Extron electronics VLP 202 Instructions d'utilisation

This guide provides instructions for an experienced installer to set up, install, and

connect the Extron VLP 202 VoiceLift Compact Pendant Microphone or VLH 102 VoiceLift

Handheld Microphone, the VLC 202 Charging Station and the VLR 102 Receiver in a system

with a PVS 405D PoleVault Digital Switcher.

Setting Up the VLP 202 and VLH 102 Microphones

1. Set the channel using the rotary switch. Aand C= 2.3 MHz; Band D= 2.8 MHz. For the VLH 102, remove the battery cover

to access this switch.

NOTE: Each microphone must be on a different frequency. On the pendant microphone, set the channel to Cor Dto

disable the volume buttons (the handheld microphone has only channels Aand B, and its volume cannot be disabled).

2. For pendant microphones only, apply the appropriate sticker (provided) to identify the microphone.

3. Remove the battery cover and insert a AA battery. If necessary, replace the battery cover and

charge the rechargeable battery (see “Installing the VLC 202 Charging Station,” below).

4. For pendant microphones only, attach the lanyard to the microphone as follows:

a. Press the lanyard into the guides on the sides of the lanyard clip

(see the VoiceLift System with PVS 405D Installation Guide for details).

b. Press the top of the microphone clip to lift it.

c. Slide the lanyard lock under the clip and release the clip (see the illustration at right).

d. Place the lanyard around your neck and slide the lanyard through the lock until the microphone

is positioned approximately 4 inches (10.2 cm) below your chin.

5. Turn the microphone on by sliding the power switch up.

6. Speak in a normal tone of voice. Do not block the microphone port or grille opening.

7. Adjust the volume if necessary.

8. Ensure that a direct line of sight exists from the

microphone to the receiver (required for proper

operation). Do not block the IR transmitter window.

Installing the VLC 202 Charging Station

To install the charging station (see the illustration at right):

1. Plug the wall charger (5 V, 1 A) into a wall outlet.

2. Connect the wall charger cable to the charging station

power jack.

3. Place the microphone in one of the slots in the charger.

The charge is complete when the microphone LED

turns green (this can take up to 5 hours).

Guides

Extron Headquarters

+800.633.9876 Inside USA/Canada Only

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.850.1000

+1.714.491.1517 FAX +1.919.850.1001 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.299.1800

+971.4.299.1880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

(Inside India Only)

+91.80.3055.3777

+91.80.3055.3737 FAX

CAUTION:

• Do not replace the battery with an incorrect type.

• Ne pas remplacer la pile par le mauvais type de pile.

ATTENTION:

• Do not charge alkaline batteries.

• Ne rechargez pas les piles alkalines.

• Dispose of used batteries according to the instructions provided on the

battery packaging.

• Débarrassez-vous des piles utilisées selon les instructions du fabricant.

NOTE: The microphone can be left to charge for extended periods. It should

not be turned off while charging.

Installing the VLR 102 Receiver

To install the VLR 102 IR Receiver in a drop ceiling:

1. In the ceiling tile, cut a hole 2 to 3 inches (50 to 76 mm) in

diameter.

2. If necessary, separate the receiver housing from the base (see

the VoiceLift Microphone System User Guide, available at

www.extron.com).

3. Align the center of the receiver housing with the hole in the

ceiling tile.

4. Insert the mounting screw through the receiver housing and

the hole in the ceiling tile.

5. Attach the provided Z-bracket to the end of the screw on the

back side of the ceiling tile. Replace the ceiling tile.

6. Pull a shielded CAT5 cable to the receiver location, and

connect one end of the cable to the RJ-45 jack (labeled OUT)

on the receiver base.

7. Align the arrow on the dome tab with the raised arrow on the

edge of the housing. Rotate the dome clockwise until the

arrow on the tab aligns with the raised dot on the housing.

8. Connect the other end of the shielded CAT5 cable to the

VoiceLift RJ-45 connector of the PoleVault switcher.

68-2548-50 Rev. B

05 14

Ce manuel convient aux modèles suivants

Autres manuels Extron electronics Système de microphone

Extron electronics

Extron electronics VoiceLift Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Pro Microphone EB Kit Series Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Microphone Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Pro VLS 3001 Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Manuel utilisateur

Extron electronics

Extron electronics MTP A/V Series Manuel utilisateur

Extron electronics

Extron electronics VoiceLift VLP 202 Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Manuel utilisateur

Extron electronics

Extron electronics VoiceLift Manuel utilisateur

Manuels Système de microphone populaires d'autres marques

Paso

Paso R824 Manuel utilisateur

Naxa

Naxa NAM-982 Manuel utilisateur

Motorola

Motorola PMNN4461 Manuel utilisateur

Xvive

Xvive U3 Manuel utilisateur

Tekon

Tekon DUOS Manuel utilisateur

Heyuan Intelligence

Heyuan Intelligence IOT-G2S-01 Manuel utilisateur

Devine

Devine WMD-IE Manuel utilisateur

LG LF-D7150 Manuel utilisateur

GE S768DAV Manuel utilisateur

LD U305 HBH 2 Manuel utilisateur

Chainway

Chainway URA8 Manuel utilisateur

ORATOR

ORATOR D860TD Manuel utilisateur

Sennheiser

Sennheiser Evolution Wireless Digital EW-DX EM 2 Manuel utilisateur

Alpha Technologies

Alpha Technologies RBMS Manuel utilisateur

SWIT Electronics Co.,LTD.

SWIT Electronics Co.,LTD. CW-S150 Manuel utilisateur

Shure

Shure UA844 Manuel utilisateur

Panasonic

Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Manuel utilisateur

Pyle

Pyle PDWM5000 Manuel utilisateur