Extron electronics SW USB Pro Series Manuel utilisateur

User Guide

SW USB Pro Series

Switchers

USB Switchers

68-3537-01 Rev. A

01 22



Trademarks

All trademarks mentioned in this guide are the properties of their respective owners.

The following registered trademarks (®), registered service marks (SM), and trademarks (TM) are the property of RGBSystems, Inc. or Extron (see the

current list of trademarks on the Terms of Use page at www.extron.com):

Registered Trademarks (®)

Extron, Cable Cubby, ControlScript, CrossPoint, DTP, eBUS, EDID Manager, EDID Minder, eLink, Flat Field, FlexOS, Glitch Free, GlobalConfigurator,

GlobalScripter, GlobalViewer, Hideaway, HyperLane, IPIntercom, IPLink, KeyMinder, LinkLicense, LockIt, MediaLink, MediaPort, NAV,

NetPA, PlenumVault, PoleVault, PowerCage, PURE3, Quantum, ShareLink, Show Me, SoundField, SpeedMount, SpeedSwitch, StudioStation,

SystemINTEGRATOR, TeamWork, TouchLink, V‑Lock, VN‑Matrix, VoiceLift, WallVault, WindoWall, XPA, XTP, XTPSystems, and ZipClip

Registered Service Mark(SM) : S3 Service Support Solutions

Trademarks (™)

AAP, AFL (Accu‑RATEFrameLock), ADSP(Advanced Digital Sync Processing), AVEdge, CableCover, CDRS(ClassD Ripple Suppression),

CodecConnect, DDSP(Digital Display Sync Processing), DMI (DynamicMotionInterpolation), DriverConfigurator, DSPConfigurator, DSVP(Digital

Sync Validation Processing), EQIP, Everlast, FastBite, Flex55, FOX, FOXBOX, IP Intercom HelpDesk, MAAP, MicroDigital, Opti‑Torque,

PendantConnect, ProDSP, QS‑FPC(QuickSwitch Front Panel Controller), RoomAgent, Scope‑Trigger, SIS, SimpleInstructionSet, Skew‑Free,

SpeedNav, Triple‑Action Switching, True4K, True8K, Vector™ 4K, WebShare, XTRA, and ZipCaddy

FCC Class A Notice

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part15 of the FCC rules. The ClassA limits provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is

likely to cause interference. This interference must be corrected at the expense of the user.

NOTE: For more information on safety guidelines, regulatory compliances, EMI/EMF

compatibility, accessibility, and related topics, see the Extron Safety and Regulatory

Compliance Guide on the Extron website.

VCCI-A Notice

Conventions Used in this Guide

Notifications

The following notifications are used in this guide:

CAUTION: Risk of minor personal injury.

ATTENTION : Risque de blessuremineure.

ATTENTION:

• Risk of property damage.

• Risque de dommages matériels.

NOTE: A note draws attention to important information.

Software Commands

Commands are written in the fonts shown here:

^AR Merge Scene,,0p1 scene 1,1 ^B 51 ^W^C.0

[01] R 0004 00300 00400 00800 00600 [02] 35 [17] [03]

E X! *X1&*X2)*X2#*X2! CE}

NOTE: For commands and examples of computer or device responses used in this

guide, the character “0” is the number zero and “O” is the capital letter “o.”

Computer responses and directory paths that do not have variables are written in the font

shown here:

Reply from 208.132.180.48: bytes=32 times=2ms TTL=32

C:\Program Files\Extron

Variables are written in slanted form as shown here:

ping xxx.xxx.xxx.xxx —t

SOH R Data STX Command ETB ETX

Selectable items, such as menu names, menu options, buttons, tabs, and field names are

written in the font shown here:

From the File menu, select New.

Click the OK button.

Specifications Availability

Product specifications are available on the Extron website, www.extron.com.

Extron Glossary of Terms

A glossary of terms is available at https://www.extron.com/technology/glossary.aspx.

SW USB Pro Series • Contents vii

Contents

Introduction ................................................ 1

About this Guide.................................................. 1

About the SW USB Pro Series............................. 1

Features .............................................................. 1

USB System Architecture .................................... 2

Application Diagrams........................................... 4

Installation .................................................. 5

Installation Overview ............................................ 5

Rear Panel Features ............................................ 6

Wiring the Power Connector................................ 8

Wiring for RS-232 Communication ...................... 9

Connecting Multiple SW USB Pro Switchers in

a System.......................................................... 10

Operation.................................................. 11

Front Panel Features.......................................... 11

Powering on the System.................................... 12

Selecting an Input (Host).................................... 13

Selecting a Host from the Front Panel ........... 13

Selecting a Host Using SIS Commands......... 13

Selecting a Host Using the Keyboard (Hot

Key Switching).............................................. 13

Auto Switching .............................................. 14

Locking and Unlocking the Front Panel

(Executive Mode).............................................. 14

Emulations......................................................... 15

Peripheral Emulation...................................... 15

Host Emulation .............................................. 15

Resetting........................................................... 16

Troubleshooting................................................. 17

Updating Firmware ............................................ 17

Remote Conﬁguration and Control............. 18

Host-to-Switcher Communications.................... 18

Connecting the Switcher to the Host ............. 18

Switcher-initiated Messages .......................... 19

Error Codes .................................................. 19

Using the Command and Response Table......... 19

Symbol Definitions ......................................... 20

Command and Response Table for SIS

Commands ...................................................... 22

Accessing the Product Conﬁguration

Software........................................................... 27

Downloading and Installing PCS .................... 27

Starting PCS.................................................. 30

Internal Web Page..................................... 31

Accessing the Web Page................................... 31

Web Page Overview .......................................... 32

Device Info Panel........................................... 32

Firmware Panel.............................................. 32

Device Status Panel....................................... 33

Roles and Permissions Panel......................... 35

Reference Information............................... 38

Mounting the SW USB Pro Series Switcher ....... 38

Tabletop Use ................................................. 38

UL Rack Mounting Guidelines........................ 38

Furniture Mounting......................................... 39

SW USB Pro Series • Contents viii

SW USB Pro Series • Introduction 1

Introduction

This section gives an overview of the Extron SW USB Pro Series switchers. Topics include:

• About this Guide

• The SW USB Pro Series Switchers

• Features

• USB System Architecture

• Application Diagrams

About this Guide

This guide provides instructions on installing, configuring, and operating the Extron SW2

USB Pro and the SW4 USB Pro Series switchers and them. The terms “SW USB Pro” and

“switcher” are used throughout this guide to refer to all models.

