6
Using your Ewbank®Floor Scrubb r &
Polish r with Vac on various floor typ s
DO NOT USE ON CARPET
Take care not to slip over when polishing floors,
they can become very slippy in the process.
Only use dedicated floor products; other
inappropriate polishes and waxes may leave
the floor dangerously slippy.
Cl aning hard floors with h avy soiling
• Use the brush heads with the vacuum
function (switch to position II), to pick up the
dry dust and loosen dried on dirt.
• Take care not to scratch the floor if hard dirt
gets stuck to the brush heads.
Spr ading floor tr atm nts
• Always read and follow manufacturer’s
instructions for floor treatment products.
• Apply the treatment directly to the floor unless
instructions indicate otherwise.
The recommended polish is Ewbank Gloss
Floor Polish (FP555) of which a sample is
supplied and available from Ewbank stockists.
Polishing wax on hard floors
• Once the wax polish has dried on the floor
use the blue buffing pads to polish.
• Switch to position I, keep the polishing head
moving, don’t stop in one place for a long time
or it will spoil the finish.
• Move at a speed of about 1 minute every 1m2
and follow the diagram for an even finish
(Fig.8).
• A glossy finish is not always possible; this
depends on the wax or polish used and the
type of floor. Sometimes several coats of
polish will help to get a glossy finish.
(approx. 1minute per square metre)
Fig.8
Switch to position II
Switch to position I
R moving old polish
• Read and follow carefully the instructions for
your chosen floor polish remover.
• Use the white pads to scrub old polish from
the floor.
