STEP 1: Tool Checklist
Essential tools: Needed to build and use the kit:
1. Small screwdriver(s)
There are several places in the assembly process where you
will need to provide a small Phillips head or flat head
screwdriver. You may find it helpful to have a couple of
different sizes handy.
3. Electrical power
And if you’re so inclined...
2. Computer, Internet access,
USB port....
To use the EggBot, you’ll need a reasonably
recent vintage computer (Mac, Windows, or
Linux) with an available USB port as well as
internet access to download software.
All of the software that you’ll need will always
be available for free.
Visit http://wiki.evilmadscientist.com/EggBot
to get started.
Wire strippers, soldering iron, etc.
Rather than using cable ties, you may want to reduce the length of
the wires on the stepper motors. If you’d like to trim, strip, and tin
the wires, you’re certainly welcome to do so.
The EggBot kit comes with a regulated universal-input
power supply that accepts worldwide voltages and puts
out 9 V DC at up to at least 1 A. (International users
may need to supply a plug adapter to fit the prongs into
local outlets.)
If you’re using your own external power, make sure that it provides
9 to 18 V DC, has a center-positive plug and is rated for at least
1000 mA. (A 12V car battery with the right connector can do the
job, for example.) Please be careful: Inappropriate voltage or
polarity can cause permanent damage.
Suggested tools: Recommended; not required
1. Small cable ties
The wires on the stepper motors are long. There are mounting
holes provided in case you want to tie them up with a couple
of small cable ties.
OK, Let’s get started! >>>
2. Containers to hold small parts
Small bowls, an egg carton, or an array of paper cups may be helpful
for organizing small parts while you put the EggBot together.
[Ostrich EggBot Kit Assembly Guide]
