Extron electronics IN3254 Manuel de la liste des pièces

Setup Guide — IN3254

This guide provides basic instructions for an

experienced installer to set up and operate the

Extron® IN3254 Distribution Ampliﬁer (DA).

C Installation and service must be performed

by authorized personnel only.

Step 1 — Turn off the DA and input/output devices

Turn the input and output devices off and unplug their power cords. Verify that the DA is

disconnected from the power source before proceeding.

Step 2 — Attach input cables

Connect an RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video

device to these BNC connectors (c). See ﬁgure 1 for information on how to cable the

BNC connectors.

Step 3 — Attach output cables

Connect up to four RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, high

resolution monochrome video, or composite video output devices, such as projectors or

monitors, to these BNC connectors (d). See ﬁgure 1 for information on how to cable the

BNC connectors.

Step 4 — Power on DA, input/output devices, and check for picture

Plug the external power supply cord into the power connector (a). When power is

applied to the unit, the front and rear panel LEDs (b) light.

Connect the power cords and turn on the input and output devices. The picture should

appear on the video displays.

N The output signal(s) must match the input signal. If the picture does not appear, check

that the BNCs for the output(s) and input are connected with an identical signal.

Step 5 — Adjust video gain and sync level

Use the sync and gain DIP switches (e) to select either high or low video gain and sync

level. Adjust video gain while viewing the displayed image to set the level that provides

the best picture quality.

Figure 1 – IN3254 connectors/controls and connection diagram

RGBHV RGBS

RGsB,

RsGsBs,

Component

S-video

Composite

video

50/60 Hz

100-240V- 1.3A

LISTED

1T23

I.T.E.

CU S

INPUT

OUTPUTS

IN3254

1 2 3 4

X1.3

SYNC LEVEL

VIDEO GAIN

LOW

234

Rear panel

Power LED

Power

connector

Video input Video outputs

Sync and gain

DIP switches

X1.3

SYNC LEVEL

VIDEO GAIN

LOW

Apply gain for long cable runs, up to

200 feet (61 m) using Extron MHR cable

Do not add gain.

Select 5 V peak-to-peak

sync output

Select 3 V peak-to-peak

sync output

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517 FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

Setup Guide — IN3254 (cont’d)

Step 6 — Mount the DA

If necessary, mount the line driver. Make any cabling

adjustments before mounting the line driver, as the

cables may be inaccessible afterwards.

The DA can be mounted using an optional Extron

2U universal rack shelf (part number 60-032-01) as

follows:

a. Remove the rubber feet if they were previously

installed on the bottom of the unit.

b. Place the DA on one side of the rack shelf. Align

the front of the DA with the front of the shelf and

align the threaded holes on the bottom of the DA

with the holes in the rack shelf.

c. Secure the DA to the rack shelf with the two provided 4-40 x 3/16 inch machine screws.

Insert the screws from the underside of the shelf and securely fasten them through

diagonally opposite corners.

d. Fasten the false front panel (provided with the rack shelf) to the unoccupied side of the

rack (as shown in ﬁgure 2), or install a second half-rack-width device on that side by

repeating steps a through c.

e. Secure the rack shelf to the rack using four 10-32 x 3/4 inch bolts. Insert the bolts through

#10 beveled washers, then through the holes in the mounting brackets.

Troubleshooting

If the image does not appear or is not displayed properly

• Make sure that all of the devices are powered on.

• Make sure that each device is receiving power. The front and rear panel LEDs on the DA

should be lit.

• Check the cabling and make adjustments as needed.

• Check the manuals of the input and output devices or contact Extron to determine if there

are special requirements to output video to the external video port.

If problems persist, contact the Extron S3 Sales and Technical Support Hotline.

68-1015-50

Rev. B

03 10

BUFFERED LOCAL

MONITOR OUTPUT

INPUT H. SHIFT

RGB 109 xi

VGA INTERFACE W /ADSP

ID PIN 4

ID PIN 11

Extron

IN3254

RGBHV

Distribution Amplifier

Projector

Monitor

Extron

RGB 109xi

VGA–UXGA

Interface

Projector

Extron

IN3254

RGBHV Distrib

ution

Amplifier

IN3204B

RGBS DISTRIBUTION AMPLIFIER

Front False

Faceplate

Figure 2 – Rack shelf mount

Figure 3 – Example of a typical IN3254 application

Autres manuels pour IN3254

Table des matières

Autres manuels Extron electronics Amplificateur

Extron electronics

Extron electronics MPA 401-100V Manuel utilisateur

Extron electronics

Extron electronics XPA Ultra Series Manuel utilisateur

Extron electronics

Extron electronics HDXP 1616 Manuel utilisateur

Extron electronics

Extron electronics TP T BNC DA4 Manuel utilisateur

Extron electronics

Extron electronics XPA 1002 Manuel utilisateur

Extron electronics

Extron electronics VersaTools MTP DA4 Manuel utilisateur

Extron electronics

Extron electronics XTRA FULL RACK XPA 2002 Manuel utilisateur

Extron electronics

Extron electronics HDMI DA2 Manuel utilisateur

Extron electronics

Extron electronics DTP HD DA 4K Series Manuel utilisateur

Extron electronics

Extron electronics FOX DA8 Manuel utilisateur

Extron electronics

Extron electronics D/2 DA4 DVI Manuel utilisateur

Extron electronics

Extron electronics DA 6V EQ Manuel utilisateur

Extron electronics

Extron electronics DA2 RGBHV Manuel utilisateur

Extron electronics

Extron electronics ADA 6 Component Manuel utilisateur

Extron electronics

Extron electronics XPA Ultra Fx Series Manuel utilisateur

Extron electronics

Extron electronics MPA 152 MD Manuel utilisateur

Extron electronics

Extron electronics XTRA Series Manuel utilisateur

Extron electronics

Extron electronics DVI DA Plus Series Manuel utilisateur

Extron electronics

Extron electronics NetPA U 8001 SUB Manuel utilisateur

Extron electronics

Extron electronics FOX DA8 Plus Manuel utilisateur

Extron electronics

Extron electronics DVI DA Plus Series Manuel utilisateur

Extron electronics

Extron electronics P/2 DA2 Plus Manuel utilisateur

Extron electronics

Extron electronics Fiber Optics Fox 4G DA8 Manuel utilisateur

Extron electronics

Extron electronics HDMI DA2 Manuel utilisateur

Manuels Amplificateur populaires d'autres marques

ASTRO

ASTRO HVO V40 P Manuel utilisateur

Marantz

Marantz SUPERSCOPE BLA-545 Instructions de montage

NAD

NAD CI980 Manuel utilisateur

Technics

Technics SE-CH770 Manuel utilisateur

Harman Kardon

Harman Kardon HK6300 Manuel utilisateur

NAD

NAD T975 Manuel utilisateur

McIntosh

McIntosh MA6850 Manuel utilisateur

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manuel utilisateur

Viatron

Viatron Autrix Manuel utilisateur

GME

GME GA9800 Manuel utilisateur

Atlas

Atlas CP700 Manuel utilisateur

Roland

Roland KC-1000 Manuel utilisateur

Pyle

Pyle PFMRA350BW Manuel utilisateur

Advantage

Advantage S-250 Manuel utilisateur

IRT Electronics

IRT Electronics DVA-3007 Manuel utilisateur

Dimavery

Dimavery BA-100 Series Manuel utilisateur

Sony

Sony XM-S400D Manuel utilisateur

Schertler

Schertler ROY X Manuel utilisateur