3.2 Normal operation
- Use the float switch in its intended application only.
- Comply with the specifications
- If the controller is damaged, disconnect it immediately.
- It is forbidden to make changes to the device. This violates the
Normative.
3.3 Inexpert handling
- Ignoring the Safety instructions and the Operating instructions.
- Not intended use.
- Making changes or handling the float switch.
- Violation against applicable Law and Standards.
- Using of non original parts.
4. Maintenance, servicing and spare parts
4.1 Maintenance
- If used correctly, no specific maintenance is required.
4.2 Servicing
- Check and review the state of the switch, the cable, the float, the
mechanical stops, the counterweight and the correct commutation
of the electrical contact, as well.
4.3 Spare parts
- Use only original parts.
- The spare parts of the controllers are the cable, the float, the
counterweight and the mechanical stops.
5. Storage
- Store the controller in a dry and dust-free environment.
6. Disposal
-
- The controller can be recycled.
- The disposal applies to the valid environmental Guidelines
according to the location of the carrier and the local
manufacturing conditions.
on the data plate and the technical
data of this manual.
Switch off the power supply, before disconnecting the device.
2. Installation
-
- Verify if you have got all the parts:
•Housing.
•Float.
•Counterweight, cable and mechanical stops.
- The controller has to be mounted in a way that the incoming
liquid does not hit the float and does not make turbulence in its
side.
It is simple: the float must be vertically installed on the top of the
tank with an appropiate support to fix it. The tank can have a cap
to preserve the liquid against dust. Just a little hole in the cap
allows the free movement of the cable.
- Fasten the cable gland after making the electrical connection.
- Fix and fasten the screw nut of the cable gland to make sure of
the water-tightness.
3. Use
3.1 Commissioning
- Put the controller into operation only if the installation and the
electrical connection have been done correctly.
2.1 Preparing for use
Read the Safety Instructions and the Operation Instructions
before using the controller.
2.2 Mechanical connection
2.3 Electrical connection
Connection diagram
Cable gland
FILSA constantly strives to improve its products and reserves the right to modify designs, materials and data without prior notice.
Keep this manual for further questions!
B-1
04
Talleres Filsa, S.A.U. www.filsa.es• • • • •E-08100 Mollet del Vallès (Barcelona) Tel. +34 93 570 46 01 Fax +34 93 570 24 71 [email protected] 05/14 MI-B1-EN-04© by FILSA
Emptying Filling
B1-002
2
1
4
3
2
1
4
3
