Flybox EngiMaster Manuel utilisateur

FLYBOX

EngiMaster

Engine Information System

User Manual

FLYBOX

REV 1.0

User Manual, Safety Instructions

and Warning Booklet

This product is not TSO’d and cannot be installed

into traditional FAA Part 23 and similarly Type-

Certicate Aircraft

Document U2023ENGMST

Revision#1.0, 11/2023

For rmware version 1.13

This booklet is suitable for printing in A5 format.

FLYBOX

SECTIONS

REV 1.0 3

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

WARRANTY

TECHNICAL SPECIFICATIONS

IMPORTANT NOTICE AND WARNINGS

INDEX

INTRODUCTION

INSTRUMENTS CONFIGURATION

OPERATING INSTRUCTIONS

DISCLAIMER

FLYBOX Important notice & warnings

REV 1.0

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

Symbols used in the User Manual

NOTE: Used to highlight important information.

CAUTION: Used to warn the user, it indicates a potentially

hazardous situation or improper use of the product.

WARNING: Used to indicate a dangerous situation that

can cause personal injury or death if the instruction is

disregarded.

FAILURE TO DO SO MAY RESULT IN SERIOUS

INJURY OR DEATH.

FLYBOX

Important notice & warnings

REV 1.0 5

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

WARNING: These instructions must be provided to users

before use, and retained for ready reference by the user.

The user must read, understand (or have explained) and

heed all instructions and warnings supplied with this

product and with those products intended for use in

association with it. Always keep a copy of the Installation

and User Manual, Safety Instructions and Warning

Booklet on the aircraft. In case of change of ownership,

the Installation and User Manual, Safety Instructions and

Warning Booklet must be delivered together with all of the

other papers.

WARNING: Read the Installation and User Manual, Safety

Instructions and Warning Booklet before installing the

device on your aircraft and follow the procedure described

therein.

WARNING: This device is intended to be installed on

NON-TYPE CERTIFIED AIRCRAFT ONLY, as it does

NOT require any air operator’s certicate. Refer to your

national aviation authorities to check if this device can be

installed on your aircraft.

WARNING: It is the owner’s responsibility to test this

device before operating the aircraft and to make sure

nobody is using it unless properly instructed and

authorized to do so.

WARNING: Once the installation process is completed, it

is extremely important to test the device before taking o

to make sure it works properly. Therefore, we strongly

suggest to double check all of the electronic instruments

available on the aircraft and to turn them on to verify they

function correctly.

FLYBOX Important notice & warnings

REV 1.0

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

WARNING: This device is operated through a software

which from time to time can be updated and/or subject to

change. Please, always refer to the Installation and User

Manual, Safety Instructions and Warning Booklet for the

last updated version of the software available on www.

yboxavionics.it

WARNING: It is the responsibility of the installer to

properly install the device on the aircraft. In case of

calibration, or any technical or functional customization of

the device, the responsibility lies with the individual who

carried out such operation.

WARNING: If this product is not used correctly, or it is

subjected to additions or alterations, the eectiveness of

this device may be considerably reduced.

WARNING: Alterations, additions, or repairs not

performed by the instrument manufacturer or by a person

or organization authorized by the manufacturer shall

negate any warranty.

WARNING: The unit isn’t waterproof. Serious damage

could occur if the unit is exposed to water or spray jets.

WARNING: Installation and conguration of this

instrument should only be carried out by trained and

authorised professionals. See the Flyboxavionics website

for a list of authorised installers.

FLYBOX

Important notice & warnings

REV 1.0 7

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

NOTE: The consumer decides of his own free will if the

purchased product is suitable and safe for his need. If the

consumer does not agree with the notices contained in this

Installation and user Manual, Safety Instructions and Warning

Booklet, do not install this instrument in his aircraft.

NOTE: Flybox Avionics reserves the right to change or improve

its products as well as terms, conditions, and notices under

which their products are oered without prior notice.

NOTE: The Installation and User Manual, Safety Instructions

and Warning Booklet will be updated annually if needed.

All changes or updates will be published on our website www.

yboxavionics.com in the "support" section.

NOTE: Check the website www.yboxavionics.it periodically for

software and manual updates.

NOTE: For some products, registration may be required to

receive important news or information on available rmware

updates or to receive security information.

