Safety Instructions
Please read the safety and warning information below before operating
your new GC2 smart camera system:
If foreign objects or water has entered the device, disconnect the
device from external power and turn the power off.
Continued use in this state can cause fire or electric shock.
DO NOT disassemble, change or attempt to repair the device.
This could result in electric shock and will void the manufacturer’s
warranty. If the flash module needs to be replaced, follow the
directions provided in this user manual.
DO NOT use this device in environments where high humidity,
smoke or dust is present.
To avoid possible injury, DO NOT look directly at the device while
the flash is in use.
The GC2 has been designed to withstand ball impact. However,
if the device enclosure or LCD display has been damaged due
to a ball impact or for any other reason, turn power off and
discontinue use.
Use only the power adapter that came with the device. Using any
other power adapter or charger may cause damage to the GC2 or
battery, and may cause fire or injury.
Unless directly authorized by Foresight Sports, DO NOT attempt
to replace the battery in the device. Doing so will void all
warranties, and may cause injury. For battery replacement
authorization and instruction, please contact Foresight Sports.
The GC2 uses two digital cameras that are precisely calibrated.
Do not drop or subject the device to any impacts that may
cause shock.
After use, always store the GC2 in a safe, dry, and dust-free
environment.
Replacing the Flash Unit
10
The GC2 has a replaceable flash unit installed. Depending on usage, this
unit should operate reliably for one to two years. If the flash unit requires
replacement, it can be easily removed and replaced.
To replace the flash unit:
2
1
3
4
5
Using a flat head screwdriver (not provided),
loosen the two screws connecting the flash
unit to the device housing until the screws
spin freely.
NOTE: Screws are attached to the
removable flash unit. DO NOT attempt
to pull screws out by themselves.
Make sure LCD screen is fully lowered into
base prior to removing flash unit.
Once both screws spin freely, grab both
screws firmly and gently pull flash unit from
housing. If necessary, pull against screws in
an alternating pattern to free flash unit
from device.
Align new flash unit with attached screws to
device housing. MAKE SURE PINS ON BACK
OF FLASH UNIT ARE PROPERLY ALIGNED
WITH PIN RECEPTACLES IN DEVICE. Gently
but firmly insert flash unit into housing.
Secure new flash unit by
tightening both screws
until snug.
DO NOT
OVER-TIGHTEN
SCREWS.
11
New flash modules may be
purchased by contacting your
Foresight Sports retailer
or representative today.
Need a new flash?
