Fluidmaster PerforMAX Manuel utilisateur
INSTALL WITH CONFIDENCE
QUICK Install Guide
400H
PerforMAX®FILL VALVE
*See page 23 for important legal information.
Français - Page 16
HOW-TO VIDEO
VISIT: FLUIDMASTER.COM
400H PRODUCT PAGE
VIDEO
2
GETTING STARTED
PARTS OVERVIEW
Locknut
Shank
Washer
Refill Tube
Tank Water Level
Adjustment Screw
Bowl Water Level Dial
Refill Clip
TOP DOWN VIEW
TOOLS NEEDED
SpongeBucket
Towel Scissors
(Optional)
Bowl Water Level Dial
Tank Water Level
Adjustment Screw
3
STEP 1: PREPARE TANK
A: TURN OFF WATER
B: DRAIN WATER
Flush toilet to drain most of the water from the tank.
C: USE SPONGE OR TOWEL TO SOAK UP
EXCESS WATER IN TANK
FLUSH
Towel
Sponge
TURN
CLOCKWISE
4
STEP 2: REMOVE OLD FILL VALVE
LEFT
LEFT
A: REMOVE CONNECTOR
Remove water supply
connector from bottom
of fill valve by twisting
connector nut to the left
(clockwise).
B: REMOVE OLD LOCKNUT
Below tank, twist locknut
to the left (clockwise) to
remove from fill valve.
C: REMOVE OLD FILL VALVE
Including refill tube, refill
clip and shank washer.
Drain any excess water
into bucket by removing
fill valve from tank.
(Pull fill valve up)
Bucket
(Optional)
NOTE: Inspect water
supply connector.
Replace it if it is worn, or
you don’t know how old it is, to
prevent flooding and property damage.
Towel
(Optional)
*Lever Hole
STEP 2: REMOVE OLD FILL VALVE
5
STEP 3: ADJUST HEIGHT OF NEW FILL VALVE
A: TWIST FILL VALVE TO ADJUST HEIGHT
Top of fill valve cap should measure roughly 3"
above top of overflow pipe when installed.
TWIST
LEFT
NOTE:
Increasing height allows
more water to fill in the tank.
HOLD
Do Not Move Lock Ring
*The top of the overflow pipe must be a minimum of 1" below tank lever hole.
TOP OF FILL VALVE CAP
TOP OF OVERFLOW PIPE
3"
Fill Valve Cap
Overflow Pipe
*Lever Hole
6
STEP 4: INSTALL NEW FILL VALVE
D: INSTALL LOCKNUT
Screw locknut to the right
(counterclockwise) onto fill valve shank
(below tank).
*Hand-tighten only. DO NOT OVER TIGHTEN.
A: ATTACH REFILL CLIP TO OTHER
END OF REFILL TUBE
B: INSERT FILL VALVE
Position refill tube to face flush valve
making sure fill valve parts do not
interfere with lever arm.
TOP
DOWN
VIEW
Refill Tube
Lever Arm
Overflow
Pipe
Fill Valve
RIGHT
* Over tightening may crack the fill valve or tank causing flooding. Make sure the float cup
does not touch the tank walls or tank lever and flush valve.
C: ATTACH REFILL CLIP TO
OVERFLOW PIPE
Note: If refill tube is too long to
fit inside tank with lid closed,
remove refill tube from fill valve
refill port, cut tube, and
reattach to port.
Scissors
(Optional)
7
STEP 5: FINISHING STEPS
A: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the right
(counterclockwise)
*Hand-tighten only.
DO NOT OVER TIGHTEN.
RIGHT
B: TURN ON WATER
Check for leaks.
(Go to www.Fluidmaster.com/support
for leak solutions.)
C: WATER LEVEL
After the tank stops filling, water level should fill the tank to
roughly ½ inch below top of overflow pipe to ensure a
proper flush. (Does not need to be exact.)
Over tightening may damage fill valve or coupling nut, potentially causing flooding. Make sure
the float cup does not touch the tank walls or tank lever and flush valve.
