1) Power Port 6) USB 3.0 Ports
2) Serial Console Port 7) IPMI Port
3) Video Port 8) pether3 (RJ45) SMTP interface Port
4) ether2/pether2 (RJ45) live mode analysis 9) pether4 (RJ45) SMTP interface Port
5) ether1 (RJ45) Management 1 Port 10) SFP+ Ports (Disabled)
Power Port
lPower: Connect your power source to this port to provide power to the appliance.
The appliance comes with one redundant power supply unit for use if the primary
unit fails.
I/O Ports
lSerial Console: Connect to this port to manage the appliance from your terminal.
lVideo: Connect a monitor to this port to view the appliance's command-line
interface.
lUSB 3.0: These ports are USB 3.0 compliant.
Management Ports
lether (RJ45): Connect your LAN to this port to enable remote access to the CLI and
Web UI. The RJ45 connector is a 10/100/1000BASE-T port.
lIPMI: Connect for access to out-of-band management functions, including power
control, console redirection, and appliance health status. The connector is a
100BASE-T port.
IMPORTANT: The IPMI interface port is only enabled in CM Release 8.2.0 or
later and IPMI firmware version 2.07 or earlier.
Monitoring Ports
Each interface pair is physically and logically segregated from other interface pairs,
preventing communication between the different network segments.
FX Series Hardware Administration Guide CHAPTER 1: The FX 6500
7 ©2019 FireEye
