G-Force Power Switch G0021 Manuel utilisateur
G-FORCE introduces the POWER SWITCH, a tiny MCU controlled on/off switch for your radio controlled
model. A simple push button operates the switch meaning to eliminate the problems associated with
intermittent contact of an ordinary mechanical switch. The sealed unit is plastic and can easily be
mounted to the transponder mount of your model or anywhere else you can mount it using double side
tape. (Two kinds of bottom covers are included, user can change the bottom cover.)
The switch also features a LiPo mode, by turning this on the switch unit will auto detect low LiPo voltage
and cut off power to protect your LiPo from over dis-charging. This of course can be turn off if you have
other safeguards in place or using NiMH/NiCad battery.
Beside that the power switch informs you about the remaining capacity and conditions of your battery
pack.
Thank you very much for your trust in the products of G-FORCE. Please read this user manual carefully
before using this product to avoid any problems in advance. Please also pay attention to the technical
data and limits of this product.
INTRODUCTION
SWITCH ON/OFF SETUP
1.NiMH/NiCadBatteryPack
For switching on please press and hold the button for one second. The PWR LED will turn on. For
switching off please press and hold the button until all LEDs turn off. The PWR LED also shows you
the remaining battery capacity when switched on.
SWITCH ON
Green
Orange
Red
Red Blinking
80-100%
60-79%
20-59%
<20%
REMAINING BATTERY CAPACITY
SWITCH OFF
Press and hold the button
for one second. Press and hold the button until all LEDs turn off.
1/ 2
INSTRUCTION MANUAL
G0021
All manuals and user guides at all-guides.com
all-guides.com
RoHS
2.LiPoBatteryPack
For switching on please press and hold the button for more than three second. The PWR LED and
LIPO LED will turn on. For switching off please press and hold the button until all LEDs turn off. The
PWR LED also shows you the remaining battery capacity when switched on.
SWITCH ON
Green
Orange
Red
Red Blinking
80-100%
60-79%
20-59%
<20%
REMAINING BATTERY CAPACITY
SWITCH OFF
Press and hold the button
for more than three second. Press and hold the button until all LEDs turn off.
SPECIFICATIONS
Input Voltage: 4-12V
Max. Current: 10 Amp
Battery Mode: 1. NiHM / NiCad 2. LiPo
Low Voltage Protection: 6.2V(LiPo)
Operating temperature: 0-50℃
Weight: ≤7g
With Transponder Mount
34.5mm
28.5
22.5
16
8.5
15.93
21.93
3- 3.2 22.5mm
16
8.5
2/ 2
Without Transponder Mount
Products by
G-FORCE, Inc.
www.gforce-hobby.jp
Mare-kanda Bld.9F, 1-3-1, Kajicho, Chiyoda-ku,
Tokyo, 101-0044, JAPAN
Copyright © 2014 G FORCE, Inc. All Right Reserved.
All manuals and user guides at all-guides.com
Table des matières
Autres manuels G-Force Changer
