Manual
SLUGGUARD®
Manual SLUGGUARD® Revision 6
3
2. Introduction
For secure and error-free operation of the device, these operating instructions must be read with care before
commissioning and kept at a site well accessible for the operator/s.
Should further questions arise after the lecture of these operating instructions please do not hesitate to contact our
sales representatives.
3. Intended Use
The SLUGGUARD
®
bulk water sensor is designed for the detection of bulk quantity of free water in running aviation
fuel or for the distinction of media (fuel / water) in low points of filter water separators or in drain points of filter
vessels. The manufacturer is not liable for damages caused by improper or non-intended use of the device.
4. Safety Instructions
This manual provides operation and routine maintenance instructions for the FAUDI Aviation SLUGGUARD
®
.
Read this manual and ensure that you fully understand its content before you attempt to install, use or maintain
the SLUGGUARD
®
.
Work on electrical equipment is to be conducted by trained specialists only, according to valid regulations.
Attention must be paid to the requirements of VDE 1 when setting up high-power electrical units with nominal
voltages of up to 1 V, including associated standards and stipulations.
Check the details on the type plate to ensure that the equipment is connected to the correct
mains voltage.
Protect against touching dangerously high electrical voltages. Opening the equipment is strictly prohibited.
The equipment is only to be used within the permitted temperature and operation ranges (see Chapter 1 ).
All CHANGEs of the SLUGGUARD
®
with parts which are not specified or approved by FAUDI Aviation GmbH, as well as
repair and service with unspecified parts will result in loss of the CE conformity and guarantee.
In case of doubt, please turn directly to FAUDI Aviation GmbH, respectively to your FAUDI Aviation Distributor or
Service organization.
Danger, safety, prohibition and risk notes in this manual must be complied with under all
circumstances!
4.1 Operational Safety
The SLUGGUARD® is designed and tested according to the state of the art and left the factory in perfect functioning
order. Relevant regulations and european standards have been met.
As the user, you are responsable for complying with the following safety conditions:
-Installation instructions
-Local prevailing standards and regulations
