Flight Display Systems FD104SMT Manuel utilisateur

Rev:

Revision Date:

09/04/2012

Page 1 of 16

MAN –FD104SMT

FD104SMT

Installation and Operation Manual

10.4” LCD and Slide Mount

Manufactured by MILIC, LLC with marketing support from Flight Display Systems.

This product does not have FAA PMA approval.

TECHNICAL SUPPORT

+1 (678) 867-6717, or

www.FlightDisplay.com

All manuals and user guides at all-guides.com

all-guides.com

Rev:

Revision Date:

09/04/2012

Page 2 of 16

MAN –FD104SMT

FD104SMT

10.4" LCD and Slide Mount

Flight Display Systems

1765 Grassland Parkway

Alpharetta, GA 30004

+1 (678) 867-6717 Phone

+1 (678) 867-6742 Fax

sales@flightdisplay.com

www.flightdisplay.com

For the most current copy of all product manuals, please visit our website at

www.flightdisplay.com

For more product support information, please visit the following link at

http://support.flightdisplay.com/

All manuals and user guides at all-guides.com

Rev:

Revision Date:

09/04/2012

Page 3 of 16

MAN –FD104SMT

Table of Contents

General Information......................................................................................................................4

1. Front View..........................................................................................................................4

2. Additional information ....................................................................................................4

Specifications................................................................................................................................5

Installation Instructions .............................................................................................................5

1. Power ..................................................................................................................................5

Wiring Suggestions .....................................................................................................................6

1. S-Video/Comp and Audio Wiring.................................................................................6

2. VGA Wiring.......................................................................................................................7

3. Power and Ground Wiring..............................................................................................8

Power/Video..................................................................................................................................9

1. Pinout DB-15......................................................................................................................9

Operation Instructions..............................................................................................................10

1. Buttons..............................................................................................................................10

2. Remote Control Buttons.................................................................................................11

Technical Drawing.....................................................................................................................12

Troubleshooting.........................................................................................................................13

Technical Support......................................................................................................................14

Instructions for Continued Airworthiness ...........................................................................14

Warranty ......................................................................................................................................15

Log of Revisions.........................................................................................................................16

All manuals and user guides at all-guides.com

Rev:

Revision Date:

09/04/2012

Page 4 of 16

MAN –FD104SMT

General Information

The FD104SMT is a 10.4" LCD and Slide Mount which has features that allow

installation in the smallest of mounting areas with the minimum of interface equipment.

Built with retrofit aircraft integration in mind, this display can switch between three

video input sources using an infrared remote.

Front View

Additional Information

The FD104SMT, an integral part of the FD104SMT, utilizes a state of the art digital

video decoding chipset for the analog video input. The three video sources in order of

picture quality are VGA (computer graphics like moving maps), S-Video and

Composite Video (DVD, camera or VCR).

The FD104SMT can also be connected to existing video switchers and just take a

composite video input from a selector interface box. In this case multiple input sources

can be selected and displayed on the monitor.

The FD104SMT is visible to passengers when deployed, and is offered in a Left or

Right configuration. The FD104SMT-Lis mounted on the Left side of the bulkhead, to

extend to the right into the aisle, while the FD104SMT-Ris installed on the Right side

of the bulkhead, extending to the left into the aisle.

When the monitor is stowed a latching mechanism automatically engages. To deploy

the monitor for viewing, depress the latch release button above the front handle and

slide out.

All manuals and user guides at all-guides.com

Rev:

Revision Date:

09/04/2012

Page 5 of 16

MAN –FD104SMT

Specifications

Display Type

10.4” TFT Color LCD

Display Color

262,144 Colors

Screen Resolution

1024x768 (1280x768 supported)

Brightness

700 cd/m²

Display Size

8.24”(W) x 6.2” (H)

Weight

10.0 lbs

Power

28VDC @ 1.0 Amp

Video Inputs Supported

Composite Video, S-Video

Video Types Supported

NTSC/PAL

Screen control

On-Screen Display Menu

Remote Control

IR, included

Materials

Aluminum

DO-160E testing

Section 21 Category B

Dimensions Stowed

13.10”(W) x 11.25” (H) x 2.5” (D)

Dimensions Deployed

24.7”(W) x 11.25” (H) x 2.5” (D)

Slide Mount Type

Retractable –Enclosed Dual Slide Rail

Mechanism

Installation Instructions

All cabin entertainment equipment, such as the FD104SMT, should be installed on a

non-essential bus and have a dedicated circuit breaker. It is a requirement that a

switch be installed in the cockpit so that the pilot can de-energize the entertainment

system should it become necessary.

The FD104SMT is integrated with a rugged slide mount bracket. Usually the

FD104SMT is mounted against a bulkhead behind a seat, exposed to the interior. The

FD104SMT is secured by four #10 machine screws. The monitor locks into place when

stowed and held in place by a gas spring when deployed.

There is one DB-15 male connector on the back of the unit. The FD104SMT comes

with a female DB-15 connector and crimp pins. The FD104SMT has already been

connected to the slide mount and tested prior to shipping.

