8
Playback on your computer
Power off the camcorder! Screw the rear cap , connect with your computer via
USB cable from the USB port ,then turn on the device! The driver would be
automatically installed. Or you can take out the MicroSD card and use your own card
reader to connect with your computer too.
On a MAC
Simply plug the camcorder into your MAC with the included USB cable, turn your
camcorder on, and the MAC OS will recognize the camcorder as an external hard
drive.
IMPORTANT TIP FOR MAC USERS
When deleting files from your MicroSD cards you must empty the trash before
removing it or unplugging the camcorder. If you do not empty your trash the photos
and videos files will not be completely erased from your cards.
The device must be power on while connecting with computer for data
download. Don’t remove the battery!
When you remove the battery while the video is playing, damage to
your video data could occur!
Take Snapshot Photos
Screw out the rear cap , switch to left for photo standby mode, close the cap.
Turn on camcorder by pressing POWER/Shutter button for 3 seconds. The blue led
will be on, then comes to standby mode. Press the shutter button to start taking
photos (red led will blink). Press the shooter button again to stop. In this mode
the camcorder will take sequential photos every 3 seconds until the battery die or the
Micro SD card is full.
Take a Video
To confirm the camcorder is in video mode, screw out the rear cap , and the
video/photo switch “ ” must be to right for video recording standby mode. Turn on
the camcorder and the Blue LED on! Then press the Power/Shutter button quick
once again to start video recording. Red LED light will blink while video is recording.
Please the same button to stop recording!