The SW USB Pro Series Switchers

The SW USB Pro Series are two- and four-input USB switchers that allow for two or four

host computers to switch among up to four peripheral USB devices (such as mass storage

devices, keyboards, mice, and other human interface devices [HIDs]) with data rates up to

10 Gbps. The switchers act as active USB hubs, supplying power to attached devices. In

addition, the switchers are USB 3.2 compatible, including SuperSpeed USB 5 Gbps and

10 Gbps, and are backward-compatible with all previous USB data rate specifications.

The series consists of four models:

• SW2 USB Pro

• SW4 USB Pro

• SW2 USB Pro Non-LAN

• SW4 USB Pro Non-LAN

The non-LAN models are identical to the standard models except that they do not contain

LAN ports. Ethernet functionality is available via IP over USB (see Ethernet over USB

starting on page18 for more information).

Features

A number of specialized features help to streamline system integration, including port status

indication, front panel security lockout, and multiple control points.

• Outputs — One female USB-C and three female USB Type A connectors.

• SuperSpeed USB 10G compatible — Supports newer USB 3.2 speed devices and is

backwards compatible with all prior USB versions.

• Hot Key, Auto, and manual switching capability — Provides multiple ways to

switch between hosts to ensure easy integration and control for many AV environments.

SW USB Pro Series • Introduction 2

• Four port output hub with USB‑C and Type A connections — Enables

simultaneous connection to multiple peripheral devices with USB-C or Type A

connections such as mass storage devices, keyboards, mice, or other Human Interface

Devices (HIDs).

• Supports selectable Host and Peripheral emulation — Emulates uninterrupted

connection between host, keyboard, and mouse devices. This feature enables devices

to remain functional when switching between inputs.

• Front panel selection buttons and status indicators — Facilitates easy control and

troubleshooting from front panel.

• Built‑in web pages — Enables the use of a standard browser for device monitoring

and troubleshooting over an intuitive web interface.

• Ethernet and RS‑232 control options — Provides multiple control options for pro AV

environments.

• Front panel security lockout — Prevents unauthorized use in non-secure

environments. In lockout mode, a special button combination is required to operate the

switcher from the front panel.

• Rack‑mountable, 1U half rack width metal enclosure

• External Extron Everlast power supply included — Provides worldwide power

compatibility with high-demonstrated reliability and low power consumption.

• Extron Everlast Power Supply is covered by a 7‑year parts and labor warranty

USB System Architecture

A USB system architecture refers to the physical bus topology of USB devices connected

to a host device. USB devices include USB hubs, USB peripheral devices, or compound

devices (devices with a combination of USB hubs and USB peripheral devices built into it).

The system is organized in a tiered star topology to prevent multiple or circular attachments

to the bus. Each tier represents a degree of separation from the host device. Per USB

specifications, there are seven supported tiers, starting with the host device (or root hub)

occupying the first tier.

NOTE: Do not connect more than five daisy-chained hubs to the root hub. The

architecture does not support peripheral devices connected to USB hubs occupying

the seventh tier.

Autres manuels pour SW USB Pro Series

Table des matières

Autres manuels Extron electronics Changer

Extron electronics

Extron electronics IN1804 Series Manuel utilisateur

Extron electronics

Extron electronics SW2 VGA DA2 AF R Manuel utilisateur

Extron electronics

Extron electronics FOX T USW 203 Manuel utilisateur

Extron electronics

Extron electronics SW AV Manuel utilisateur

Extron electronics

Extron electronics MMX 62 AV RCA Manuel utilisateur

Extron electronics

Extron electronics SW8/12 Manuel utilisateur

Extron electronics

Extron electronics YCS SW6 MX Manuel utilisateur

Extron electronics

Extron electronics ISM 824 Manuel utilisateur

Extron electronics

Extron electronics Extron SW 2 VGAcc Manuel utilisateur

Extron electronics

Extron electronics SW2 ARxi Manuel utilisateur

Extron electronics

Extron electronics SW AV Series Manuel utilisateur

Extron electronics

Extron electronics TeamWork 601 Manuel utilisateur

Extron electronics

Extron electronics PVS 407D Manuel utilisateur

Extron electronics

Extron electronics MPS 601 Manuel utilisateur

Extron electronics

Extron electronics VEGA AUDIO SW6 Manuel utilisateur

Extron electronics

Extron electronics System 5 IP Series Manuel utilisateur

Extron electronics

Extron electronics SW 2 RGB Manuel utilisateur

Extron electronics

Extron electronics MLS 406 Series Manuel utilisateur

Extron electronics

Extron electronics SW12 VGA Ars Manuel utilisateur

Extron electronics

Extron electronics PoleVault PVS 204SA Manuel utilisateur

Extron electronics

Extron electronics MTPX Plus Series Manuel utilisateur

Extron electronics

Extron electronics SW6 HDMI Manuel utilisateur

Extron electronics

Extron electronics MMX 42 Series Manuel utilisateur

Extron electronics

Extron electronics MLS 100 A Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur