatedly until you see the date appear.
Adding credit to
the meter
To add credit simply hold your
charged card against the meter
as indicated.
First beep
The meter has started reading
the card. Please KEEP holding
the card in front of the meter.
Double Beep
The meter has finished reading
the card, you can now remove
it and view your credit on the
display.
If the meter makes a long beep
it has failed to read the card.
Please remove your card, wait a
few seconds and then try again.
The display
The meter display alternates between:
• the current rate and the balance reading
• and emergency credit, if activated.
When displaying the balance the meter shows if you are:
T1 T2 T3 T4 T5 T6
17
-
10
-
12
- - 2
T1 T2 T3 T4 T5 T6
1.00
- - 3
T1 T2 T3 T4 T5 T6
27.40
- - 5
T1 T2 T3 T4 T5 T6
20.00
- - 6
Press approx. 12 times
Last credit on meter date
Press again
Last payment accepted by
meter
Press twice more
Current meter arrears
(if you are not in arrears this will read 0.00)
Press again
Arrears collection per week
(if none is due this will read 0.00)
Emergency credit
You can activate the Emergency Credit (£2.00) when the credit
shown on the meter is below £1.00.
Emergency credit is available if the orange E/Credit light u
is flashing.
To activate Emergency credit just press the button
oat the
bottom of the meter, if the credit is below £0.00 the supply
will be reconnected. The meter display will alternate between
the Credit Balance - BAL
and remaining Emergency
Credit --1 available before
disconnection.
Once the Emergency credit
has been used up, the entire
balance due will have to be
repaid before your supply can
be reconnected.
‘Friendly’ periods
The meter is designed not to disconnect at times when it is not
possible for you to top up your card. So, if your credit runs out
at an unsociable hour we will be ‘Friendly’ and the supply will
remain on but accumulate a debt which will need to be repaid
during the next ‘TOP-UP TIME’. If you do not put some credit on
your meter at the next ‘TOP-UP TIME’ your supply is likely to go off.
For a quick guide to Emergency credit and ‘Friendly’ and
‘TOP-UP TIME’ periods, please see the chart over the page ➔
Where to buy credit
You can buy top-ups at the outlets listed on the reverse
of this leaflet. You can also call us on 200700 or go to
www.electricity.gg for the latest information.
Lost Card
Should you lose your card, please call in to Guernsey Electricity
on the Bridge to arrange for a replacement. Repeated losses
may result in a small charge.
SUPPLY
DISCONNECTED
METER NEEDS
CREDIT TO
RECONNECT
ACTIVATE
EMERGENCY
CREDIT
BY PRESSING
BUTTON
CREDIT
RUNS OUT
?
FRIENDLY
TIME
YES NO
No credit
light illuminates
SUPPLY STAYS
Next
TOP-UP TIME
SUPPLY
DISCONNECTS
E/Credit light
flashes
SUPPLY TURNS
YES
EMERGENCY
CREDIT RUNS
OUT
Next
TOP-UP TIME
SUPPLY
DISCONNECTS
?
FRIENDLY
TIME
12|00 16|30 23|5909|00
Monday-
Saturday
00|00
Sunday
and Bank
Holidays
NO
T1 T2 T3 T4 T5 T6
2.00
- - 1
T1 T2 T3 T4 T5 T6
0.41
- BAL
The meter is designed not to disconnect at times when it
is not possible for you to top up your card. So, if your credit
runs out at an unsociable hour we will be ‘Friendly’ and the
supply will remain on but accumulate a debt which will need to
be repaid during the next ‘TOP-UP TIME’.
SUPPLY
DISCONNECTED
METER NEEDS
CREDIT TO
RECONNECT
ACTIVATE
EMERGENCY
CREDIT
BY PRESSING
BUTTON
CREDIT
RUNS OUT
?
FRIENDLY
TIME
YES NO
No credit
light illuminates
SUPPLY STAYS
Next
TOP-UP TIME
SUPPLY
DISCONNECTS
E/Credit light
flashes
SUPPLY TURNS
YES
EMERGENCY
CREDIT RUNS
OUT
Next
TOP-UP TIME
SUPPLY
DISCONNECTS
?
FRIENDLY
TIME
12|00 16|30 23|5909|00
Monday-
Saturday
00|00
Sunday
and Bank
Holidays
NO
‘Friendly’
periods
Top-up credit is available from:
•Guernsey Electricity Reception
•Checkers Xpress
The Bridge, Pollet, & Collings Rd, St Peter Port
•The Co-operative
The Market & Forest
•Jeffrey’s CI Fuels, Ville au Roi
•Landes du Marche Garage
•Candie Cache Stores
ISSUE Nº
03
JUNE 2014
Northside GY1 3AD
200 700
electricity.gg
Your card
200700 /guernseyelectricity
@guernseyelectricity www.electricity.gg
Table des matières
Autres manuels GE Instrument de mesure
GE
GE RHM 80 Manuel utilisateur
GE
GE Dresser Series B3 Manuel du propriétaire
GE
GE Bently Nevada 3300/16 Manuel utilisateur
GE
GE 3300 Manuel utilisateur
GE
GE Hydran 201i Manuel utilisateur
GE
GE N60 Manuel utilisateur
GE
GE RHM 20 Manuel utilisateur
GE
GE Intellix BMT 330 Manuel utilisateur
GE
GE PM880 Manuel utilisateur
GE
GE UV-1 Manuel utilisateur
GE
GE PanaFlow Z1G Manuel utilisateur
GE
GE N60 Manuel utilisateur
GE
GE MT144 Manuel utilisateur
GE
GE TransPort PT878GC Manuel utilisateur
GE
GE Baker Hughes PanaFlow LC XMT1000 Manuel utilisateur
GE
GE N60 Manuel utilisateur
GE
GE PQMII Manuel utilisateur
GE
GE 68K System Manuel utilisateur
GE
GE EPM 5300 Manuel utilisateur
GE
GE hydran m2 Manuel utilisateur
Manuels Instrument de mesure populaires d'autres marques
Endress+Hauser
Endress+Hauser Proline Promag 50 Caractéristiques techniques
Siemens
Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces
KLINGER
KLINGER CMF V Series Manuel utilisateur
EXFO
EXFO FTB-2 Manuel d'exploitation et d'entretien
Keysight
Keysight M8290A Manuel utilisateur
ADTEK
ADTEK MW-5 Manuel utilisateur