8 WT.050.455.000.DE.IM.0319
Safety GMS plus
2.
2.2 General safety instructions
Evoqua Water Technologies GmbH places great emphasis on
safety when working on or with the unit. Safety is our guiding
principle right from the design phase; the system is therefore
equipped with safety features.
Safety instructions The safety instructions in this documentation must be observed
unconditionally at all times. Additional industry-wide or in-house
safety regulations also continue to apply.
Safety notes printed
on the unit
All safety instructions attached to the unit itself must be observed.
These instructions must always be clearly legible and complete.
State-of-the-art technology The unit has been constructed in accordance with state-of-the-art
technology and the accepted safety regulations. However, if the
unit is used by persons who have not been adequately instructed,
risks to life and limb of such persons or third parties and damage
to the unit itself or to other property cannot be ruled out. Work not
specifically described in this instruction manual may only be
performed by authorized personnel.
Personnel The operator of the overall system must ensure that only
authorized and qualified specialists are permitted to work with and
on the unit within their defined scope of authority. "Authorised and
specialised personnel" refers to trained technicians of the
operator, of Evoqua Water Technologies GmbH and, if applicable,
of the service partner. All work on electrical components must be
performed by qualified electricians only.
Spare parts / components Trouble-free operation of the unit is only guaranteed if original
spare parts and components are used in precisely the combination
described in this instruction manual. Failure to observe this
instruction may incur the risk of malfunction or damage to the unit.
Extensions and conversions Never attempt to perform any modifications, extensions or
conversions on the unit that could have an adverse affect on safety
without the written approval of the manufacturer.
Electrical power During normal operation, the housing must remain closed.
Prior to installation, inspection, maintenance and repair work,
always switch the unit off by the main switch on the outside of the
unit and secure against reactivation.
Connect all cables in accordance with the wiring diagram.
Disposal Ensure that auxiliary materials and replaced parts are disposed of
in a manner that is safe and environmentally benign.
