Extron electronics RWM 1 Manuel utilisateur

RWM 1 • Installation Guide

Overview

The RWM 1 is an accessory kit for the TLP Pro 525M touchpanel

to be installed into a wall. This guide provides instructions for

experienced and professional installers to mount and install the TLP

Pro 525M using an RWM 1.

ATTENTION:

• All structural steps and electrical installation must be performed by qualified personnel in accordance with local

and national building codes and electrical codes.

• Toute étape structurelle et installation électrique, doit être effectuée par un personnel qualifié, conformément aux

codes du bâtiment, aux codes incendie et sécurité, et aux codes électriques, locaux et nationaux.

Figure 1. RWM 1

AScrews to turn locking arm (4) C 2-gang EU junction box mounting

holes

E 1-gang North America

junction box mounting holes,

horizontally mounted

B Magnets (4) D 1-gang MK junction box mounting

holes

F Locking arms (4)

The RWM 1 ships with three magnets attached to the front and a spare magnet (G) attached to the back, as shown in

figure 1. The spare magnet can be moved to the front if extra support is needed.

TOP

NORTH

AMERICA

NORTH

AMERICA

Front View Back View

IMPORTANT:

Go to www.extron.com for the

complete user guide and installation

instructions befor

e connecting the

oduct to the power sou

rce.

www.extron.com

RWM 1

TLP Pro 525M

Mounted Touchpanel

RWM 1 • Installation Guide (Continued)

Figure 3. Installing the TLP Pro 525M

Before You Start

Decide where you want to mount the touchpanel. A

cut-out template for the RWM 1 is available at www.

extron.com and it provides clearances for the com-

ponents to be installed.

1. Use the template to cut a hole in the drywall

or furniture (see figure 2, 1) that is 4.15'' H x

6.07'' W (105 mm H x 154 mm W). The RWM

1 is suitable for drywall that is 1/2-1'' (13-

25mm) thick.

2. Route cables to the hole.

If local building codes require cables to be run through

a conduit to a junction box, then the RWM 1 can be

used with a standard 2-gang EU junction box, 1-gang

MK junction box, or a horizontally mounted 1-gang US

junction box (Extron JB 125). The junction box must be

purchased separately.

If required, attach the junction box to the RWM 1 using

the screws provided with the junction box through the

corresponding holes in the RWM 1 (see Figure 1).

268-3269-01 Rev. B

11 18

Mounting the RWM 1 to Drywall

1. Ensure the locking arms (2) are lying flat against the top and bot-

tom of the RWM 1, and insert the RWM 1 into the hole.

2. Use a Philips-head screwdriver to turn and tighten the locking

arms against the drywall. The locking arms should hold the RWM 1

securely, but should not be overtightened.

The cables have to come through the RWM 1 opening before

inserting the RWM 1 onto the wall and tightening the locking

arms. 11

RWM 1

Touchpanel

Mounting

Plate

Lock Screw

Back View

TLP Pr

o 525M

Figure 2. Installing RWM 1 into the wall

Mounting the TLP Pro 525M

1. Run a PoE/Ethernet cable through the RWM 1 and

connect it to the rear panel port on the touchpanel

(see the TLP Pro 525, 725, and 1025 Series User

Guide)

2. The touchpanel mounting plate has two hooks (3)

located on the top left and right corners. Position the

TLP Pro 525M so the hooks fit into the two rear slots

of the touchpanel (see the TLP Pro 525 Series, 725

Series, and 1025 Series User Guide).

3. Slide the TLP Pro 525M down slightly so the hooks

are secure in the slots.

4. The tongue at the bottom of the mounting plate (4)

sits in the groove at the bottom of the touchpanel

(5). Fasten the touchpanel to the mounting plate by

tightening the lock screw (6).

5. Place the touchpanel against the RWM 1. Strong

magnets on the RWM 1 hold the touchpanel in

place.

NOTE: The cables have to come through the RWM 1 opening before

inserting the RWM 1 onto the wall and tightening the locking

arms.

RWM 1

TLP Pr

o 525M

Wall

Side View

Mounted Touchpanel Side View

For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the

Extron Safety and Regulatory Compliance Guide on the Extron website.

Autres manuels Extron electronics Équipement d'enregistrement

Extron electronics

Extron electronics Converter CVC 200 Manuel utilisateur

Extron electronics

Extron electronics TLI Pro 201 Manuel utilisateur

Extron electronics

Extron electronics AXI 22 AT D Manuel utilisateur

Extron electronics

Extron electronics DVI-RGB 150 Manuel utilisateur

Extron electronics

Extron electronics RGB 160xi Manuel utilisateur

Extron electronics

Extron electronics SSP 200 Manuel utilisateur

Extron electronics

Extron electronics RGB 580xi AAP Manuel utilisateur

Extron electronics

Extron electronics Quantum Ultra Series Manuel utilisateur

Extron electronics

Extron electronics Feedback Loop Isolator FBI 100 Manuel utilisateur

Extron electronics

Extron electronics IP Link Series Manuel utilisateur

Extron electronics

Extron electronics P/2 DA1 USB Manuel utilisateur

Extron electronics

Extron electronics AXI 22 AT D Manuel utilisateur

Extron electronics

Extron electronics RGB 103 Manuel utilisateur

Extron electronics

Extron electronics NetPA AT Series Manuel utilisateur

Extron electronics

Extron electronics PIP 422 Manuel utilisateur

Extron electronics

Extron electronics RGB 460xi FSR Series Manuel utilisateur

Extron electronics

Extron electronics RGB 326 Manuel utilisateur

Extron electronics

Extron electronics VNR 100 Manuel utilisateur

Extron electronics

Extron electronics RGB 472xi Manuel utilisateur

Extron electronics

Extron electronics RGB 109xi Manuel utilisateur

Extron electronics

Extron electronics RGB 302 Manuel utilisateur

Extron electronics

Extron electronics RGB 118 PLUS Manuel utilisateur

Extron electronics

Extron electronics SSP 7.1 Manuel utilisateur

Extron electronics

Extron electronics RGB 190F Manuel utilisateur

Manuels Équipement d'enregistrement populaires d'autres marques

KV2 Audio

KV2 Audio 500 Series Manuel utilisateur

Robotics Technologies

Robotics Technologies microBus-Cam II Manuel utilisateur

Seca

Seca 460 Manuel utilisateur

Cognex

Cognex MVS-8000 Series Manuel utilisateur

Mect

Mect MPNC006 Series Manuel utilisateur

Bad Caf

Bad Caf THE LEASH Manuel utilisateur

Strymon

Strymon NIGHTSKY Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manuel utilisateur

Tews Technologies

Tews Technologies TPMC465 Manuel utilisateur

Honeywell

Honeywell Excel 50 Manuel utilisateur

SeaLevel

SeaLevel COMM+8.LPCI Manuel utilisateur

Arturia

Arturia AUDIOFUSE STUDIO Manuel utilisateur

Rukra

Rukra RK-1240 Manuel utilisateur

Samson

Samson SCOM Manuel utilisateur

Dynacord

Dynacord DPS260 Manuel utilisateur

Nice

Nice Core Manuel utilisateur

Pyle Pro

Pyle Pro PSS8 Manuel utilisateur

RF-System

RF-System TinyGate Manuel d'utilisation et d'entretien