
4) For under cabinet installation, measure the position of your existing under cabinet hole and compare it with
your range hood exhaustion hole. If they do not match, you need to alter your under cabinet exhaustion hole
position to match your range hood exhaustion hole position.
5) Mark the position of the screw holes on top of range hood, which need to be drilled or screwed on in order to
mount the range hood.
6) Remove grease filter panels from the bottom of the range hood.
7) Position the range hood against to cooking stove wall. WARNING: when lifting, hanging or positioning the
range hood, please DO NOT TOUCH the fan wind wheels or motors with your hands or tools. More
importantly, please DO NOT squeeze, bump or grab the fan wind wheels. This may cause the fan wind
wheels become unbalanced, resulting abnormal noise or malfunction when turning on range hood.
8) For best results, the mounting height, distance from bottom of range hood to top surface of range / stove
should be 65cm to 75cm (25 inch to 30 inch).
9) Connect wires of the range hood with your at-home electric wires. Or connect the range hood plug into the
range hood outlet at-home.
10) For wall mounted installation: according to marks, drill two holes appropriate for heavy duty wall anchors
and screws (not included). Mount the range hood onto the wall with the two screws and anchors, and tighten.
For under cabinet installation, drill 4 holes on the bottom of cabinet with four iron expansion fixed on the
cabinet board, OR use heavy duty screws to mount range hood onto the cabinet board.
11) IMPORTANT: Range hood mounting must be fully leveled. If the cabinet itself is not leveled, you need to
adjust it to a perfect level point before hanging the range hood. If cabinet cannot be leveled further, please
fine-tune the level of range hood by adjusting the screws up or down. If range hood is unevenly installed or
leveled, it may cause abnormal noise and damage to the machine.
12) Use heavy duty tape (Metal tape that can endure heat and grease is recommended) to seal your at-home
exhaustion pipe with exhaustion hole of range hood. Make sure no air leaks through the gaps of tape.
13) For wall mounted installation only: Affix the decorative cover with two M4 tapping screws on the hood body.