FLIR Scout Manuel utilisateur

431-TS00-02-QS Rev 110 June 2012

Scout Quick Start Guide

Power Button – The Scout camera has 3 power modes:

On, Off, and Standby.

• On - Takes approximately 90 seconds (during bootup there is a

fast-flashing red LED on the eyepiece display).

• Standby - After the camera is on, pressing the Power button will

toggle the camera between On and Standby mode. (In Standby

there is a slow-flashing red LED on the eyepiece display.)

• Off - Push and hold the power button for 8 sec. to turn off.

Capture Button – When enabled, takes snapshots (press and

release) or video clips (press and hold 3 seconds to start video

recording). The files are stored on the integrated SD card..

Display Brightness – Toggle through five brightness settings.

White/Black Hot/Instalert – In White Hot, hotter items appear

as white or light grey. In the Black Hot, hotter items appear as black

or dark grey. In Instalert, hot items in a scene are outlined in red.

2× Zoom – When enabled, causes the image to zoom to 2X.

Diopter Controls – The diopter adjustment knob allows a ±2

diopter range.

PowerCapture2x zoom

White hot/

Display

Black hot/

Adjustable

diopter ±2

Eyepiece

Lens cap

Brightness

Instalert

431-TS00-00-QS Scout Quick Start Guide.fm Page 1 Saturday, June 2, 2012 4:12 PM

431-TS00-02-QS Rev 110 June 2012

Installing the Batteries and SD Card

The batteries must be installed and charged before using your

camera. Install your SD card.

1. Remove the small SD card

cover.

No tools are required.

2. Install the SD card.

3. Loosen the four captive screws

securing the battery cover.

4. Pry off the battery cover by

grasping the front edge where the

SD card cover was removed.

5. Install the batteries as shown.

6. Snap the SD card cover back

into place and re-install the battery

cover—it only fits one way.

Charging the Camera

The batteries in the camera must be charged prior to their first

use.

1. Connect the Hot Shoe to your

camera.

2. Ensure that the plug is fully

seated in the Hot Shoe.

When charging correctly, the

charging indicator will be lit

yellow and will blink green for one

second within about 35 seconds.

The charging indicator will

continue to blink at decreasing

intervals until the batteries are

fully charged.

When fully charged, the charging

indicator will be lit solid green.

The initial charge time is

approximately 4 hours.

www.flir.com

Grasp SD card

Battery

cover

cover edges

and pull

–

Plug from power adapter

Charging

indicator

Solid

green

431-TS00-00-QS Scout Quick Start Guide.fm Page 2 Saturday, June 2, 2012 4:12 PM

Autres manuels pour Scout

Table des matières

Autres manuels FLIR Caméra thermographique

FLIR

FLIR T865 Manuel utilisateur

FLIR

FLIR FlashSight Manuel utilisateur

FLIR

FLIR ThermaCAM P65 Manuel utilisateur

FLIR

FLIR ix Series Manuel utilisateur

FLIR

FLIR E6-XT Manuel utilisateur

FLIR

FLIR T560-42 Manuel utilisateur

FLIR

FLIR T8 Series Manuel utilisateur

FLIR

FLIR T6 series Manuel utilisateur

FLIR

FLIR EX Series Manuel utilisateur

FLIR

FLIR E4 Manuel d'instructions

FLIR

FLIR Exx series Manuel utilisateur

FLIR

FLIR ThermaCAM P20 Manuel utilisateur

FLIR

FLIR Scout TS32r Pro Manuel utilisateur

FLIR

FLIR K2 Manuel utilisateur

FLIR

FLIR GF300 Manuel utilisateur

FLIR

FLIR E4 Manuel utilisateur

FLIR

FLIR T560 Manuel utilisateur

FLIR

FLIR T4 Series Manuel utilisateur

FLIR

FLIR EX Series Manuel utilisateur

FLIR

FLIR A3 PT series Manuel utilisateur

FLIR

FLIR ThermaCAM EX300 Manuel utilisateur

FLIR

FLIR A300f Manuel utilisateur

FLIR

FLIR Ax5 series Manuel utilisateur

FLIR

FLIR SCOUT II Manuel utilisateur

Manuels Caméra thermographique populaires d'autres marques

Hikmicro

Hikmicro HM-TD3117T-1/Q Manuel utilisateur

optris

optris PI 160 Manuel utilisateur

Perfect Prime

Perfect Prime IR0001 Manuel utilisateur

InfraTec

InfraTec InfraTec Manuel utilisateur

ICI

ICI 8000 Series Manuel utilisateur

Hikmicro

Hikmicro BX20 Manuel utilisateur

ICI

ICI SOUND DETECT Manuel utilisateur

Perfect Prime

Perfect Prime IR0175 Manuel utilisateur

HT THT80 Manuel utilisateur

ICI

ICI TRACE IR 25 Series Manuel utilisateur

Qvis

Qvis PX-SDH2010 Manuel utilisateur

WORKSWELL

WORKSWELL GIS 320 Manuel utilisateur

InfraTec

InfraTec VarioCAM Manuel utilisateur

Eneo

Eneo VKC-1327C Manuel utilisateur

ITS Telecom

ITS Telecom TC-1 Manuel utilisateur

ICI

ICI I-CAM 380 Series Manuel utilisateur

MRC

MRC IR-CAM-160 Manuel utilisateur

Process Sensors

Process Sensors 160 Manuel utilisateur