Power

This is a 28VDC monitor that requires 1.0 amp of power to operate. The unit turns on

automatically upon power application.

All manuals and user guides at all-guides.com

Rev:

Revision Date:

09/04/2012

Page 6 of 16

MAN –FD104SMT

Wiring Suggestions

All shields should be grounded to the connector at the source, and floating at the

display.

Avoid routing video wiring parallel to:

AC wiring

Strobe wiring

DC motor supply cables

Inverter cabling

Or any other potential noise source

S-Video/Composite and Audio Wiring

Recommended cable for s-video/composite and audio purposes is PIC 75 Ohm Coax,

P/N V75268. This is a lightweight, flexible, and low signal loss cable which meets FAA

flammability requirements of FAR 23.1359(d), FAR 25.853(a) and FAR 25.869(a)(4).

Similar aviation coaxial cable can be used from other vendors, as well.

Some aircraft are prone to AC noise - we recommend adding to the composite source

a 75Ohm video isolation transformer such as Deerfield Laboratory, Inc. Part No. 162-1

(www.deerfieldlab.com, (650) 632-4090). In most cases this should be added to the

video output of the source.

All manuals and user guides at all-guides.com

all-guides.com

Rev:

Revision Date:

09/04/2012

Page 7 of 16

MAN –FD104SMT

VGA Wiring

Recommended cable for VGA purpose is ECS P/N 453005. This is a single shielded

cable containing 5 separate coaxial cables, color-coded to match the functions of the

wires.

We recommend coax cables be terminated using solder sleeve coaxial cable

terminators such as Raychem Part Number CWT-4174-W122-5/9.

All manuals and user guides at all-guides.com

Rev:

Revision Date:

09/04/2012

Page 8 of 16

MAN –FD104SMT

Power and Ground Wiring

This is a 28VDC monitor that requires 1 amp of power to operate. To operate properly

this monitor requires an input voltage of 18-29VDC.

The rated current of the equipment and associated voltage drop should be taken into

consideration when selecting wire gauge. The following example is based on an install

with a 28VDC power system and a total of 50 feet of wire between the circuit breaker,

monitor and ground.

Example: 22awg wire has 16.2 Ohms per 1000 feet, this equates to .81 Ohms for 50

feet. 1 Amp of current on .81 Ohms will drop .81 Volts.

Resistance of Wire Type M22759/16-**

(** = Gauge)

Gauge (AWG)

OHMS/1000’

26.20

16.20

9.88

4.81

2.02

1.26

.701

Also, use short heavy gauge wire and a clean tight connection for ground.

It is the installer's responsibility to understand the product's requirements to install the

product in compliance with industry standards and safety.

All manuals and user guides at all-guides.com

Rev:

Revision Date:

09/04/2012

Page 9 of 16

MAN –FD104SMT

Power/Video

Pin out for High Density DB-15 Receptacle

Part Numbers for DB-15 connectors, manufactured by Tyco or Amp.

High density, D-sub, 15 contact receptacle (female) P/N 748565-1

HD15F pins P/N M39029/57-354

Pin Number

Description

28VDC Power

28VDC Ground

Composite Video –Signal

Composite Video –Shield

S-Video Y –Signal

S-Video Y –Shield

S-Video C –Signal

S-Video C –Shield

Red Video (Pin 1 on Standard VGA)

Green Video (Pin 2 on Standard VGA)

Blue Video (Pin 3 on Standard VGA)

Red Ground (Pin 6 on Standard VGA)

Green Ground (Pin 7 on Standard VGA)

Horizontal Sync (Pin 13 on Standard VGA)

Vertical Sync (Pin 14 on Standard VGA)

All manuals and user guides at all-guides.com

Rev:

Revision Date:

09/04/2012

Page 10 of 16

MAN –FD104SMT

Operation Instructions

The FD104SMT is continuously on but can be de-energized by removing power from

the entertainment system. No pilot or aircrew action is necessary during flight or

ground operation. It is necessary to stow the display during take-off and landing.

The passengers will be able to change the video output on the FD104SMT using the

video source select button on the display, or remotely throughout the cabin with the

included IR remote. Point the IR remote at the top of the LCD to make changes.

When applying 28VDC power, the display will turn on and look for a valid input on the

last known source. If no input is found, the display will go to standby mode. Pressing

the Select button will select new video input.

Button

Located at the top of the FD104CV LCD are seven buttons.

Operations are as follows (From Right to Left):

BUTTON

DESCRIPTION

Power

Used to turn the unit on or off.

(LED)

Right

Used to move through the menu options.

Left

Used to move through the menu options.

Used to increase the adjustment of a menu option.

Down

Used to decrease the adjustment of a menu option.

Select

Used to select the input signal source.

Used to change the configuration of the picture

settings (Backlight, Brightness, Contrast, Saturation,

Hue, etc.)

All manuals and user guides at all-guides.com

Table des matières

Autres manuels Flight Display Systems Support et étagère

Flight Display Systems

Flight Display Systems FD171DMT Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur