Extron electronics MTP 1500RL 15HD A SEQ Manuel utilisateur

MTP 1500RL 15HD A SEQ • Setup Guide

This guide provides basic instructions for an experienced installer to set up and operate the Extron MTP 1500RL

15HD A SEQ twisted pair receiver.

For full details, see the MTP 1500RL 15HD A SEQ User Guide, available online at www.extron.com.

MTP 1500RL Series

POWER

12V

1.0A MAX

MTP 1500RL 15HD A SEQ

OUTPUT

MONO

AUDIO

RGB

PEAKING

LEVEL

DELAY

RED

GREEN

BLUE

SELECT

ADJUST MIN/MAX

INPUT BUFFERED OUTPUT

H +

V +

CSYNC

SOG

VIDEO

END

SPARE

MTP

Installation and Setup

Step 1 — Mounting

Turn off or disconnect all equipment power sources. Mount the MTP 1500RL 15HD A SEQ receiver as required.

Step 2 — Connect Input

Connect the RJ-45 cable from an MTP transmitter to the Input port on the MTP 1500RL 15HD A SEQ receiver.

Terminate the cable as shown below right, using the same standard (A or B) at both ends.

NOTE: The transmitter and receiver are designed for and perform best with Extron Enhanced Skew-Free AV cable terminated in accordance

with the TIA/EIA T568A standard. CAT 5 cables are acceptable but less preferable. Using preterminated and tested cables is also

recommend, Cables terminated on site should be tested before use to ensure that they comply with Category 5 specifications.

Step 3 — Connect Outputs

Attach the applicable output cables (video, audio, and buffered output).

A. High resolution video output — Connect a display device to the 15-pin HD connector (RGB).

B. Audio connector —Connect an audio device to the 5-pole captive screw connector for mono audio output

MONO AUDIO

Unbalanced Output Balanced Output

Do not tin the wires!

Mono output 1-

Sleeve(s)

Mono output 1+

Mono output 2+

Mono output 2-

Sleeve(s)

Mono output 1

Mono output 2

NO GROUND.

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground contact.

DO NOT connect the sleeves to the negative (-) contacts.

C. Buffered output — Connect up to 5 daisy-chained MTP receivers to this RJ-45 connector.

Insert Twisted

Pair Wires

Pins:

RJ-45 Connector

12345678

Pin T568A Wire

Color

T568B Wire

Color

1 White-green White-orange

2 Green Orange

3 White-orange White-green

4 Blue Blue

5 White-blue White-blue

6 Orange Green

7 White-brown White-brown

8 Brown Brown

MTP 1500RL 15HD A SEQ • Setup Guide (Continued)

Extron USA Headquarters +1.800.633.9876 (USA/Canada Only) Extron USA - West: +1.714.491.1500 FAX: +1.714.491.1517 Extron USA - East: +1.919.850.1000 FAX: +1.919.850.1001

Step 4 — Receiver DIP Switches

• H sync (H+) and V sync (V+) switches — Set these switches up (On) for positive

sync or down (Off) for negative sync.

• Composite Sync, SOG, and Video switches — Set these switches as shown in the

table on the right to output the indicated format.

• End Unit switch — Set this switch up if either of the following is true:

• The receiver being congured is the only receiver connected to the transmitter.

• The receiver being congured is the last receiver in a daisy-chained system.

Power Supply

Output Cord

SECTION A–A

Ridges

Smooth

Tie

Wrap

POWER

12V

xA MAX Rear

Panel

Ridges

Earth

Ground

3/16"

(5 mm)

Max.

Step 5 — Power

Wire the 2-pole captive screw connectors for the included external 12 VDC power supplies (see

image a on the right). Plug them into all units.

Grounding guidelines

Extron MTP 1500RL 15HD A SEQ products can be adversely affected by electrostatic discharge (ESD)

if they are not grounded correctly.

To prevent malfunctions or product damage, an experienced installer can correctly ground an Extron

MTP 1500RL 15HD A SEQ product in either of two ways:

• Ground the power input port — Insert one end of the grounding wire to the negative or ground pin on the

power input connector (see image aon the right). Tie the other end of the wire to an earth ground.

• Ground the chassis — Use a connector hex nut (see image bon the right). Tie the other end of the wire

to an earth ground.

If you have any questions about how to ground a product in a specic application, contact an Extron technical

support specialist.

Step 6 — Peaking and Level

Adjust image sharpness with the Peaking control. Increased peaking compensates for mid- and high-frequency detail

loss. The LED lights red when minimum (zero) and maximum peaking is reached.

Adjust image brightness using the Level control. View the image and adjust either control for the best image quality.

Step 7 — Skew Compensation

Pair skew can be measured with test equipment or by viewing a crosshatch test pattern. The SEQ receivers have

built-in skew compensation capabilities. Adjust the equalization as follows:

A. Set the skew delay to zero for red, green, and blue by pressing and holding the Select button in for 3 seconds,

using a Tweeker or small screwdriver. When the Red, Green, and Blue LEDs all go out, release the Select button.

B. Use UTP cable test equipment or examine the displayed image to determine which video signal — red, green, or blue

— is shifted furthest to the right.

C. Adjust the furthest left video signal by using a Tweeker or screwdriver to press and release the Select button until the LED for the left-

shifted color lights.

D. Slowly rotate the Adjust control clockwise until the shifted color is properly aligned.

E. Repeat steps C and D to align the third color if needed.

68-1554-50

Rev. B

01 13

DELAY

RED

GREEN

BLUE

SELECT

ADJUST

RGB

PEAKING

LEVEL

MIN/MAX

MTP1500RL 15HD A SEQ

POWER

12V

0.5AMAX

OUTPUT

MONO

AUDIO

H+

V+

CSYNC

SOG

VIDEO

END

SPARE

INPUT BUFFEREDOUTPUT

MTP

MTP1500RL 15HD A SEQ

POWER

12V

0.5AMAX

OUTPUT

MONO

L R

AUDIO

H+

V+

CSYNC

SOG

VIDEO

END

SPARE

INPUT BUFFEREDOUTPUT

MTP

Flat Panel

Display

Flat Panel

Display

1,000' (305 m) UTP Cable

(CAT 5/5e/6)

Audio

RGBHV

RGBHV500' (152 m) UTP Cable

(CAT 5/5e/6)

RGBHV

Extron

MTP 1500RL 15HD A SEQ

Extron

MTP T 15HD A

Extron

MTP 1500RL 15HD A SEQ

Figure 1. Example of a typical MTP 1500RL 15HD A SEQ application

H +

V +

CSYNC

SOG

VIDEO

END

SPARE

Output

Format C Sync SOG Video

RGBHV

RGBS

RGsB

Component*

S-video*

Composite*

* Input video format must match.

Autres manuels pour MTP 1500RL 15HD A SEQ

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Extron electronics Récepteur

Extron electronics

Extron electronics MTP U R A Manuel utilisateur

Extron electronics

Extron electronics MTP 15HD RS Series Manuel utilisateur

Extron electronics

Extron electronics MTP 15HD A Series Manuel utilisateur

Extron electronics

Extron electronics MTP 1500RL 15HD A SEQ Manuel utilisateur

Extron electronics

Extron electronics PowerCage FOX Tx/Rx AV Manuel utilisateur

Extron electronics

Extron electronics TP R BNC A Manuel utilisateur

Extron electronics

Extron electronics HC 402 EU Manuel utilisateur

Extron electronics

Extron electronics Twisted Pair Transmitter VTT001 Manuel utilisateur

Extron electronics

Extron electronics Twisted Pair Transmitter VTT001 Manuel utilisateur

Extron electronics

Extron electronics XTP R HDMI Manuel utilisateur

Extron electronics

Extron electronics PowerCage FOX SR HDMI Manuel utilisateur

Extron electronics

Extron electronics MTP 1500RL 15HD A SEQ Manuel utilisateur

Extron electronics

Extron electronics FOXBOX SR HDMI Manuel utilisateur

Extron electronics

Extron electronics XTP T HD 4K Manuel utilisateur

Extron electronics

Extron electronics FOX3 T 301 Manuel utilisateur

Extron electronics

Extron electronics DTP2 T 211 Manuel utilisateur

Extron electronics

Extron electronics XTP SFR HD 4K Manuel utilisateur

Extron electronics

Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201... Manuel utilisateur

Extron electronics

Extron electronics MTP T SV A Manuel utilisateur

Extron electronics

Extron electronics FOX II T DP 4K Manuel utilisateur

Extron electronics

Extron electronics FOXBOX SR HDMI Manuel utilisateur

Extron electronics

Extron electronics FOX3 T 301 Manuel utilisateur

Extron electronics

Extron electronics Dual Link DVI Transmitter and Receiver DVI DL 201... Manuel utilisateur

Extron electronics

Extron electronics MTP C7 T 15HD RS Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur