Extron electronics FOX 2G Tx AV Manuel utilisateur

Setup Guide — FOX 2G Tx/Rx AV

(Continued on reverse side)

The FOX 2G Tx AV and FOX 2G Rx AV are a high performance, low resolution video, audio,

and data (RS-232) transmitter (Tx) and receiver (Rx) pairs. Both the transmitter and receiver are

available in single mode (SM) and multi-mode (MM) models. The SM models transmit signals

up to 30 km (18 miles) over ﬁber optic cable, at rates up to 2 Gbps.

NThe transmitter and receiver must be compatible. Both must be MM or both must be SM. It

is not possible to mix types.

WThe FOX 2G Tx/Rx AV outputs continuous invisible light (Class 1 rated), which may

be harmful and dangerous to the eyes; use with caution.

Do not look into the rear panel ﬁber optic cable connectors or into the ﬁber optic cables

themselves.

NPlug the attached dust caps into the optical transceivers when the ﬁber optic cable is

unplugged.

To install, cable, and power on the transmitter/receiver pair:

Step 1

Turn off all equipment or disconnect it from power sources.

Mount the transmitter and receiver as required.

Step 2

Connect a low resolution video source to the transmitter using

the input BNC connections for composite or component sources.

S-video can be connected using either the BNC connectors or the

4-pin mini DIN. (See the ﬁgure at right).

Step 3

Connect balanced or unbalanced, stereo or mono audio input

to the transmitter using the 5-pole, 3.5 mm captive screw

connector. (See the ﬁgure at right).

Step 4

If required, connect an alarm system to the transmitter’s

2-pole captive screw connector.

Step 5

To conﬁgure the transmitter and receiver using RS-232

commands, connect a control device to the three right poles

( ,Tx, and Rx), labeled RS-232 Remote, on the RS-232 captive

screw connector of the transmitter (see the ﬁgure at the bottom

of the page). Alternatively, the host device can be connected

through the front panel Conﬁg port or the corresponding ports on the receiver

(see step 13). These ports may also be used to conﬁgure the system with the

FOX Extender Windows®Control Program.

Step 6

To pass through RS-232 commands to remote devices, independently of the

FOX 2G Tx/Rx AV, use the three left poles (Tx, Rx, and ), labeled RS-232

Over Fiber. The ground is common for both sets of RS-232 signals. (See the

ﬁgure at right).

Y/VID

R-YS-VID

B-Y/C

S-video

-Y

Y/VID

R-YS-VID

B-Y/C

-VI

S-video

Y/VID

R-YS-VID

B-Y/C

-VID

Component

Y/VID

R-YS-VID

B-Y/C

-VID

Composite

-Y/

Balanced Audio

Tip

Ring

Tip

Ring

L R

Sleeves

Unbalanced Audio

Tip

Sleeve

Tip

L R

WInstallation and service must be performed by

authorized personnel only.

These instructions provide a quick setup guide for

the Extron FOX 2G Tx/Rx AV. They are for use by

experienced installers.

REMOTE

Tx RxTx Rx

OVER FIBER

RS-232

Setup Guide — FOX 2G Tx/Rx AV

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

68-1466-50

Rev. A

04 09

Step 7

Connect the 12 VDC power supply to the transmitter’s 2-pole captive screw connector. Do not

switch on the power supply.

Step 8

Connect the receiver to a low resolution video display using either the output BNC connectors

(component, S-video, or composite) or the 4-pin mini DIN (S-video only), as shown in the

ﬁgure at right.

Step 9

Connect the receiver’s audio output to a sound system, using the 5 pole, 3.5 mm captive screw

connector.

Step 10

If required, connect an alarm system to the receiver’s 2-pole

captive screw connector.

Step 11

Connect the ﬁber optic cable(s) from the transmitter to the back

of the receiver (see the ﬁgure below). Fiber optic link 1 connects

the Tx port of the transmitter to the Rx port of the receiver and

is essential for transmission of video, audio, and control signals

from the transmitter to the receiver. Fiber optic link 2 connects the Rx port of the transmitter

to the Tx port of the receiver. It is optional, but two-way communication from the Tx port of

the receiver is required to fully conﬁgure the system using RS-232 commands or FOX Extender

Windows Control Program.

RxTx

OPTICAL

RxTx

OPTICAL

Transmitter Receiver

Link 2 may be connected to another receiver in a daisy chain. In that case, there is no return

link to the transmitter.

Step 12

Connect an RS-232 control device to the 5-pole captive screw connector or the front panel

Conﬁg port of the receiver. These ports are an alternative to the transmitter ports (see steps 6

and 7).

NIf the RS-232 control device is connected to the receiver, ﬁber optic Link 2 is required to

conﬁgure the transmitter.

Step 13

Connect the 12 VDC power supply to the receiver’s 2-pole captive screw connector.

Step 14

Power up all devices and conﬁgure the system using the Simple Instruction Set (SIS™)

commands or FOX Extender Windows Control Program. Consult the user’s manual (available

online at www.extron.com) for more information about SIS commands and the Control

Program.

Y/VID

R-YS-VID

B-Y/C

S-video

-Y

Y/VID

R-YS-VID

B-Y/C

-VI

S-video

Y/VID

R-YS-VID

B-Y/C

-VID

Component

Y/VID

R-YS-VID

B-Y/C

-VID

Composite

-Y/

Autres manuels pour FOX 2G Tx AV

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Extron electronics Extenseur

Extron electronics

Extron electronics PowerCage FOX 4G Tx VGA Manuel utilisateur

Extron electronics

Extron electronics DTP T DWP 4K D Series Manuel utilisateur

Extron electronics

Extron electronics DTP DVI 4K 230 D Series Manuel utilisateur

Extron electronics

Extron electronics XTP R HWP 201 Manuel utilisateur

Extron electronics

Extron electronics FOXBOX Tx HDMI Manuel utilisateur

Extron electronics

Extron electronics FOXBOX Tx VGA MM Manuel utilisateur

Extron electronics

Extron electronics FOX T USB Extender Plus Manuel utilisateur

Extron electronics

Extron electronics FOX T Plus MM Manuel utilisateur

Extron electronics

Extron electronics DTP DVI 4K 330 Manuel utilisateur

Extron electronics

Extron electronics PowerCage FOX 4G Rx DVI Manuel utilisateur

Extron electronics

Extron electronics FOXBOX HDMI Manuel utilisateur

Extron electronics

Extron electronics DDX 102 Tx Manuel utilisateur

Extron electronics

Extron electronics Tx-Rx Manuel utilisateur

Extron electronics

Extron electronics 60-871-12 Manuel utilisateur

Extron electronics

Extron electronics DTP T/R DP 330 Manuel utilisateur

Extron electronics

Extron electronics DTP T USW 223 Manuel utilisateur

Extron electronics

Extron electronics HDMI 230 D Manuel utilisateur

Extron electronics

Extron electronics FOX3 SR 20 Manuel utilisateur

Extron electronics

Extron electronics DTP DVI 4K 230 D Series Manuel utilisateur

Extron electronics

Extron electronics DTP HDMI 230 Manuel utilisateur

Extron electronics

Extron electronics PowerCage FOX HDMI Manuel utilisateur

Extron electronics

Extron electronics FOX 500 DVI Manuel utilisateur

Extron electronics

Extron electronics DDRX DVI Manuel utilisateur

Extron electronics

Extron electronics DTP DVI 330 Manuel utilisateur

Manuels Extenseur populaires d'autres marques

SY HDBT-60T Manuel utilisateur

Appsys ProAudio

Appsys ProAudio ADX-16 Manuel utilisateur

Atlona

Atlona RS232 Manuel utilisateur

IDK

IDK OPF-TH1000-A Manuel utilisateur

Enable-IT

Enable-IT 824WP Manuel utilisateur

Worx

Worx Landroid RadioLink WA0864 Fiche technique

TP-Link

TP-Link TL-WA730RE Manuel utilisateur

Camplex

Camplex CMX-HDMI-SFPL Manuel utilisateur

SC&T

SC&T HE03-4K Manuel utilisateur

Marmitek

Marmitek MegaView70 Manuel utilisateur

Samsung

Samsung SCS-26UC4 Manuel utilisateur

Foxun

Foxun SX-GES24 Manuel utilisateur

MuxLab

MuxLab 500771 Manuel utilisateur

foxunhd

foxunhd SX-AEX01 Manuel utilisateur

TERK Technologies

TERK Technologies LFIRX2 Manuel utilisateur

Devolo

Devolo Audio Extender Manuel

Edimax

Edimax EW-7438RPn V2 Manuel utilisateur

Shinybow USA

Shinybow USA SB-6335T5 Manuel utilisateur