1 Safety instruction
1.1 The electric scooter is a recreational transporter. Before mastering riding skills, you need to practice, G-CYCLE is not responsible for
any injuries or damages caused by a rider's inexperience or failure to follow the instructions in this document.
1.2 Please understand that you can reduce the risk by following all the instructions and warnings in this manual, but you cannot
eliminate all the risks. Remember that whenever you ride the electric scooter you risk injury from loss of control, collisions and falls.
When entering into public spaces always comply with the local laws and regulations. As with other vehicles, faster speeds require a
longer braking distance. Sudden braking on low traction surfaces could lead to wheel slip or falls. Be cautious and always keep a safe
distance between you and other people or vehicles when riding. Be alert and slow down when entering unfamiliar areas.
1.3 Always wear a helmet when riding. Use an approved bicycle or skateboard helmet that fits properly with the chin strap in place,
and provides protection for the back of your head.
1.4 Do not attempt your first ride in any area where you might encounter children, pedestrians, pets, vehicles, bicycles, or other
obstacles and potential hazards.
1.5 Respect pedestrians by always yielding the right of way. Pass on the left whenever possible. When approaching a pedestrian from
the front, stay to the right and slow down, avoid startling pedestrians. When approaching from behind, announce yourself and slow
down to walking speed when passing. Please obey local trac laws and regulations if the situation is dierent.
1.6 In places without laws, comply with the safety guidelines outlined in this manual. G-CYCLE is not responsible for any property
damage, personal injury/death, accidents, or legal disputes caused by violations of the safety instructions.
1.7 Do not allow anyone to ride your scooter on his/her own. The safety of new riders is your responsibility. Assist new riders until they
are comfortable with the basic operation of the electric scooter. Make sure each new rider wears a helmet and other protective gear.
1.8 Before each ride check for loose fasteners and each component. lf the scooter makes abnormal sounds or signals an alarm,
immediately stop riding and contact us through support@g-cycle.com for service.
1.9 Be alert! Scan both far ahead and in front of your scooter- your eyes are your best tool for safely avoiding obstacles and low
traction surfaces (including but not limited to wet ground, loose sand, loose gravel, and ice).
5 Setting Overview
Display
4
4
4
4
4
73
Multi-function Description about the Power Button.
1. Turn on/o the scooter. Keep pressing the power button for two seconds to turn it on/o.
2. Turn on/o the lights. After turning on the scooter, quickly press the power button twice to turn on/o the LED light.
3. Adjust the speed. Press the power button once to adjust the speed. (It has two speed levels, 9mph and 15mph).
4.Change the speedunit (mph orkm/h). Quickly press the power button three times.
5. Cruise Control Mode. Quickly press the power button four timesto activate the cruise control mode, and then if the speed is
maintained at a certain speed for 8-10 seconds, you’ll enter into the cruise control mode and you’ll hear the beep sound twice. When
you pull the brake or throttle again, the scooter will end the cruise control mode, and you will hear a beep sound.
6. The power will turn o automatically after 5 minutes of no operation.
Battery level
Speed unit
Current speed
Front and rear light
4
6