FLYBOX Index

REV 1.0

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

INDEX

1.1 - Primary action after installation ......................................10

1.2 - Panel indicators and commands ....................................12

1.3 - Instrument conguration .................................................13

1.3.1 - Entering & Browsing the menus ............................ 13

1.3.1.1 - Common items description ............................15

1.3.2 - Main menu ............................................................ 17

1.3.3 - Instruments menu ................................................. 18

1.3.3.1 - Engine RPM ..................................................19

1.3.3.2 - Rotor RPM ....................................................22

1.3.3.3 - MAP ..............................................................24

1.3.3.4 - Oil pressure ...................................................25

1.3.3.5 - Oil temperature .............................................28

1.3.3.6 - Coolant ..........................................................31

1.3.3.7 - CHT ...............................................................33

1.3.3.8 - EGT ...............................................................36

1.3.3.9 - Fuel pressure ................................................39

1.3.3.10 - Fuel levels ...................................................41

1.3.3.11 - Fuel computer ..............................................50

1.3.3.12 - Volt ..............................................................57

1.3.3.13 - Ampere ........................................................59

1.3.3.14 - IAT ...............................................................60

FLYBOX

Index

REV 1.0 9

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

1.3.3.15 - OAT .............................................................62

1.3.3.16 - Warmup dependendencies .........................62

1.3.4 - Conguration ......................................................... 63

1.3.4.1 - Audio .................................................................. 65

1.3.4.2 - Serial port ........................................................... 65

1.3.4.3 - GPS .................................................................... 66

1.3.5 - Backlight ................................................................ 67

1.3.6 - Firmware upgrade ................................................. 68

1.3.7 - Backup & Restore ................................................. 70

1.3.8 - Fuel Computer Activation ...................................... 71

2.0 - Using EngiMaster ...........................................................73

2.1 - Page 1: Engine main data ..............................................74

2.2 - Page 2: Timers ...............................................................79

2.3 - Page 3: Fuel Computer ..................................................81

2.4 - Page 4: Cameras ...........................................................84

3.0 - Alarms ............................................................................85

4.0 - Datalogger ......................................................................86

5.0 - Technical specications ..................................................90

INDEX

FLYBOX Introduction

REV 1.0

EngiMaster - User Manual,

Safety Instructions and Warning Booklet

1.1 - Primary action after installation

WARNING: Do not y until you have performed at least

the actions indicated below:

1. Choose aircraft type: the rst parameter to setup is

the engine selection. It can be made by entering in the

Main menu → Conguration → Aircraft as explained in

chap 1.3.3 Conguration

2. Choose engine model: the rst parameter to setup is

the engine selection. It can be made by entering in the

Main menu → Conguration → Engine as explained in

chap 1.3.3 Conguration

3. Tank level sensors: (if connected). It's indispensable

to perform the calibration for all the tank level sensors

connected to EngiMaster. Without performing

calibration and settings no indication will be furnished.

It is responsibility of the user to check during the rst

ights and over time the goodness of the calibration

and therefore the instrument indications. The

verication can be done in any moment, for example by

simply checking the quantity put to ll the tank: if you

know that the tank lled contain 40 liters and the

EngiMaster indicate as remaining quantity 10.0 liter,

you know that to ll the tank you must put

approximately 30 liters. Of course keeping in mind that

in ground the indications will be dierent that in ight

because of the ight's attitude. This problem is present

also in the traditional analog gauge indicators, but is

more dicult to detect because of the non-numeric

indication. Another verication is, in case of low

remaining quantity (i.e. 4~5 liters), drain and measure

it.

Autres manuels pour EngiMaster

Table des matières

Autres manuels Flybox Instrument de mesure

Flybox

Flybox Omnia57 MAP Manuel utilisateur

Flybox

Flybox Omnia57-80 Series Manuel utilisateur

Flybox

Flybox Omnia57-80 Series Manuel utilisateur

Flybox

Flybox Omnia57-80 Series Manuel utilisateur

Flybox

Flybox Omnia57 ROTOR Manuel utilisateur

Flybox

Flybox Omnia57-80 Series Manuel utilisateur

Flybox

Flybox Omnia57-80 Series Manuel utilisateur

Flybox

Flybox ALT57 Manuel utilisateur

Flybox

Flybox Omnia57 Fuel-P Manuel utilisateur

Flybox

Flybox Omnia57 G-METER Manuel utilisateur

Flybox

Flybox EngiMaster Manuel utilisateur

Flybox

Flybox Omnia57 CHT-EGT Manuel utilisateur

Flybox

Flybox Omnia57 Series Manuel du produit

Flybox

Flybox Omnia57 ALTI-VARIO Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur