IV5038-E Edion B fossbreopcs.com Page 3 of 3
Foss AS
P.O. Box 3614
N-3007 Drammen
Telephone +47 32 21 08 00
Telefax +47 32 21 08 08
rmapost@foss-as.no
www.fossbreopcs.com
The informaon in this document is believed to be reliable (including drawings and pictures). However, FOSS AS makes no warranes as to its
accuracy or completeness and disclaims any liability in connecon with its use. The document may contain inaccuracies and errors. In no case
will FOSS AS be liable for any incidental, indirect or consequenal damages arising out of the sale, resale, use or misuse of the described
products. Users of FOSS AS products should make their own evaluaon to determine the suitability of each such product for the specic
applicaon. In no case will FOSS AS be liable for any errors, inaccuracies, omissions or lack of validity of informaon in this document.
Any use or copying of this document for other purposes than it is intended is strictly forbidden.
Onto DIN rail:
The base units DIN-clip is clipped on boom rst. The box is then pulled up to
clip on to the top part of the rail.
The DIN clip is mounted at the rear on delivery (le picture).
If you want to have the clip on the at side of the box, a wall bracket must be
used (must be bought as accessory, see data sheet DB4177):
This is xed to the box with the same screws/holes as was used for the
DIN-clip. Then the DIN-clip is xed to the bracket with 3 pcs. Of M3 screws.
Note that the spring loaded side of the clip should point downwards. (Closure
facing right; mount clip upside down)
Onto a wall, in front of a wall box or onto a raceway front:
To mount directly to the wall the DIN-clip is replaced by a wall bracket (may
be bought as accessory). This is xed to the box with the same screws/holes
as was used for the DIN-clip. The screws are inserted into the wall with 60 cm
distance and the bracket is hooked on using the key-holes, the slots are 4.5
mm wide. (The easiest may be to use the bracket as a template when making
the holes in the wall).
If the box needs to be secured hard to the wall, the bracket may be xed to
the wall rst and the box mounted on the bracket aerwards (but then the
box may not be placed in a corner).
The bracket is also used if the closure is to be put in front of a wall or raceway
box. (Box has to have its screws c/c 60 mm horizontally.)
In this case, mount the bracket to the wall box rst, then the closure to the
bracket. Cable should be put through the bracket hole, down and into the
closure. (Max cable diameter 7 mm). Assure that cable’s minimum bend
radius is not violated.
The lid may be removed even though the closure is aached to the bracket:
Remove the 4 screws, then slide the closure out, sideways or upwards.
4.1
4. Mounng to DIN-rail/wall box/raceway
4.2
4.3
