18. Make sure that all of the exposed bolts and screws are tightened.
19. Raise the kickstand to its upright position.
20. Make sure the engine is running.
21. Put one foot on the deck of the EVO Powerboard. While pushing off with
the other foot, gently depress the GAS LEVER, on the right side of the
handlebars. The EVO Powerboard will begin to move on its own power.
22. Control your speed by pressing and releasing the accelerator lever. The harder
you squeeze, the faster you will go.
Braking
23. To brake, release the GAS LEVER and gently press the BRAKE LEVER.
G.FOLDING AND STORAGE
When you are done riding the EVO Powerboard you can fold it down
for compact storage, carrying and transportation. To fold down the
EVO Powerboard, use one hand to push down on the folding handle
while gently pushing down on the handlebars.
BE CAREFUL NOT TO HIT YOUR HEAD WITH THE HANDLEBARS!
Push down until you feel the mechanism lock into down position.
•NOTE: If the lever is pulled aggressively, the locking spring may become
stretched and then the steering will not lock into position, it is also advisable
to ensure the evo powerboard locks firmly, prior to riding.
You can now carry the EVO Powerboard by the handlebar tube.
H.OPERATING PROCEDURES
FUEL
WARNING!
• This is a 2-stroke engine. Only run the engine on fuel, which is properly mixed
with 2-cycle engine oil.
• Provide good ventilation when fuelling or handling fuel.
• Always use gas with a minimum octane number of 93 unleaded.
• Use EVO/Active 2-stroke oil only (for Warranty Purposes).
Mix 40:1 (Non-Synthetic oil) or 60:1 (Synthetic oil) (or 3%), gas:oil mixture.
Refer to Fuel Mixture Table on page 8.
• Never use multi-grade (1 OW/30) or waste oil.
• Always mix fuel and oil in a separate clean, gas safe container. Always start by
adding half the amount of fuel, which is to be used. Then add the whole amount
of 2-cycle oil. Mix (shake) the fuel container. Add the remaining amount of fuel.
Mix (shake) the fuel and oil thoroughly before filling the fuel tank.
7
www.evopowerboards.com
G. FOLDING AND STORAGE
H. OPERATING PROCEDURES
