Extron electronics SW DVI Plus Series Manuel utilisateur

Setup Guide — SW DVI Plus Series

This guide provides basic instructions for setting up and

operating the Extron SW DVI Plus and SW DVI A Plus

Series switchers.

Installation

Step 1 — Mount the unit

Turn off or disconnect all equipment power sources and mount the switcher as required.

Step 2 — Connect video inputs

Connect source devices to one or more DVI video input connectors.

Only single-link DVI-D signals are supported. If necessary, set the

equalization DIP switches for each input to High (up) to compensate

for a weak signal, or to Low (down), if all signals are strong.

N These connectors are not compatible with HDCP signals.

Step 3 — Connect video outputs

Connect a DVI-D display device to the DVI-I video output connector.

Step 4 — Connect audio inputs (SW DVI A Plus models

only)

Plug the input devices’ audio connectors into the 3.5 mm TRS audio

input jacks for unbalanced audio. See the wiring diagram at right.

Step 5 — Connect audio outputs (SW DVI A Plus models only)

Connect the switcher’s audio output to a suitable audio device. Wire the 5-pole connector as

shown below.

Step 6 — Enable auto switching (optional)

SW2 and SW4 DVI Plus (non-audio) models:

Enter one of the following Simple Instruction Set (SIS™)

commands via the RS-232 interface:

• 2#, to select auto switch mode

• 1#, to select normal switch mode

For explanations of all SIS commands, refer to chapter 4

of the SW DVI Plus Series User’s Manual.

All other models:

Use a jumper wire to connect pins 4 and 5 of one of the

provided 5-pin captive screw plugs. Insert the plug into the

Remote/Auto-SW shared connector as shown at right. (Continued on reverse side)

AUTO

SWITCH

ACTIVE

IR 1 2 3 4 INPUT

HIGH

LOW

2 3 4

1 2 3 4

SIGNAL

PRESENCE

1 2 3 4

SW4 DVI Plus SERIES

17 24

Sleeve ( )

Ring

(R)+

Tip (L)+

CAUTION

For unbalanced audio, connect

the sleeve(s) to the ground contact.

DO NOT connect the sleeve(s)

to the negative (-) contacts.

Tip

Ring

Tip

Ring

L R

Do not tin the wires!

Tip

NO Ground Here

Sleeve(s)

NO Ground Here

Tip

L R

Sleeve(s)

Balanced Audio Output Unbalanced Audio Output

SW8 DVI A PLUS

DVI-D / AUDIO

OUTPUT

Tx Rx A S

REMOTE / AUTO-SW

L R

Setup Guide — SW DVI Plus Series, cont’d

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517 FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

www.extron.com

Step 7 — Connect RS-232

• SW2 and SW4 DVI Plus (non-audio) models: Connect an RS-232 cable

from your computer to this female 9-pin D connector. Protocol for this

port is 9600 baud, 8 data bits, 1 stop bit, no parity. Wire the connector as

follows: pin 2 = Tx, pin 3 = Rx, pin 5 = Gnd.

• All other models:

Connect a bare wire-to-female

9-pin D RS-232 cable to pins 1, 2,

and 3 of one of the 5-pole captive

screw plugs. Insert the plug into

the Remote/Auto-SW shared

connector, and connect the cable to

the computer’s serial port. See the

illustration at right.

Step 8 — Wire power

connector

If using a different 12 V, 1 A external

power supply from the one that is

included (already wired), attach the

provided two-pole captive screw

connector to the power supply as

shown below.

Step 9 — Power on

a. Power on the output display.

b. Apply power to the switcher.

c. Power on the input devices.

Application Diagram

The ﬁgure at right provides an

example of how an SW8 DVI Plus

switcher may be connected.

Captive Screw Connector

Tie Wrap

Heat

Shrink 1/8”

(3 mm)

7/8”

(22 mm)

3/16”

(5 mm) Max.

9 6

245 6 78

0.4A MAX

POWER

12V

SW8 DVI A PLUS

DVI-D / AUDIO

OUTPUT

DVI / AUDIO INPUTS

Tx Rx A S

REMOTE / AUTO-SW

L R

100-240V 0.5A, 50-60Hz

VOL/MUTE

STANDBY

CLASS 2 WIRING

LISTED 17TT

AUDIO/VIDEO

APPARATUS

XPA 1002

CUS

LEVEL

1 2

LIMITER/

PROTECT

SIGNAL

INPUTS OUTPUT

REMOTE

10V 50 mA

PC with DVI Out

Extron SI 26

Two Way

Surface Mount

Speakers

Extron

XPA 1002

Power Amplier

Laptop with DVI Out

PC with DVI Out

Extron

SW8 DVI A Plus

DVI Switcher

with Audio

Projector with DVI In

Control

System

Audio

RS-232

68-1316-50

Rev. C

09 09

If you use cable that has a drain

wire, tie the drain wire to ground

at both ends.

Remote/Auto-SW

To Computer or

Control System

RS-232 Port

SW DVI Plus Switcher

Rear Ranel RS-232 Port

Tx Rx

A S

9 pin HD

Connector

Ground

Green

Orange

Red Rx Receive

Transmit

Receive (Rx)

Transmit (Tx)

Ground 5

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Extron electronics Changer

Extron electronics

Extron electronics SW2 VGA DA2 A Manuel utilisateur

Extron electronics

Extron electronics VGA MATRIX SWITCHERS MVX PLUS 128 Manuel utilisateur

Extron electronics

Extron electronics SW2 DP Manuel utilisateur

Extron electronics

Extron electronics USB HUB4 Series Manuel utilisateur

Extron electronics

Extron electronics MGP 641 xi Series Manuel utilisateur

Extron electronics

Extron electronics PVS 305SA Manuel utilisateur

Extron electronics

Extron electronics Matrix 12800 Series Manuel utilisateur

Extron electronics

Extron electronics MLS 100 A Manuel utilisateur

Extron electronics

Extron electronics MPS 602 Manuel utilisateur

Extron electronics

Extron electronics SW6 VGA A Manuel utilisateur

Extron electronics

Extron electronics SGS 408 Manuel utilisateur

Extron electronics

Extron electronics Extron MediaLink MLS 304MA Manuel utilisateur

Extron electronics

Extron electronics SW2 MTP T 15HD A Manuel utilisateur

Extron electronics

Extron electronics SW8/12 Manuel utilisateur

Extron electronics

Extron electronics MMX 42 Series Manuel utilisateur

Extron electronics

Extron electronics SW2 HDMI Manuel utilisateur

Extron electronics

Extron electronics SVS 100 Manuel utilisateur

Extron electronics

Extron electronics VersaTools MSW 4V SDI Manuel utilisateur

Extron electronics

Extron electronics PVS 407D Manuel utilisateur

Extron electronics

Extron electronics PVS 407D Manuel utilisateur

Extron electronics

Extron electronics MPS 112 Manuel utilisateur

Extron electronics

Extron electronics SW HDMI Series Manuel utilisateur

Extron electronics

Extron electronics SW HDMI LC Series Manuel utilisateur

Extron electronics

Extron electronics System 8 Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur