Extron electronics ISM Series Guide de démarrage rapide

ISM MTP UT 4DA Output Board Installation Notes

The Extron ISM MTP UT 4DA is a twisted pair transmitter board for the ISM 824 with four RJ-45

outputs, two RS-232 inserts, and local audio output.

The board mounts in one of the four vertical expansion

slots (numbered 1 to 4) at the rear of the ISM 824.

For full operating details of the ISM refer to the

ISM 824 User’s Manual, online at www.extron.com.

To install an output board in the ISM 824 base unit,

1. Turn off the ISM 824, and remove the power cord.

Repeat for all connected devices.

2. At the rear, select an open slot, or take out the

blank plate from the desired output port by

removing the two retaining screws (top and

bottom), and lifting the blank away.

NRe-use the screws to secure the new output

board in place. Retain the blank plates.

If a board is already installed in the desired slot,

remove the screws and carefully pull out the

board.

3. Remove the board from its outer box and anti-ESD

bag, holding the boards by the rear frame.

4. With the board upright, align the front (non connector end) of the board with the top and

bottom plastic guides in the ISM 824. Slide the board in carefully, keeping within the guides.

Push it home ﬁrmly, and secure it with the retained screws.

5. If applicable, repeat steps 2through 4for any other output boards.

6. Power on the ISM 824. The new output board(s) is auto-detected, and takes approximately

30 seconds to initialize. The LCD display indicates the new board type,

slot used, and counts down the initialization time. See inset for example

display for a new ISM MTP UT 4DA board installed in Slot #3.

7. Using suitable twisted pair cables connect any MTP

receiver, DA, or switcher to the RJ-45 twisted pair outputs

on the installed boards. See wiring details at right.

NUse the same standard at both ends of the twisted pair

cable.

8. Insert a 5-pole captive screw connector from an audio

device into the local audio output connector for balanced

or unbalanced stereo audio. Wire the connector as shown

below.

Balanced Stereo Output

Tip

Ring

Sleeve(s)

Tip

Ring

L R

Left

Right

Unbalanced Stereo Output

Tip

NO GROUND HERE.

Sleeve(s)

Tip

NO GROUND HERE.

L R

Left

Right

CAUTION

For unbalanced audio, connect the sleeve(s)

to the center contact ground. DO NOT connect

the sleeve(s) to the negative (-) contacts.

12345678

RJ-45

Connector

Insert Twisted

Pair Wires

Pins:

Wire color

White-green

Green

White-orange

Blue

White-blue

Orange

White-brown

Brown

Wire color

T568A T568B

White-orange

Orange

White-green

Blue

White-blue

Green

White-brown

Brown

NOTE If you are using Enhanced

Skew-Free™ A/V cable, use the

TIA/EIA T568A standard only.

(Continued on reverse side)

100

240

50/60 Hz

1.2A MAX.

2 3 4 5 6 7 8

2 1 2

345 678

INPUTS OUTPUTS

R/R-Y

G/Y

VID

B/C

B-Y

H/HV

R/R-Y

G/Y

VID

B/C

B-Y

H/HV

PASS THRU

INPUTS

RESET

LAN

REMOTE

RS232/RS422 ACT LINK

OUTPUT

VIDEO

SCALER

70-545-01

R-Y

G/Y

B-Y

OUTPUT

UNIV.

SCALER

70-544-01

R-Y

G/Y

B-Y

OUTPUT

PASS

THRU

70-547-01

R-Y

G/Y

B-Y

Extron

ISM 824

Integration Scaling

Matrix Switcher

Align output board with

top and bottom plastic guides.

R-Y

G/Y

B-Y

OUTPUT

SCAN

CONV.

70-546-01

Example Output Board Installation

New ISM MTP UT 4DA

Slot #3 18

INSERT 3/4

LOCAL

AUDIO OUTPUT

1234

BUFFERED OUTPUTS

RS 232

Tx Rx

INSERT 1/2

Tx Rx

ISM

MTP UT 4DA

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

68-1123-60

Rev A

02 09

ISM MTP UT 4DA Output Board Installation Notes, cont’d

9. Connect a control device to RS-232 insert 1/2 (for

outputs 1 and 2), or insert 3/4 (for outputs 3 and

4). This allows bidirectional, pass-through control

signals to and from the control device and the

MTP devices on ports 1 and 3, and unidirectional

pass-through signals from the control device on

ports 2 and 4. Ports 1 and 2 always receive the

same RS-232 command signal, but only port 1

allows for bidirectional communications. The

same is true for ports 3 and 4, where port 3 allows

for bidirectional communications (see right).

See below for board speciﬁc SIS™commands.

ISM MTP UT 4DA conﬁguration menu

Using the front panel menu buttons (Menu and Next), the

ISM MTP UT 4DA board conﬁguration menu can be accessed.

From the Output Conﬁguration screen, press Next until reaching

the #xISM MTP menu (see the image at right). Using the front

panel adjustment knobs ({ [), change the settings as desired.

Power up input and output devices and create the desired ties.

Board speciﬁc SIS commands table

Alternatively, the ISM MTP UT 4DA board can be conﬁgured with speciﬁc SIS commands.

NX! = ISM 824 output number, 3,5,7,8 (i.e. the slot/port occupied by the ISM MTP UT 4DA)

X@ = RS-232 number 0 = insert 1/2, 1= insert 3/4

X# = Setting value 0 = off, 1= on

X$ = Sub-output number (setting for each MTP output on each card) 1,2,3,4

Command ASCII

command

(host to switcher)

Response

(switcher to host)

Additional description

Local RS-232 ports

Enable EX!*X@*1LRPT X!LrptX@*1]Enable RS-232 insert X@ to

control output X!.

Disable EX!*X@*0LRPT X!LrptX@*0]Disable RS-232 insert X@

controlling output X!.

View EX!*X@LRPT X#] View the RS-232 status X# for

output X!.

Output Pre-peaking

Turn on EX!*X$*1OPEK X!OpekX$*1]Turn pre-peaking on for output

X! to MTP sub-output X$.

Turn off EX!*X$*0OPEK X!OpekX$*0]Turn pre-peaking off for output

X! to MTP sub-output X$.

View

status

EX!*X$OPEK X#]View the pre-peaking status X#

for output X!.

RS-232 Insert 3/4

<Off> On

Output Card

Configuration

Prepeaking #x

<Off> On

RS-232 Insert 1/2

<Off> On

Select Ouptut

#xISM MTP UT 4DA

RS-232 Commands

INSERT 3/4

1234

BUFFERED OUTPUTS

RS 232

Tx Rx

INSERT 1/2

Tx Rx

TP UT 4D

Bidirectional

1234

BUFFERED OUTPUTS

Unidirectional

Tr ansmit (Tx)

Receive (Rx)

Ground (Gnd, )

Ce manuel convient aux modèles suivants

Autres manuels Extron electronics Commutateur matriciel

Extron electronics

Extron electronics SMX System Manuel utilisateur

Extron electronics

Extron electronics CrossPoint 84 Manuel utilisateur

Extron electronics

Extron electronics DXP 88 SDI Manuel utilisateur

Extron electronics

Extron electronics MPX Plus 866 A Manuel utilisateur

Extron electronics

Extron electronics DTP CrossPoint 108 4K Manuel utilisateur

Extron electronics

Extron electronics Matrix 50 Series Manuel utilisateur

Extron electronics

Extron electronics MMX 32 VGA MTP Manuel utilisateur

Extron electronics

Extron electronics TPX 88 Series Manuel utilisateur

Extron electronics

Extron electronics Matrix 50 Series Manuel utilisateur

Extron electronics

Extron electronics DMS 1600 Manuel utilisateur

Extron electronics

Extron electronics CrossPoint 300 Series Manuel utilisateur

Extron electronics

Extron electronics CrossPoint 450 Plus 64 Series Manuel utilisateur

Extron electronics

Extron electronics MAV Plus Series Manuel utilisateur

Extron electronics

Extron electronics HDXP Plus Series Manuel utilisateur

Extron electronics

Extron electronics XTP II CrossPoint Series Manuel utilisateur

Extron electronics

Extron electronics DMS 1600 Manuel utilisateur

Extron electronics

Extron electronics FOX3 Matrix 80x Manuel utilisateur

Extron electronics

Extron electronics MVX 128 VGA A Manuel utilisateur

Extron electronics

Extron electronics MPX 423 A Manuel utilisateur

Extron electronics

Extron electronics DXP 44 4K PLUS Manuel utilisateur

Extron electronics

Extron electronics CrossPoint 450 Plus 64 Series Manuel utilisateur

Extron electronics

Extron electronics TPX 88 Manuel utilisateur

Extron electronics

Extron electronics HDXP Plus Series Manuel utilisateur

Extron electronics

Extron electronics DXP 1616 HD 4K PLUS Series Manuel utilisateur

Manuels Commutateur matriciel populaires d'autres marques

Broadcast Tools

Broadcast Tools SS 8.2 Manuel utilisateur

Altimium

Altimium MATF32 Manuel utilisateur

ALFAtron

ALFAtron ALF-MUK44N Manuel utilisateur

Monoprice

Monoprice Blackbird 15377 Manuel utilisateur

Kramer

Kramer XL 3216VS Manuel utilisateur

PTN

PTN FMX12 Manuel utilisateur

CYP

CYP nT15GX01 Manuel utilisateur

Kramer

Kramer VP-2x2 Manuel utilisateur

Kramer

Kramer Sierra Video 6432V5xl Manuel utilisateur

TESmart

TESmart HMA0402A40 Manuel utilisateur

Octava

Octava HD4XSTPMX Manuel utilisateur

Intelix

Intelix FLX-88 Mode d'emploi

Kramer

Kramer LASSEN XL 3232S Manuel utilisateur

Roland

Roland XS-1HD Manuel utilisateur

Kramer

Kramer VS-66HDCPxl Manuel utilisateur

Atlona

Atlona AT-HDMI-22M Manuel utilisateur

Link

Link HD8X8 Manuel utilisateur

AMX

AMX AVS-OP-2020-117 Instructions et recettes