** The top of the overflow pipe must be a minimum of 1" below tank lever hole.
Water Level
Overflow Pipe
Top of
Overflow Pipe
1/2"
**Lever Hole
*
TURN
COUNTER-
CLOCKWISE
8
STEP 6: FINE-TUNE TANK WATER LEVEL
A: FLUSH THE TOILET
TO CHECK THE TANK
WATER LEVEL
After the water stops filling the
tank, the water level should be
roughly ½ inch below the top
of overflow pipe to ensure a
proper flush.
B: WATER LEVEL IS TOO LOW
Turn the tank water level adjustment screw
clockwise to raise the float. Flush to reset
water level.
WATER LEVEL IS TOO HIGH
Turn the water level adjustment screw
counterclockwise to lower the float. Flush
to reset water level.
1/2"
Overflow
Pipe
See Step 5C for Full Tank view
Tank Water Level
Adjustment Screw
+
–
9
STEP 7: FINE-TUNE BOWL WATER LEVEL
NOTE: The PerforMAX Fill Valve is pre-set to fill the proper
bowl water level in most toilets straight out of the box.
A: FILL BOWL WITH A GALLON
OF WATER
Wait 1 minute until the bowl water level
recedes down and stops.
B: MARK THE WATER LEVEL IN
THE BOWL
With a pencil, draw a line at the top of
the water level in bowl.
(Pencil mark will easily wash off).
C: FLUSH TOILET TO CHECK BOWL
WATER LEVEL
If the water level matches the line
you’ve made in the bowl when the fill
valve stops filling the tank, the water
level is correct, proceed to Step 8.
TOO HIGH
TOO LOW
If the water level matches the line in the
bowl and the fill valve is STILL FILLING,
then the bowl water is TOO HIGH, proceed
to Step 7D.
If the valve shuts off and the water level does
NOT match the line in the bowl, the water
level is TOO LOW, proceed to Step 7D.
Setting for Most Toilets
10
YOU DID IT!
We knew you could!
Share your success story
with friends and family!
#FixedMyToilet
#Fluidmaster
STEP 7: FINE-TUNE BOWL WATER LEVEL
E: FLUSH TOILET, CHECK BOWL
WATER LEVEL
Repeat Steps 7D and 7E until water
level in bowl matches the line when the
fill valve shuts off.
D: ADJUST THE BOWL WATER LEVEL
IF TOO HIGH: Turn the dial clockwise.
IF TOO LOW: Turn the dial counter-clockwise.
LESS WATER
MORE WATER
Table des matières
Langues :
Autres manuels Fluidmaster Produits de plomberie
Fluidmaster
Fluidmaster PerforMAX K-400H-040 Manuel utilisateur
Fluidmaster
Fluidmaster Flush 550 Feuille d'instructions
Fluidmaster
Fluidmaster 540AKR Manuel utilisateur
Fluidmaster
Fluidmaster EVERYTHING Manuel utilisateur
Fluidmaster
Fluidmaster S2DBL Manuel utilisateur
Fluidmaster
Fluidmaster BETTER THAN WAX 7530 Manuel utilisateur
Fluidmaster
Fluidmaster PRO Series Manuel utilisateur
Fluidmaster
Fluidmaster K-507A-008 Manuel utilisateur
Fluidmaster
Fluidmaster Delchem Dualflush Manuel utilisateur
Fluidmaster
Fluidmaster MONACO 1000A-002 Manuel utilisateur
Fluidmaster
Fluidmaster PerforMAX K-400H-001 Manuel utilisateur
Fluidmaster
Fluidmaster FILL 747 3/8 Manuel utilisateur
Fluidmaster
Fluidmaster K-400H-039 Manuel utilisateur
Fluidmaster
Fluidmaster FILL 400 3/8" Manuel utilisateur
Fluidmaster
Fluidmaster MANSFIELD Manuel utilisateur
Fluidmaster
Fluidmaster PerforMAX K-400H-5002 Manuel utilisateur
